SM326gb - rev 12/06 S E R V I C E Power supplies CBC 140-T, CBC 140-1, CBC 140-2 and M A N U A L WARNER ELECTRIC EUROPE Rue Champfleur, B.P. 20095, F- 49182 St Barthélemy d Anjou Cedex Tél. +33 (0)2 41 21 24 24, Fax + 33 (0)2 41 21 24 00 www.warnerelectric-eu.com
We, WARNER ELECTRIC EUROPE, 7, rue Champfleur, B.P. 20095, F-49182 St Barthélemy d Anjou Cedex state under our sole responsibility, that products in the family: CBC 140-T, CBC 140-1, CBC 140-2, are solely intended to be incorporated in an installation or to be assembled with other equipment with a view to constituting a machine to which directive 98/37/EC as amended applies. The products specified above comply with the requirements of Low Voltage directive 73/23/EC as amended through full conformity with the following standards: EN 61010-1, 6.5.1/6.7/6.2/6.8.4 and VDE 0160,5.7/5.5.1/7.6.1/7.6.2 If installed and wired as instructed (Chap 3), these products comply with standards EN50081-1 and EN50082-1 relative to CEM directive 89/336/EEC as amended. Drawn up in St Barthélemy d Anjou, July 2002 Eric Prat, General Managing Director CONTENTS 1 Description 2 2 Characteristics 2-3 3 Dimensions and connections 3-5 1 Description These Warner Electric series CBC 140-T, CBC 140-1, CBC 140-2 and supply units are designed to control Warner Electric Direct Current, electromagnetic brakes and clutches CBC 140-T : Supply unit transformer CBC 140-1 : Supply unit with single wave rectificatio for low current. CBC 140-2 : Supply unit with dual wave rectification for low current. : Supply for high current with single or dual wave rectification, with possibility of overexcitation/ holding voltage Max. Input voltage : 230VAC Presentation in box The built-in protection limits the reverse voltage from induction and protects the control switches. The power supplies are fitted with a built-in fuse to protect from short circuits, located beneath the part of the box carrying the identification label (see Chap. 3.) 2 Characteristics 2-1 Convertor CBC 140-T Reference: B 905-9999 Input voltage: 230/40 Output voltage: 27.5 VAC / 3 Power: 150 VA Current: 6 A 2-2 Power suplies See tables 1 and 2 Name CBC 140-1 CBC 140-2 Reference ACG830A1P1 ACG830A1P2 Frequency (Hz) 50/60 50/60 Input voltage (VAC) 230/400 27 115 230 Output voltage (VDC) 103,5/180 24 103,5 207 Max. current (A) 1 2 2 2 Table 1 WARNER ELECTRIC EUROPE - Rue Champfleur, B.P. 20095, F - 49182 St Barthélemy d Anjou Cedex SM326gb - rev 12/06 2/5
Symbol designating an action that might damage the brake Symbol designating an action that might be dangerous to human safety Symbol designating an electrical action that might be dangerous to human safety Name Reference 7 67 000416 Frequency (Hz) 50 / 60 Input voltage (VAC) Terminal 1 and 2 U 230 115 30 State of contact Terminals 3 et 4 Closed Open Closed Open Closed Open Closed Open Ouput voltage VDC Terminals 7 et 8 U x 0,9 U x 0,45 207 103,5 103,5 51,7 24 12 Max. current (A) - - 2 4 4 4 4,5 4,5 Max. power (W) - - 414 414 414 207 108 54 Admissible max. power (W) during overexcitation 2s max - - 828 828 414 414 108 108 Table 2 3 Dimensions and connections WARNING The current present in these supply units can cause serious injury (or even death). Ensure when installing them or any other electrical equipment that the supply is switched off. 112 Only switch on again when fully installed and properly wired in accordance with local regulations and all installation, including cleaning, is fully completed. 126 All works on the electrical connections have to be made with power off. 40 3-1 The units should be fitted in a closed metal cabinet. 3-2 Power link between control and clutch / brake by screened cable. 3-3 Setting connection, inputs and outputs by screened cables 105 CBC 140 - T 116 3-4 Screens are connected to earth at both ends of the cable. 3-5 Control cables and power 3 27,5 VAC WARNER ELECTRIC EUROPE - Rue Champfleur, B.P. 20095, F - 49182 St Barthélemy d Anjou Cedex SM326gb - rev 12/06 3/5
CBC 140-1 46 CBC 140-2 40 ø 4,5 18 CBC 140-1 CBC 140-2 1 2 3 4 5 6 3 28 AC + - DC : contactor (3 A / 400 V), not supplied Mounting on a DIN rail (EN50-022) Fuse 6,3 A 1 OR 2 waves POWER SUPPLY 1 OR 2 WAVES POWER SUPPLY OUTPUT VDC : : 207V/2A - 103.5-103.5 V/4A - V/4A 24V/4.5A - 24V/4.5A 7 / 8 SWITCH ON/OFF 5 / 6 Choice 11 or or 2 waves 2 waves 3 / 4 1 / 2 2 waves ON 2 waves Input U x 0.9 Max 230 VV U 1 wave OFF 1 wave U x 0.45 1 2 3 4 5 6 7-8+ 90 DIN RAIL EN50022 71 58 Connection examples, apparatus supply, 24 VDC with a convertor CBC 140-T 40 : contactor (9 A / 400 V), not supplied CBC 140 - T 27,5 VAC 3 Shunt 24 VDC WARNER ELECTRIC EUROPE - Rue Champfleur, B.P. 20095, F - 49182 St Barthélemy d Anjou Cedex SM326gb - rev 12/06 4/5
Apparatus supply, 103,5 VDC, from : contactor (9 A / 400 V), not supplied 103,5 VDC Apparatus supply 103,5 VDC, with overexcitation 207 VDC then holding voltage 103,5 VDC, from Temporised relay (0,5 to 2 s, 9 A /400 V) not supplied : contactor ( 9 A / 400 V), not supplied 207 / 103,5 VDC Apparatus supply 48 VDC, with overexcitation 103,5 VDC then holding voltage 48 VDC, from 115 VAC Temporised relay (0,5 to 2 s, 9 A /400 V) not supplied : contactor ( 9 A / 400 V), not supplied 115 VAC 103,5 / 48 VDC Subject to alteration without prior notice WARNER ELECTRIC EUROPE - Rue Champfleur, B.P. 20095, F - 49182 St Barthélemy d Anjou Cedex SM326gb - rev 12/06 5/5