FM DISTRIBUTION FOR MOTORWAYS AND TUNNELS

FM DISTRIBUTION FOR MOTORWAYS AND TUNNELS

ADVANTAGES IF COMPARED TO A TRADITIONAL SYSTEM As compared to the traditional analog systems, our innovative solution for FM transmission allows considerable cost reductions in terms of equipment, system complexity and management costs, at the same time providing a high-efficiency infrastructure and an easy scalability of the whole network (see diagram). Head station: one single station can manage the whole network. Transmission stations: extremely compact and modular (as many as needed in the network)

EMERGENCY ALERTS BROADCAST Beside transmitting FM channels along motorways and inside tunnels, the system can also send alert signals on any radio frequency (either a recorded message or a live one) if needed. The alert signal can be transmitted either on selected channels or on the whole FM frequency range at the same time. In case of use in a multi-frequency network, thanks to the RDS coder embedded in every transmitter and the automatic AF (alternate frequency) signalling feature, the car radio switches automatically between frequencies, offering a superior audio quality and lower infrastructure costs as compared to SFN distribution. Every RDS remote station coder is individually addressable by the head station, allowing to send specific messages for every single motorway section if needed. Every on-site transmitter can also broadcast one or more recorded alert messages when enabled via a local sensor detecting a specific situation. One head-station rack system Different on-site FM stations (according to need)

MULTI AND SINGLE FREQUENCY DISTRIBUTION SYSTEM The head station manages the whole network from a single place. All the information is sent to the on-site stations using a single data stream containing both the management data and the audio channels to be broadcast. This simplifies the on-site equipment drastically, at the same time offering more flexibility and simplicity of use as compared to the currently used heterogeneous distribution networks. Multi Frequency Network Thanks to the embedded RDS coder and the alternate-frequency autoswitch feature of the receiver, very long motorway sections can be easily covered in a cost-effective way (no GPS or clock recovery hardware needed). Freq.2 Freq.2 Freq.2 Single Frequency Network Thanks to our unique synchronous MPEG decoder, long motorway sections can be covered using a single frequency carrier even though the transport signal is based on a compressed MPEG stream GPS receiver and clock recovery (hardware is embedded in the station).

SIGNAL DISTRIBUTION OPTIONS Tunnel distribution base station Head-station rack system Fibre-optic fed base station DVB-S fed base station

MAIN FEATURES FREQUENCY POWER Operating frequency range FM 87.5 to 108MHz Frequency Setting 1Hz steps Generation Direct to channel Management USB Interface, optional LAN interface Nominal deviation ±75KHz Pre emphasis settings Flat, 75 or 50us Operation mode Mono or stereo Harmonics suppression < -75dBc S/N ratio (weighted) > 80 db THD < 0,5% Crosstalk 55dB Nominal POWER 5 to 25 W depending on options RJ45 feed through waterproof connector for data stream and control EXTERNAL CONNECTIONS INPUT DC input 24V waterproof connector OUTPUT SUPPLY (25W model) DIMENSIONS ENVIRONMENTAL DATA RF OUTPUT N type connector 50 Ohm Multi-carrier transmission OTHER OPTIONS STANDARD COMPLIANCE BNC type connector 75Ohm for coaxial ASI/SPDIF/AES/EBU input LAN remote control input module Radio spectrum ETSI 300-384; ETS 302-018 EMC ETSI 447; ETS 301-489 Safety EN 60950 - EN 60215 Power consumption outdoor unit 90W @24V external power supply Outdoor unit (ODU module) 240 x 310 x 160 mm (9kg) for 25W Operating range 0 to 60 C Storage range -10 to 75 C