Features Up t 1.25Gb/s bidirectinal data links Ht-pluggable SFP ftprint TX Disable and RX Ls/withut Ls functin Fully metallic enclsure fr lw EMI Lw pwer dissipatin (1.05 W typical) Cmpact RJ-45 cnnectr assembly Access t physical layer IC via 2-wire serial bus 1000 BASE-T peratin in hst systems with SERDES interface 10/100/1000Mbps cmpliant in hst systems with SGMII interface Operating case temperature range f 0 C t +70 C (Cmmercial) r -20 C t +85 C (Extend) 1000BASE-T and 10/100/1000BASE-T Cpper SFP Transceiver XSUEx1-M1Rx Applicatins 1.25 Gigabit Ethernet ver Cat 5 cable Descriptin Xenya`s XSUEx1-M1Rx Cpper Small Frm Pluggable (SFP)transceivers is high perfrmance, cst effective mdule cmpliant with the Gigabit Ethernet and 1000BASE-T standards as specified in IEEE 802. 3-2002 and IEEE 802.3ab, which supp- rting 1000Mbps data- rate up t 100 meters reach ver unshielded twisted-pair categry 5 cable. The mdule supprts1000 Mbps full duplex data-links with 5-level Pulse Amplitude Mdulatin (PAM) signals. All fur pairs in the cable are used with symbl rate at 250Mbps n each pair. The mdule prvides standard serial ID infrmatin cmpliant with SFP MSA, which can be accessed with address f A0h via the 2wire serial CMOS EEPROM prtcl. The physical IC can als be accessed via 2wire serial bus at address ACh.
Pin Definitins Pin Diagram Figure 1. Pin Definitins
Pin Descriptins Pin Signal Name Descriptin Plug Seq. Ntes 1 VEET Transmitter Grund 1 2 TX FAULT Transmitter Fault Indicatin 3 Nte1 3 TX DISABLE Transmitter Disable 3 Nte2 4 MOD_DEF(2) SDA Serial Data Signal 3 Nte3 5 MOD_DEF(1) SCL Serial Clck Signal 3 Nte3 6 MOD_DEF(0) TTL Lw 3 Nte3 7 Rate Select Nt Cnnected 3 8 LOS Lss f Signal 3 Nte4 9 VEER Receiver grund 1 10 VEER Receiver grund 1 11 VEER Receiver grund 1 12 RX- Inv. Received Data Out 3 Nte 5 13 RX+ Received Data Out 3 Nte 5 14 VEER Receiver grund 1 15 VCCR Receiver Pwer Supply 2 16 VCCT Transmitter Pwer Supply 2 17 VEET Transmitter Grund 1 18 TX+ Transmit Data In 3 Nte 6 19 TX- Inv. Transmit Data In 3 Nte 6 20 VEET Transmitter Grund 1 Ntes: Plug Seq.: Pin engagement sequence during ht plugging. 1) TX Fault is nt supprted and is always cnnected t grund. 2) TX disable, an input used t reset the transceiver mdule, This pin is pulled up within the mdule with a 4.7 KΩ resistr. Lw (0 0.8 V): Transceiver n Between (0.8 V and 2.0 V): Undefined High (2.0 3.465 V): Transceiver in reset state Open: Transceiver in reset state 3) Md-Def 0,1,2. These are the mdule definitin pins. They shuld be pulled up with a 4.7K~10K resistr n the hst bard. The pull-up vltage shall be VccT r VccR Md-Def 0 is grunded by the mdule t indicate that the mdule is present Md-Def 1 is the clck line f tw wire serial interface fr serial ID Md-Def 2 is the data line f tw wire serial interface fr serial ID 4) RX_LOS (Lss f Signal): LVTTL cmpatible with a maximum vltage f Hst_Vcc. RX_LOS can enabled r disabled (Refer t Ordering infrmatin),rx_los is nt used and is always tied t grund via 100-hm resistr. 5) RD-/+: These are the differential receiver utputs. They are AC cupled 100 differential lines which shuld be terminated with 100 (differential) at the user SERDES. 6) TD-/+: These are the differential transmitter inputs. They are AC-cupled, differential lines with 100 differential terminatin inside the mdule.
