IP65 IP67 Ⅰ Ⅰ A D File Name:HVG150SPEC 180529
SPECIFICATION MODEL HVG150 HVG15015 HVG150 HVG15024 HVG15030 HVG15036 HVG15042 HVG15048 HVG15054 DC VOLTAGE V 15V V 24V 30V 36V 42V 48V 54V CONSTANT CURRENT REGION Note.4 7.2~V 8.25~15V 11~V 13.2~24V 16.5~30V 19.8~36V 23.1~42V 26.4~48V 29.7~54V RATED CURRENT RATED POWER 10A 1W 10A 150W 7.5A 150W 6.25A 150W 5A 150W 4.17A 150.W 3.58A 150.36W 3.13A 150.24W 2.78A 150.W RIPPLE & NOISE (max.) Note.2 150mVpp 150mVpp 150mVpp 150mVpp 0mVpp 0mVpp 0mVpp 0mVpp 0mVpp OUTPUT VOLTAGE ADJ. RANGE Adjustable for A/ABType only (via the builtin potentiometer) 10.8 ~ 13.5V 13.5 ~ 17V 17 ~ 22V 22 ~ 27V 27 ~ 33V 33 ~ V 38 ~ 46V 43 ~ 53V 49 ~ 58V CURRENT ADJ. RANGE Adjustable for A/ABType only (via the builtin potentiometer) 6 ~ 10A 5.5 ~ 10A 4.13 ~ 7.5A 3.44 ~ 6.25A 2.75 ~ 5A 2.29 ~ 4.17A 1.97 ~ 3.58A 1.72 ~ 3.13A 1.53 ~ 2.78A VOLTAGE TOLERANCE Note.3 ±2.5% ±2.0% ±1.0% ±1.0% ±1.0% ±1.0% ±1.0% ±1.0% ±1.0% LINE REGULATION LOAD REGULATION ±2.0% ±1.5% ±1.0% SETUP, RISE TIME Note.6 500ms, ms /230VAC, 347VAC, 4VAC HOLD UP TIME (Typ.) VOLTAGE RANGE Note.5 18ms/347VAC, 4VAC 1 ~ 528VAC 254VDC ~ 747VDC (Please refer to "STATIC CHARACTERISTIC" section) FREQUENCY RANGE POWER FACTOR (Typ.) 47 ~ 63Hz PF 0.98/230VAC, PF 0.97/277VAC, PF 0.95/347VAC, PF 0.93/4VAC @full load (Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section) TOTAL HARMONIC DISTORTION THD< %(@ load 50%/230VAC, 277VAC, 347VAC [@ load % only for V model]; @ load 75%/4VAC) (Please refer to TOTAL HARMONIC DISTORTION (THD) section) INPUT EFFICIENCY (Typ.) 87% 89% 90.5% 91% 91% 91% 91% 91.5% 91.5% AC CURRENT (Typ.) 347VAC 4VAC 0.45A 0.35A 0.5A 0.38A INRUSH CURRENT (Typ.) MAX. No. of PSUs on 16A CIRCUIT BREAKER COLD START 35A(t width=790 μs measured at 50% I peak) at 4VAC; Per NEMA 410 4 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 4VAC LEAKAGE CURRENT <0.75mA / 4VAC OVER CURRENT 95 ~ 108% Constant current limiting, recovers automatically after fault condition is removed SHORT CIRCUIT Constant current limiting, recovers automatically after fault condition is removed PROTECTION 14.4 ~ 16.8V 18 ~ 21V 23 ~ 27V 28 ~ 34V 34 ~ 38V 41 ~ 46V OVER VOLTAGE Shut down o/p voltage with autorecovery or repower on to recovery 47 ~ 53V 54 ~ V 59 ~ 65V OVER TEMPERATURE Shut down o/p voltage, recovers automatically after temperature goes down WORKING TEMP. Tcase= ~ 85 ( ~ 75 for V model, ~ for 15V model)(please refer to "OUTPUT LOAD vs TEMPERATURE" section) MAX. CASE TEMP. Tcase=85 (75 for V model, for 15V model) ENVIRONMENT WORKING HUMIDITY ~ 95% RH noncondensing STORAGE TEMP., HUMIDITY ~, 10 ~ 95% RH TEMP. COEFFICIENT ± 0.03%/ (0 ~ ) VIBRATION 10 ~ 500Hz, 5G min./1cycle, period for 72min. each along X, Y, Z axes SAFETY & EMC