1W-H3-05 (K)* M12 RFID reader 125 khz Unique Product Card * Letter K refers to a reader with a common cathode.
Before use Please do not open the reader and do not make any changes. This results in loss of warranty. In case of any questions please contact with us. We certainly answer to all questions and solve possible problems. Please carefully read the following information before connecting the reader. Please keep in mind, that there are factors as metal surfaces, which can affect on radio communication and correct reader operation. It is advisable to consult the mounting conditions before use with our staff. Please contact with us before sending damaged products. We offer possibility to change cable length and terminate it with a plug. Before make an order please contact with us to determine the details.
General information The RFID reader 1W-H3-05 (K) M12 reads identification data wireless of passive transponders (cards, tags, etc.) compatible with UNIQUE standard. The built-in two-color LED for any use. LEDs are powered by internal voltage regulator via built-in resistor. The light is on when the appropriate LED is connected to the minus of power supply. Grey power supply (-) Yellow power supply (+) Green green LED cathode (anode for K version) Brown red LED cathode (anode for K version) White 1-Wire The reader should be connected according to the scheme "A". In case of necessity of simultaneous control of LED and other devices (e.g. Buzzer) connect the reader according to the scheme "B": SCHEME A SCHEME B
For product with common cathode: LED connected in series with a resistor 330R has a cathode connected to the negative power supply. LED is activated when is connected to plus of power supply. To connect more than 5V, it is advised to use external resistor to avoid exceeding the maximum LED current. Minimum value of resistor can be calculated from the formula: where: Rx = (Us 1.6V) Id - 330Ω Rx External resistor Us Power supply voltage of LED Id LED current (max. 10mA) Connect the reader according to the scheme C : SCHEME C
DS1990A emulation After successful parity bits check, collected data (manufacturer code and serial number) are sent via 1-Wire interface, emulating the MAXIM DS1990A Checksum Constant value Manufacturer code Serial number code DS1990A CRC 0x00 1 byte 4 bytes 0x01 MSB LSB 1. The reader is waiting for the proximity of the token (card) trying to read it at a frequency of about 6 times per second. (~ 50 ms [checking the presence of the card] + ~ 100 ms [gap between successive checks]). 2. After the token is approached, its identifier is read (~ 120 ms) and it is stored for a period of ~ 500 ms during which it is possible to emulate the read number as the MAXIM ibutton DS1990A. 3. If during this ~ 500 ms on the 1-wire bus no RESET pulse initiating the transmission appears, the identifier is forgotten and the reading is repeated. Otherwise, the time of remember the identifier will be extended for another 500 ms from the moment of the RESET pulse.
External dimensions
Technical Data Power supply Nominal power supply voltage Power supply efficiency Peak current Receiver current Green LED current Red LED current Frequency Type of transponder 6,5-30 V DC 12 V DC 1 A 50 ma 12 ma (without LED) 10 ma (for K version do not exceed 15 ma) 10 ma (for K version do not exceed 15 ma) 125 khz Manchester, 64 cycles per bit Surface of the antenna 6,8 cm 2 Reading range Reading frequency Supported 1-Wire commands Mounting method Cable length Reader temperature ROHS ~4cm 6/s for identification 2/s when transponder is in range of the reader 0x33 (0x0F) - Read ROM 0xF0 - Search ROM M12 Thread 0,4 m -20 o C +55 o C YES