+3.3V Vlt Electrical Pwer Interface +3.3V vlt Electrical Pwer Interface Parameter Symbl Min Typ Max Units Ntes/Cnditins Supply Current Is 320 375 ma 1.2W max pwer ver full range f vltage and temperature. See cautin nte belw Input Vltage Vcc 3.13 3.3 3.47 V Referenced t GND Maximum Vltage Vmax 4 V Lw-speed signals, electrnic characteristics Lw-Speed Signals, Electrnic Characteristics Parameter Symbl Min Max Units Ntes/Cnditins SFP Output LOW VOL 0 0.5 V SFP Output HIGH VOH hst_vcc - 0.5 hst_vcc + 0.3 SFP Input LOW VIL 0 0.8 V SFP Input HIGH VIH 2 Vcc + 0.3 V V 4.7k t 10k pull-up t hst_vcc, measured at hst side f cnnectr 4.7k t 10k pull-up t hst_vcc, measured at hst side f cnnectr 4.7k t 10k pull-up t Vcc, measured at SFP side f cnnectr 4.7k t 10k pull-up t Vcc, measured at SFP side f cnnectr High-speed electrical interface, transmissin line-sfp High-Speed Electrical Interface Transmissin Line-SFP Parameter Symbl Min Typ Max Units Ntes/Cnditins Line Frequency fl 125 MHz 5-level encding, per IEEE 802.3 Tx Output Impedance Zut,TX 100 Ohm Rx Input Impedance Zin,RX 100 Ohm Differential, fr all Frequencies between 1MHz and 125MHz Differential, fr all Frequencies between 1MHz and 125MHz
High-speed electrical interface, hst-sfp High-Speed Electrical Interface, Hst-SFP Parameter Symbl Min Typ Max Units Ntes/Cnditins Single ended data input swing Vinsing 250 1200 mv Single ended Single ended data utput swing Vutsing 350 800 mv Single ended Rise/Fall Time Tr,Tf 175 psec 20%-80% Tx Input Impedance Zin 50 Ohm Single ended Rx Output Impedance Zut 50 Ohm Single ended General specificatins General Parameter Symbl Min Typ Max Units Ntes/Cnditins Data Rate BR 10 1000 Mb/sec IEEE 802.3 cmpatible. See Ntes 2 thrugh 4 belw Cable Length L 100 m Categry 5 UTP. BER <10-12 Ntes: 1. Clck tlerance is +/- 50 ppm 2. By default, the XSUEx1-M1RN is a full duplex device in preferred master mde 3. Autmatic crssver detectin is enabled. External crssver cable is nt required Envirnmental specificatins Parameter Symbl Min Typical Max Unit Operating Case Temperature Cmmercial 0 +70 C Tc Extend -20 +85 C Strage Temperature -40 +85 C
Mechanical Specificatins The hst-side f the XSUEx1-M1RN cnfrms t the mechanical specificatins utlined in the SFP MSA1. The frnt prtin f the SFP (part extending beynd the face plate f the hst) is larger t accmmdate the RJ-45 cnnectr. Figure 2. Mechanical dimensins Regulatry Cmpliance XENYA SFP-Cper transceiver is designed t be Class I Laser safety cmpliant and is certified per the fllwing standards: Feature Agency Standard Envirnmental prtectin Certificate / Cmments SGS RHS Directive 2002/95/EC GZ090319751A/CHEM
Ordering infrmatin Part number Speed mde MAC interface TX Disable functin Link Indicatr n RX_LOS Pin Temp XSUEA1-M1RN 10/100/1000Mbps SGMII Yes Yes 0~70 XSUEB1-M1RN 10/100/1000Mbps SGMII Yes N 0~70 XSUE11-M1RN 1000Mbps SERDES Yes Yes 0~70 XSUE21-M1RN 1000Mbps SERDES Yes N 0~70 XSUEA1-M1RD 10/100/1000Mbps SGMII Yes Yes -20 C~+85 C XSUEB1-M1RD 10/100/1000Mbps SGMII Yes N -20 C~+85 C XSUE11-M1RD 1000Mbps SERDES Yes Yes -20 C~+85 C XSUE21-M1RD 1000Mbps SERDES Yes N -20 C~+85 C XSUEM1-M1RN 10/100/1000Mbps SGMII NO NO 0~70 XSUEG1-M1RN 1000Mbps SERDES NO NO 0~70 References 1. Small Frm Factr Pluggable (SFP) Transceiver Multi-Surce Agreement (MSA), September 2000. 2. IEEE802.3 2002. 3. AT24C01A/02/04/08/16 2-Wire Serial CMOS E2PROM, Atmel Crpratin. Imprtant Ntice Perfrmance figures, data and any illustrative material prvided in this data sheet are typical and must be specifically cnfirmed in writing by XENYA befre they becme applicable t any particular rder r cntract. In accrdance with the XENYA plicy f cntinuus imprvement specificatins may change withut ntice. The publicatin f infrmatin in this data sheet des nt imply freedm frm patent r ther prtective rights f XENYA r thers. Further details are available frm any XENYA sales representative. E-mail: inf@xenya.si Web: www.xenya.si XSUEx1-M1Rx- 140530164100