SDG5000 Series DataSheet V1.2 Data Sheet Function/Arbitrary Waveform Generator SDG5000 Series DDS technology, dual-channel output, 500MSa/s sample rate, 14bit vertical resolution. The 2ppm high-frequency stability, -116dBc/Hz low phase noise(ssb) signal output Has the outstanding signal fidelity,512k waveform length,can output complicated signals,can display signals user define more accurately, Adopt unipue EasyPulse technology,can output the pulse signal which is low jitter and very small duty cycle,the edge and pulse width can adjust a wide rang and fine Complete set of modulation functions: AM, DSB-AM,FM, PM, FSK, ASK, PWM, linear/logarithmic sweep and burst Built-in accurate frequency counter enables to measure ranges 100mHz-200MHz (single channel) Standard interfaces: USB Device, USB Host The TFT graphics of big screen, higher-resolution and high brightness,support the intuitionistic operations and setting parameters Supplied with powerful arbitrary editing software,remote control support. Signal fidelity SDG5000 series Function/Arbitrary Wavefo m Generator has high stability time base a nd 512kpts arbitrary waveforms storage len gth,can output more complicated and more accurate arbitrary,user can get more fedelit y signal by the Function/Arbitrary Wavefom Generator. 1 Edit arbitrary waveform Enables edition of 14-bit,512kpts /16kpts arbitrary output waveforms, Arbitrary editing software EasyWave provides 9 standard waveforms: Sine, Square, Ramp, Pulse, ExRise, ExpFall, Sinc, Noise and DC, which meets all engineers basic needs; In addition, it provides plenty of ways of manual drawing, point-to-point line drawing and arbitrary point drawing. It facilitates to create complex waveforms; Multi-file screen management helps users to edit multiple-waveform simultaneously. It provides 10 Storage in non-volatile RAM. Outstanding Performance SDG5000 series Function/Arbitrary Waveform Generator is a new family member of SIGLENT with friendly design: 4.3 inch TFT-LCD display; Built-in Chinese/English language; Online help function; Support USB and internal storage, facilitate files management; Special connection terminal for grounding.
V1.2 SDG5000 Series DataSheet Specification Model SDG5162 SDG5122 SDG5082 Max. output frequency 160MHz 120MHz 80MHz Output channels 2 Sample rate 500 MSa/s Arbitrary waveform CH1:16 kpts CH2:512 kpts length Frequency resolution 1 μhz vertical resolution 14 bit Waveform Sine, Square, Ramp, Pulse, Gaussian Noise, DC, Built-in arbitrary waveforms Modulation AM DSB-AM FM PM FSK ASK PWM Sweep Burst Frequency counter Frequency range:100mhz~200mhz Standard interface USB Host & Device Dimension Width Heigth Depth=261mm 105mm 344mm Attention: All these specifications apply to the SDG5000 Series Function/Arbitrary Waveform Generator unless otherwise explanation. To satisfy these specifications, the following conditions must be met first: 1. The instrument has been operating continuously for more than 30 minutes within specified operating temperature range (18ºC~28 C ). 2. The temperature variation does not exceed 5. 3. Unless otherwise stated,all specifications apply with a 50Ω resistive load and auto range ON. Note: all specifications are guaranteed unless where noted typical. Typical:The characteristic performance,which 80% or more of manufactured instruments will meet,this data is not warranted,does not include measurement uncertainty,and is vaild only at room temperature(approximately 23 C) 2
