The GigaTech Products SFP-10G-AOCxM-GT is programmed to be fully compatible and functional with all intended Cisco switching devices. These active optical cables are designed to meet the SFP+ 10Gbs SFF-8431 specification. These cables use multimode fiber carrying an 850nm nominal wavelength. The active optical SFP+ cable is a light weight small diameter option for distances up to 100 meters. Features Up to 11.3 GBd bi-directional data links Hot-pluggable SFP+ footprint Up to 100 meters 3mm fiber cable diameter Less than 1W power consumption Operating temperature range: 0 to 70 Compliance MSA SFF-8431, SFF 8432 10G FC RoHS Compliant Applications 10GBASE Ethernet Infiniband DDR, SDR 8GB Fiber Channel Warranty: GigaTech Branded Cables- Lifetime Warranty
Part Numbers SFP-10G-AOCxM-GT Part Number Distance Description SFP-10G-AOC1M-GT 1M 10GBASE-AOC SFP+ Cable Cisco Compatible- 1M SFP-10G-AOC2M-GT 2M 10GBASE-AOC SFP+ Cable Cisco Compatible- 2M SFP-10G-AOC3M-GT 3M 10GBASE-AOC SFP+ Cable Cisco Compatible- 3M SFP-10G-AOC5M-GT 5M 10GBASE-AOC SFP+ Cable Cisco Compatible- 5M SFP-10G-AOC7M-GT 7M 10GBASE-AOC SFP+ Cable Cisco Compatible- 7M SFP-10G-AOC10M-GT 10M 10GBASE-AOC SFP+ Cable Cisco Compatible- 10M SFP-10G-AOC15M-GT 15M 10GBASE-AOC SFP+ Cable Cisco Compatible- 15M SFP-10G-AOC20M-GT 20M 10GBASE-AOC SFP+ Cable Cisco Compatible- 20M SFP-10G-AOC25M-GT 25M 10GBASE-AOC SFP+ Cable Cisco Compatible- 25M SFP-10G-AOC30M-GT 30M 10GBASE-AOC SFP+ Cable Cisco Compatible- 30M SFP-10G-AOC50M-GT 50M 10GBASE-AOC SFP+ Cable Cisco Compatible- 50M SFP-10G-AOC75M-GT 75M 10GBASE-AOC SFP+ Cable Cisco Compatible- 75M SFP-10G-AOC100M-GT 100M 10GBASE-AOC SFP+ Cable Cisco Compatible- 100M General Specifications Bit Error Rate BER 10-12 Input Voltage VCC3 3.14 3.3 3.47 V Maximum Voltage VMAX -0.5 4 V Electric Power Interface Operating Temperature TOP 0 70 Case Temperature Storage Temperature TSTO -40 85 Ambient Temperature Link Distance Parameter Fiber Type Distance Range (m) 10GBd OM2 Up to 100 AOC Electrical Input Requirements Data Rate Per Channel DR 1 11.3 GB/s Non Condensing Differential Input Amplitude VIN_PP 180 700 mv Single Ended Voltage Tolerance V -0.3 4 V AC Common Mode Voltage VCM 15 mv Total Jitter TJ 0.28 UI Data Dependent Jitter DDJ 0.1 UI AOC Electrical Output Requirements Data Rate Per Channel DR 1 11.3 GB/s Non Condensing Differential Output Amplitude VOUT_PP 300 850 mv Differential Output Amplitude in VOUT_SQ 50 mv Squelched State Single Ended Voltage Tolerance V -0.3 4 V Output AC Common Mode Voltage VCM 7.5 mv RMS Output Transition Time TR, TF 30 ps 20% - 80% Total Jitter TJ 0.7 UI Deterministic Jitter DJ 0.42 UI
Block Diagram of Transceiver PCB Layout Recommendation
Dimensions ALL DIMENSIONS ARE ±0.2mm UNLESS OTHERWISE SPECIFIED UNIT: mm Electrical Pad Layout
Pin Assignment SFP-10G-AOCxM-GT PIN # Symbol Description Remarks 1 VEET Transmitter ground (common with receiver 2 TFAULT Transmitter Fault 3 TDIS Transmitter Disable. Laser output disable on high or open Circuit ground is isolated Disabled: TDIS>2V or open Enabled: TDIS<0.8V 4 SDA Data line for serial ID Should Be pulled up with 5 SCL Clock line for serial ID 6 MOD_ABS Module Absent. Ground within the module 7 RS0 No Connection required 8 LOS Loss of Signal indication. Logic 0 indicates normal operation 4.7k 10k ohm on host board to a voltage between 2V and 3.6V LOS is open collector output 9 RS1 +3.3V Power Supply Circuit ground is isolated 10 VEER Receiver ground (common with transmitter 11 VEER Receiver ground (common with transmitter 12 RD- Receiver Inverted DATA out. AC coupled 13 RD+ Receiver Non-inverted DATA out. AC coupled 14 VEER Receiver ground (common with transmitter Circuit ground is isolated 15 VCCR Receiver power supply 16 VCCT Transmitter power supply Same as Pin# 1 17 VEET Transmitter ground (common with receiver 18 TD+ Transmitter Non-inverted DATA out. AC coupled 19 TD- Transmitter Inverted DATA out. AC coupled 20 VEET Transmitter ground (common with receiver References 1. IEEE standard 802.3ae. IEEE Standard Department, 2005. 2. Enhanced 8.5 and 10 Gigabit Small Form Factor Pluggable Module SFP+ SFF-8431 Circuit ground is connected to chassis ground Circuit ground is connected to chassis ground