SERIES 8000 LAN FOUR 1X6 TWO 1X2 Product Part Number: 90570150 Document # 07500102 Revision: B July 16, 2010
Revision: B 07500102 Page 2 of 17
Record of Changes Revision Description of Change Chg Order # Approved By A Initial Release ----- B Reformatted ECO-03263 J.LUM Revision: B 07500102 Page 3 of 17
Table of Contents SECTION 1... 5 OVERVIEW... 5 FUNCTIONAL DESCRIPTION... 5 WARRANTY... 5 FRONT/REAR VIEW... 6 SECTION 2... 7 UNIT DEFAULTS... 7 SCPI COMMANDS... 7 SWITCH CLOSURE, COUNTER, QUERY COMMANDS... 8 SECTION 3... 9 AC INPUT MODULE FUSE... 9 52000100 024 FUSE,250V,TYPE T,SLO BLO,6.3 AMP... 9 POWER SUPPLY SPECIFICATIONS... 9 47500680 Universal Power Supply,250W,5V/30A & 12V/16.7A,W/FAN... 9 SECTION 4... 10 RF SWITCH SPECIFICATIONS... 10 52200020 001 SP6T RF SWITCH... 10 52200120 SPDT SWITCH... 10 SECTION 5... 11 PARTS LIST/OUTLINE DRAWINGS... 11 90570150 PARTS LIST... 11 90570150 OUTLINE DRAWING... 12 90570150 SWITCH CONNECTIONS... 13 85003830 002 PWA, RELAY DRIVER BOARD... 14 88102320 002 CABLE ASSEMBLY FOR 1X6 RF SWITCH... 15 88101690 002 CABLE ASSY 1X2 MICROWAVE FOR SW11... 16 88101690 003 CABLE ASSY 1X2 MICROWAVE FOR SW12... 17 Revision: B 07500102 Page 4 of 17
SECTION 1 OVERVIEW This manual describes a version of the Giga tronics 8000 series LAN products. Part Number (P/N) 90570150 is a Full Rack wide unit with four (4) 1X6 Non terminated RF Switches, and two (2) Non terminated Single Pole Double Throw (SPDT) switches that are controlled by an Ethernet Interface. FUNCTIONAL DESCRIPTION The design is housed in a 3 RU (5.25 inch) high, full rack size unit. The unit fits in a standard 19 inch rack and is provided with mounting flanges to enable it to be mounted in the rack. The unit is self contained, that is, it contains its own power supplies, Ethernet Interface, RF relay driver circuits and the RF Relays mounted on the front. The RF Switches can be removed from the front of the unit. The Ethernet interface is a VXI 11.3 compliant interface. This interface is tn IEEE 488.2 device and uses standard SCPI commands to control its digital interface. (See Section 2 for the SCPI Command Set for this instrument.) A single power supply supplies +5.00 VDC and +12.0VDC to the unit. The power supply input is 90 250VAC, 47 63 Hz. (See Section 3 for full specifications) The RF switches provided are 50 Ohm impedance, with a frequency range of 0 26.5 GHz at 3dB with SMA connectors, (See Section4 for full specifications) WARRANTY Product is warranted to conform to all applicable specifications for a period of three (3) years from acceptance, or 10 million cycles in the case of relays, whichever comes first. Revision: B 07500102 Page 5 of 17
FRONT/REAR VIEW Figures 1 and 2 illustrate the front and rear power, power indicator and switch positions for the unit. Figure 1 Figure 2 Revision: B 07500102 Page 6 of 17
SECTION 2 UNIT DEFAULTS This unit is shipped from the factor with the following default settings: Default IP Address: 192.168.5.254 Default Timeout: 1000 (seconds) SCPI COMMANDS Revision: B 07500102 Page 7 of 17
SWITCH CLOSURE, COUNTER, QUERY COMMANDS The SCPI commands required to set switch positions, query the switch count and to save counters are listed below: These end user commands are always accessible. ROUTe:SWITch Sw, P Sets a switch to a desired position. Sw is the switch identification number, 1 6. P is the desired position as a decimal value. Sw Positions 1 0, 1, 2, 3, 4, 5, 6 2 0, 1, 2, 3, 4, 5, 6 3 0, 1, 2, 3, 4, 5, 6 4 0, 1, 2, 3, 4, 5, 6 5 0 = Normally Closed, 1 = Normally Open 6 0 = Normally Closed, 1 = Normally Open ROUTe:SWITch? Sw Returns switch position, current switch count, and switch identifier string. Sw is a number from 1-6 to identify the switch. The response is: Sw, position, count, ID. An example is: ROUTe:SWITch? 2 2, 5, 1002123, S/N 12345678 ROUTe:SWITch:SAVe ROUTe:SWITch:SAVe? Saves all switch counter values to flash memory. The command only saves the current counter values. Queries the number of flash saves done via the ROUTe:SWITch:SAVe command, power fail and auto save intervals. Revision: B 07500102 Page 8 of 17