SDG5000 Series DataSheet V1.2 Frequency Specification Model SDG5162 SDG5122 SDG5082 Waveform Sine, Square, Ramp, Triangle, Pulse, Noise, Arb Sine 1μHz ~ 160MHz 1μHz ~ 120MHz 1μHz ~ 80MHz Square 1μHz ~ 50MHz 1μHz ~ 40MHz 1μHz ~ 30MHz Pulse 1μHz ~ 40MHz 1μHz ~ 30MHz 1μHz ~ 20MHz Ramp/Triangular 1μHz ~ 4MHz 1μHz ~3MHz 1μHz ~ 2MHz Gaussian white noise 100MHz(-3dB) 100MHz(-3dB) 100MHz(-3dB) Arbitrary 1μHz ~ 40MHz 1μHz ~ 30MHz 1μHz ~ 20MHz Resolution 1 μhz 1 μhz 1 μhz Temperature coefficient 1 year,18 C ~ 28 C,±1ppm Temperature Coefficient ±1ppm,0 ~55 Sine Spectrum Purity Harmonic Distortion Total harmonic waveform distortion Spurious signal (non-harmonic) Phase noise Square Specification DC ~ 1 MHz <-56dBc 1 MHz ~ 10 MHz <-46 dbc 10 MHz ~ 100 MHz <-35 dbc 100 MHz ~ 160 MHz <-26 dbc DC ~ 20kHz,1Vpp<0.2% DC ~ 160MHz : <-70dBc+20dB/spectrum phase 100kHz Offset, 116dBc/Hz(typical) Rise/fall time 6 ns(10% ~ 90%) Overshoot < 3% 10 MHz 20% ~ 80% Duty 10 MHz- 40MHz 40% ~ 60% Cycle 40 MHz-50MHz 50% Asymmetric (50% Duty Cycle) 1% of period+5ns(typical,1khz,1vpp) Jitter(cycle-to-cycle) DC ~ 1MHz, 200ps+2ppm 1MHz ~ 50MHz, 500ps Ramp/Triangle Specification Linearity <0.1% of Peak value output (typical,1khz,1vpp,100% symmetry) Symmetry 0% ~ 100% 3
V1.2 SDG5000 Series DataSheet Pulse Specification Period 1000000s,Max. 25ns, Min. Pulse width 12ns,100ps resolution duty 0.0001% ~ 99.9999% Rise/Fall time (10% ~ 90%) 6ns ~ 6s,100ps resolution Overshoot < 3% Jitter(cycle to cycle) DC ~ 1MHz, 200ps+2ppm 1MHz ~ 50MHz, 500ps Arbitrary Specification Output CH1 CH2 Waveform length 16Kpts 16Kpts /512Kpts Vertical resolution 14 bits 14 bits Sample rate 500 MSa/s 500 MSa/s Min. Rise/Fall time 6 ns 6 ns Jitter(cycle to cycle) DC ~ 40MHz, 2.1ns±10ppm Storage in Non-volatle RAM memory 8 waveforms @ 512Kpts;24 waveform @16Kpts Output Specification Output CH1 CH2 Amplitude 50Ω: DC ~ < 40MHz: 1mVpp-10Vpp(50Ω) 40MHz ~ <100MHz: 1 mvpp ~ 5 Vpp 100MHz ~ 160MHz: 1 mvpp ~1.5 Vpp Hi_Z: DC ~ < 40MHz: 1mVpp~20Vpp 40MHz ~ <100MHz: 1 mvpp ~ 10 Vpp 100MHz ~ 160MHz: 1 mvpp ~3 Vpp 50Ω: DC ~ < 40MHz: 1mVpp-10Vpp(50Ω) 40MHz ~ <100MHz: 1 mvpp ~ 5 Vpp 100MHz ~ 160MHz: 1 mvpp ~1.5 Vpp Hi_Z: DC ~ < 40MHz: 1mVpp~20Vpp 40MHz ~ <100MHz: 1 mvpp ~ 10 Vpp 100MHz ~ 160MHz: 1 mvpp ~3 Vpp Vertical accuracy 1,2 (spec) ±1% of setting ±1mVpp at 10KHz ±1% of setting ±1mVpp at 10KHz Amplitude flatness 80MHz ±0.2 db 80MHz ±0.2 db (100 khz sine,5vpp) 160MHz ±0.8dB 160MHz ±0.8 db Output Current Max only ±200mA ±200mA Cross talk <-60dB Output BNC 1. Add 1/10th of the output amplitude and offset accuracy specification per for operation at temperatures beyond 23 ±5 2. Auto range ON 4
SDG5000 Series DataSheet V1.2 DC Offset Specification Output CH1 CH2 Range(DC) ±5V(50Ω) ±5V(50Ω) ±10V(high impedance) ±10V(high impedance) Offset accuracy ±( setting offset ±( setting offset value *1%+1mV) value *1%+1mV) Resolution 1mV 1mV Waveform Output Impedance Protection Isolation AM / DSB-AM Modulation(CH1/CH2) 50Ω(typical),Hz short-circuit protection shells for channel output(s),sync,and Mod In are connected together but isolated from the instrument s chassis,maximum allowable voltage on isolated connector shells is ±42Vpk Modulation waveform Sine, Square, Ramp, Noise, Arbitrary Modulation depth 0%~120% Modulation Frequency 1mHz-50kHz FM Modulation(CH1/CH2) Modulation waveform Modulation Frequency PM Modulation(CH1/CH2) Modulation waveform Phase Deviation Modulation Frequency Sine, Square, Ramp, Noise, Arbitrary 1mHz-50kHz Sine, Square, Ramp, Noise, Arbitrary 0~360,0.1 Resolution 1mHz-50kHz 5