OTHERS NOTE SAFETY STANDARDS WITHSTAND VOLTAGE ISOLATION RESISTANCE EMC EMISSION Note.7 UL8750(type HL ), CSA C22.2 No. 250.008, EAC TP TC 004, IP65 or IP67 approved I/PO/P:3.75KVAC I/PFG:2KVAC O/PFG:1.5KVAC I/PO/P, I/PFG, O/PFG:M Ohms / 500VDC / 25 / 70% RH Compliance to EN55015, EN32 Class C (@ load 55% load, @ load % only for V model ) ; EN33, FCC Part 15 Subpart,EAC TP TC 0 EMC IMMUNITY Compliance to EN42,3,4,5,6,8,11, EN61547, light industry level ( surge immunity LineEarth 4KV, LineLine 2KV ), EAC TP TC 0 MTBF 158.6K hrs min. MILHDBK217F (25 ) DIMENSION 245**mm (L*W*H) PACKING 1.24Kg; pcs/15.9kg/0.78cuft File Name:HVG150SPEC 180529
Block Diagram PFC fosc : 130KHz PWM fosc : 70KHz I/P FG EMI FILTER & RECTIFIERS PFC CIRCUIT PFC CONTROL O.L.P. O.T.P. POWER SWITCHING PWM & PFC CONTROL RECTIFIERS & FILTER O.L.P. DETECTION CIRCUIT O.V.P. V V DIM DIM (B Type) DRIVING METHODS OF LED MODULE This series is able to work in either Constant Current mode (a direct drive way) or Constant Voltage mode (usually through additional DC/DC driver) to drive the LEDs. In the constant current region, the highest voltage at the output of the driver depends on the configuration of the end systems. Vo(%) (A) Constant Voltage area (B) Constant Current region Should there be any compatibility issues, please contact MEAN WELL. 50 Io (%) Typical output current normalized by rated current (%) File Name:HVG150SPEC 180529
DIMMING OPERATION HVG150 DIM(Blue) DIM(White) V(Black) V(Red) 3 in 1 dimming function (for B/ABType) Output constant current level can be adjusted by applying one of the three methodologies between DIM and DIM: 0 ~ 10VDC, or 10V PWM signal or resistance. Direct connecting to LEDs is suggested. It is not suitable to be used with additional drivers. Dimming source current from power supply: μa (typ.) Applying additive 0 ~ 10VDC % 90% Output current (%) % 70% % 50% % 30% % 10% 0% 0V 1V 2V 3V 4V 5V 6V 7V 8V 9V 10V Dimming input: Additive voltage Output current (%) % 90% % 70% % 50% % 30% % 10% 0% 0% 10% % 30% % 50% % 70% % 90% % Duty cycle of additive 10V PWM signal dimming input Applying additive resistance: V V DIM V V DIM Additive Voltage DIM DO NOT connect "DIM to V" Applying additive 10V PWM signal (frequency range Hz ~ 3KHz): V V DIM Additive PWM signal DIM DO NOT connect "DIM to V" DIM DO NOT connect "DIM to V" Additive Resistance Note : 1. Min. dimming level is about 6% and the output current is not defined when 0%< Iout<6%. 2. The output current could drop down to 0% when dimming input is about 0kΩ or 0Vdc, or 10V PWM signal with 0% duty cycle. Output current (%) % 90% % 70% % 50% % 30% % 10% 0% Short 10K/N K/N 30K/N K/N 50K/N K/N 70K/N K/N 90K/N K/N (N=driver quantity for synchronized dimming operation) Dimming input: Additive resistance File Name:HVG150SPEC 180529