SECTION 3 The unit is equipped with a replaceable fuse on the AC power input module AC INPUT MODULE FUSE 52000100-024 - FUSE,250V,TYPE T,SLO-BLO,6.3 AMP POWER SUPPLY SPECIFICATIONS 47500680 Universal Power Supply,250W,5V/30A & 12V/16.7A,W/FAN INPUT Parameter Conditions /Description Min Nom Max Units Input Frequency 47 63 Hz Input Voltage 90 132 / 180 264 Auto selectable 90 264 VAC Input Current At 100 120 VAC At 200 240 VAC 8 4 A A Inrush Current Peak measured at 230 VAC at full load, cold start Peak measured at 115 VAC at full load, cold start 70 35 A A Power Factor Passive power factor correction meets EN61000 3 2 class a OUTPUT Parameter Conditions /Description Min Nom Max Units Transient Response Output voltage returns to within 1% in less than 2.5 ms for a 50% load change. Peak transient does not exceed 5% Overshoot Turn on and turn off overshoot shall not exceed 5% over nominal voltage Efficiency Measured at 230V and full load 75% Turn on Delay At 120 VAC 1 second Hold up Time At 120 VAC and 80% of rated maximum load 20 ms PROTECTION CIRCUIT Parameter Overload Short Circuit Output Over voltage Over Temperature Conditions /Description Current limiting starts at 110 140% of the rated output current in foldback mode and recovers automatically Short circuit can be continuous. Recovers automatically upon removal of shout Output is protected against over voltage. Unit shuts down and latches when the voltage at output terminals exceed 130%. AC needs to be reset to restart the power supply Power Supply shuts down when temperature is in excess of 85 C. Auto Recovery Revision: B 07500102 Page 9 of 17
SECTION 4 RF SWITCH SPECIFICATIONS 52200020-001 - SP6T RF SWITCH RF CHARACTERISTICS Number of Ways 6 Frequency Range 0 26.5 GHz Impedence 50 Ohms Frequency (GHz) 0 3 3 8 8 12.4 12.4 18 18 26.5 V.S.W.R <= 1.20 1.30 1.40 1.50 1.60 Insertion Loss <= 0.20 db 0.30 db 0.40 db 0.50 db 0.60 db Isolation >= 80 db 70 db 60 db 60 db 55 db Average Power (25 C) 240W 150W 120W 100W 40W ELECTRICAL CHARACTERISTICS Actuator Normally Open Nominal Current at 25 C (±10%) 250 ma Switching Voltage (Vcc) 12V (10.2 to 13V) / Positive Common Terminals 16 Pin double row Connector for 2.54mm pitch socket MECHANICAL CHARACTERISTICS Connectors SMA Female per Mil C 39012 Life 10,000,000 cycles per position Switching Time (Nominal Voltage; 25 C) < 10 ms Weight < 120 g 52200120 - SPDT SWITCH RF CHARACTERISTICS Number of Ways 2 Frequency Range 0 26.5 GHz Impedence 50 Ohms Frequency (GHz) 0 3 3 8 8 12.4 12.4 18 18 26.5 V.S.W.R <= 1.20 1.30 1.40 1.50 1.60 Insertion Loss <= 0.20 db 0.30 db 0.40 db 0.50 db 0.60 db Isolation >= 80 db 70 db 60 db 60 db 50 db Average Power (25 C) 120W 50W 60W 50W 30W ELECTRICAL CHARACTERISTICS Actuator Failsafe Nominal Current at 25 C (±10%) 160 ma Switching Voltage (Vcc) 12V (10.2 to 13V) / Positive Common Terminals Solder (250 C for max/30 sec) MECHANICAL CHARACTERISTICS Connectors SMA Female per Mil C 39012 Life 10,000,000 cycles per position Switching Time (Nominal Voltage; 25 C) < 10 ms Construction Splash proof Weight < 120 g Revision: B 07500102 Page 10 of 17
PARTS LIST/OUTLINE DRAWINGS 90570150 PARTS LIST 90570150 Top Level Assembly SERIES 8000 LAN SECTION 5 90570150 OL ASSY,LAN M/W,4 1X6,2 1X2 Outline Dwg 85003830 PWA, Relay Driver Board 47000600 PWA, Digital Interface LAN to Parallel PCA 47500680 Power Supply, 5VDC/30A & 12VDC/16.7A with Fan 52000100 024 Fuse,250V,Type T,SLO BLO,6.3 Amp 52200020 001 RF Switch, 1X6 Non terminated, 26.5 GHz 52200120 RF Switch, SPDT (1X2) Non terminated 26.5 GHz 88102320 002 Cable Assembly for 1X6 RF Switch 88101690 002 Cable Assembly for SPDT RF Switch 88101690 003 Cable Assembly for SPDT RF Switch Revision: B 07500102 Page 11 of 17
90570150 OUTLINE DRAWING Revision: B 07500102 Page 12 of 17
90570150 SWITCH CONNECTIONS Revision: B 07500102 Page 13 of 17
85003830-002 PWA, RELAY DRIVER BOARD Revision: B 07500102 Page 14 of 17
88102320-002 CABLE ASSEMBLY FOR 1X6 RF SWITCH Revision: B 07500102 Page 15 of 17
88101690-002 CABLE ASSY 1X2 MICROWAVE FOR SW11 Revision: B 07500102 Page 16 of 17
88101690-003 CABLE ASSY 1X2 MICROWAVE FOR SW12 Revision: B 07500102 Page 17 of 17