V1.2 SDG5000 Series DataSheet FSK Modulation(CH1/CH2) Modulation waveform 50% duty-cycle square waveform Modulation Frequency 1mHz-1MHz ASK Modulation(CH1/CH2) Modulation waveform 50% duty-cycle square waveform Modulation Frequency 1mHz-1MHz PWM Modulation(CH1/CH2) Pulse Modulation waveform Modulation Frequency 1mHz-50kHz Sweep(CH1/CH2) Type linear/logarithmic Direct Up/down Sweep time 1 ms ~ 500 s ± 0.1% Trigger source Manual, external, internal Sweep Range@Max Sample Rate 1uHz to Bandwidth frequency @ 500 MSa/s Burst(CH1/CH2) Waveform Sine, Square, Ramp, Pulse, Arbitrary(except DC) Frequency 2mHz~100MHz Type Count(1 ~ 1,000,000 periods),infinite, Gated Start/Stop phrase 0 ~360 Internal period 1 μs ~ 1000 s ± 1% Trigger delay 280ns~34s Gated source External trigger Trigger source Manual, External or Internal 6
SDG5000 Series DataSheet V1.2 External modulation Rear-panel BNC,isolated from chassis Voltage level ±(4.5~5)V= 100% modulation >10kΩ input impedance Note: The external input voltage can t be over ±5Vpk, otherwise instrument gets damaged. Trigger Input Rear-panel BNC,chassis-referenced Voltage Level CMOS compatible Slope Up or down (optional) Pulse width > 50 ns Input impedance > 5kΩ,DC coupling Reaction time 380ns(typical) Tigger Input period of external burst >160ns Input Latency CH1-366±30nS CH2-386±30nS Trigger Output Voltage level Pulse width Output impedance Max Frequency Output SYNC Output Voltage level Pulse width Output impedance Max Frequency Frequency reference input Rear-panel BNC,chassis-referenced CMOS compatible > 60 ns(typical) 50Ω(typical) 1 MHz Through Rear Panel :Ext Trig/Gate/FSK/Burst Rear-panel BNC,isolated from chassis VOH(min)>4.5V,VOL(max)<0.5V;( IOL/IOH=8mA) > 50 ns(typical) 50Ω(typical) 10MHz Rear-panel BNC,isolated from chassis and all connector. Frequency range 10MHz±1kHz Min Voltage level 2.3V Frequency reference output Frequency Voltage level Output impedance Rear-panel BNC,chassis-referenced 10MHz >1Vpp 50Ω AC-coupled 7
V1.2 SDG5000 Series DataSheet Frequency Counter Measurement Frequency, Period, Positive/negative pulse width, duty cycle Frequency range Single Channel:100mHz~200MHz Frequency resolution 6bit/s Voltage range (non-modulated signal) DC offset range ±1.5VDC Manual DC coupling 100mHz~100MHz 50mVrms~±2.5V 100MHz~200MHz 100mVrms~±2.5V AC coupling 1Hz~200MHz 100mVrms~5Vpp Pulse width and duty-cycle measurement 1Hz~10MHz(50mVrms~5Vpp) Input impedance 1MΩ Input adjustment Coupling mode AC,DC High-frequency rejection ON/OFF Trigger level range -3V~ 1.8V 8
SDG5000 Series DataSheet V1.2 General Specification Display Display type Resolution Color depth Contrast Ratio Luminance Power Voltage Consumption Fuse Environment Temperature Humidity range Altitude Electromagnetic Compatibility Safety Others Dimension Weight IP protection IP2X Calibration Cycle 1year 4.3inch TFT-LCD 480 272, (RGB) 24bit 500:1(typical) 300cd/m 2 (typical) 100-240 Vrms(±10%),50/60 Hz 100-120 Vrms(±10%),400 Hz MAX 50W 1.25A,250V Operation:0 C~40 C Storage:-20 C~60 C Below +35 : 90% relative humidity +30 ~+40 : 60% relative humidity Operation: below 3,048 meters Storage: below 15,000 meters 2004/108/EC Directive Applicable standards EN 61326-1:2006 EN 61000-3-2:2006 + A2:2009 EN 61000-3-3:2008 2006/95/EC Low Voltage Directive EN 61010-1:2010 Width:261mm Height:105mm Depth:344mm N.W: 2.8kg 9
V1.2 SDG5000 Series DataSheet Purchase Information Product Name SIGLENT SDG5000 Function/Arbitrary Waveform Generator Models: SDG5162 SDG5122 SDG5082 160MHz 120MHz 80MHz Standard Accessories A Quick Start A Certification A Guaranty Card An CD(including EasyWave2.0 computer software system) A Power Cord that fits the standard of destination country A USB Cable Optional Accessories BNC cable GPIB-USB Adapter Contact SIGLENT SHENZHEN SIGLENT TECHNOLOYIES CO., LTD Address: 3/F, No.4 BULIDING, 3 rd LIUXIAN Rd, ANTONGDA INDUSTRY GARDEN, BAO AN DISTRICT, SHENZHEN, 51851, CHINA Tel: +86-755-36615186 Fax: +86-755-33591582 Post Code: 518101 E-mail:sales@siglent.com http://www.siglent.com 10