OUTPUT LOAD vs TEMPERATURE(Note.9) Others V,15V V 15V Others LOAD (%) LOAD (%) 25 10 0 15 30 50 70 (HORIZONTAL) 25 0 45 65 75 85 (HORIZONTAL) AMBIENT TEMPERATURE,Ta ( ) Tcase ( ) STATIC CHARACTERISTIC POWER FACTOR (PF) CHARACTERISTIC LOAD (%) 90 70 50 1 347 4 4 528 INPUT VOLTAGE (V) Hz PF Tcase at 75 Constant Current Mode 1 0.98 0.96 0.94 0.92 0.9 0.88 0.86 0.84 0.82 0.8 0.78 50% % 70% % 90% % (150W) LOAD 4V 347V 277V 230V THD(%) TOTAL HARMONIC DISTORTION (THD) 48V Model, Tcase at 75 18 16 14 10 8 6 4 2 0 50% % 70% % 90% % LOAD 4VAC 347VAC 277VAC 230VAC EFFICIENCY(%) EFFICIENCY vs LOAD possess superior working efficiency that up to 91.5% can be reached in field applications. 48V Model, Tcase at 75 95 90 85 4V 347V 277V 75 230V 70 65 10% % 30% % 50% % 70% % 90% % LOAD File Name:HVG150SPEC 180529
LIFE TIME 1 For HVG150 LIFETIME(Kh) 0 25 30 35 45 50 55 65 70 75 Tc a s e ( ) 1 For HVG15015 LIFETIME(Kh) 0 25 30 35 45 50 55 65 70 75 Tc a s e ( ) 1 For others LIFETIME(Kh) 0 25 30 35 45 50 55 65 70 75 85 Tc a s e ( ) File Name:HVG150SPEC 180529
MECHANICAL SPECIFICATION AType Case No. 994 Unit:mm 9.6 245 STW 18AWG 9.4 34.2 9.4 Tcase 34 Vo ADJ. 106.9 Io ADJ. ψ 4.2 4PL V(Black) V(Red) : Max. Case Temperature BType 245 STW 18AWG 9.6 9.4 34.2 9.4 Tcase 34 106.9 DIM(Blue) DIM(White) V(Black) V(Red) UL2517 18AWG ψ 4.2 4PL : Max. Case Temperature File Name:HVG150SPEC 180529
ABType 245 DType STW 18AWG STW 18AWG 9.6 9.6 9.4 34.2 9.4 9.4 34.2 9.4 Tcase 34 : Max. Case Temperature Tcase 34 245 Vo ADJ. 106.9 106.9 DIM(Blue) DIM(White) V(Black) V(Red) V(Black) V(Red) Io ADJ. UL2517 18AWG ψ 4.2 4PL ψ 4.2 4PL : Max. Case Temperature File Name:HVG150SPEC 180529
WATERPROOF CONNECTION Waterproof connector Waterproof connector can be assembled on the output cable of HVG150 to operate in dry/wet/damp or outdoor environment. AC source I/P HVG150 O/P Size Pin Configuration (Female) Size Pin Configuration (Female) M Order No. Suitable Current 4PIN 5A/PIN M04 10A max. 5PIN 5A/PIN M05 10A max. M15 Order No. Suitable Current 2PIN A/PIN M1502 A max. LED Lamp Cable Joiner 66 26 CJ041 suitable for 14AWG~16AWG CJ042 suitable for 18AWG~22AWG ψ25 Up to four wires can be connected through this cable joiner by soldering or clamping by tools. LED Lamp HVG150 O/P Wires CJ04 cable joiner can be purchased independently for user's own assembly. MEAN WELL order No. : CJ041, CJ042. Junction Box Option 383 76 10 5 SJTW 18AWG 2ψ5 3 PF 1/2" 150± 35 61 8.5 32 8.5 6 V(Black) V(Red) 3 PF 1/2" 150± Junction box option is available for AType. Please contact MEAW WELL for details. 86 INSTALLATION MANUAL Please refer to : http://www.meanwell.com/manual.html File Name:HVG150SPEC 180529