Name No. Geometry 9-3 1) Complete the table: Name No. Geometry 9-1 1) Name a secant. Name a diameter. Name a tangent. Name No. Geometry 9-2 1) Find JK

Similar documents
9.1 and 9.2 Introduction to Circles

(1) Page 482 #1 20. (2) Page 488 #1 14. (3) Page # (4) Page 495 #1 10. (5) Page #12 30,

Tangents to Circles. The distance across the circle, through its center, is the diameter of the circle. The diameter is twice the radius.

Investigation 1 Going Off on a Tangent

9-1: Circle Basics GEOMETRY UNIT 9. And. 9-2: Tangent Properties

Geometry by Jurgensen, Brown and Jurgensen Postulates and Theorems from Chapter 1

Unit 6 Lesson 1 Circle Geometry Properties Project

CHAPTER 10 PROPERTIES OF CIRCLES

Sec Geometry - Constructions

What role does the central angle play in helping us find lengths of arcs and areas of regions within the circle?

6.00 Trigonometry Geometry/Circles Basics for the ACT. Name Period Date

Geometry 1 FINAL REVIEW 2011

Where should Sam and Marla Wilson look for a new apartment that is equidistant from their jobs?

Student Name: Teacher: Date: District: Rowan. Assessment: 9_12 T and I IC61 - Drafting I Test 1. Form: 501

UNIT 1 GEOMETRY. (revision from 1 st ESO) Unit 8 in our books

FINAL REVIEW. 1) Always, Sometimes, or Never. If you answer sometimes, give an example for when it is true and an example for when it is not true.

1. Construct the perpendicular bisector of a line segment. Or, construct the midpoint of a line segment. 1. Begin with line segment XY.

Project Maths Geometry Notes

UNIT 1 SIMILARITY, CONGRUENCE, AND PROOFS Lesson 3: Constructing Polygons Instruction

UNIT PLAN. Grade Level: Unit #: 7 Unit Name: Circles

UNIT 3 CIRCLES AND VOLUME Lesson 3: Constructing Tangent Lines Instruction

Droodle for Geometry Final Exam

CHAPTER. 11 Circles Carnegie Learning, Inc.

Senior Math Circles: Geometry III

Tangents and Chords Off On a Tangent

h r c On the ACT, remember that diagrams are usually drawn to scale, so you can always eyeball to determine measurements if you get stuck.

University of Houston High School Mathematics Contest Geometry Exam Spring 2016

Geometry Mrs. Crocker Spring 2014 Final Exam Review

Name: Partners: Math Academy I. Review 2 Version A

Indicate whether the statement is true or false.

Arcs, Central and Inscribed Angles Coming Full Circle

3 In the diagram below, the vertices of DEF are the midpoints of the sides of equilateral triangle ABC, and the perimeter of ABC is 36 cm.

G.C.A.2: Chords, Secants and Tangents 9

10.13 Sample A.G.E. program

Class 5 Geometry O B A C. Answer the questions. For more such worksheets visit

Geometry For Technical Drawing Chapter 4

Geometry Station Activities for Common Core State Standards

APPLIED GEOMETRY COORDINATE SYSTEM LINE CONSTRUCTION LINE CONSTRUCTION BISECTING LINE OR ARC LINE CONSTRUCTION

Geometry 2001 part 1

Day Opener. a) The midsegment of a trapezoid is 10 inches long. One base is 19 inches long. How long is the other base? 128

Table of Contents. Standards Correlations...v Introduction...vii Materials List... x

Geometry. Practice Pack

0810ge. Geometry Regents Exam y # (x $ 3) 2 % 4 y # 2x $ 5 1) (0,%4) 2) (%4,0) 3) (%4,%3) and (0,5) 4) (%3,%4) and (5,0)

The diagram shows the construction of PS through point F that is parallel to RQ. Can the statement justify that. Unit 4, 29.2

m BED m BD and m ABE m AE. Apply the Ext. Thm. to BCE to prove that m C Answers for Lesson 12-4, pp Exercises Geometry Chapter

is formed where the diameters intersect? Label the center.

b. Draw a line and a circle that intersect at exactly one point. When this happens, the line is called a tangent.

MATH FCAT PRACTICE (Grade 10, Lesson 6, Part A)

Unit 4: Geometric Construction (Chapter4: Geometry For Modeling and Design)

CTB/McGraw-Hill. Math Quarter 2: Week 5: Mixed Review Test ID:

Activity 5.2 Making Sketches in CAD

PENNSYLVANIA. List properties, classify, draw, and identify geometric figures in two dimensions.

June 2016 Regents GEOMETRY COMMON CORE

11 1 Reteach Lines That Intersect Circles

Step 2: Extend the compass from the chosen endpoint so that the width of the compass is more than half the distance between the two points.

CONIC SECTIONS 1. Inscribe a parabola in the given rectangle, with its axis parallel to the side AB

Introduction to Autodesk Inventor User Interface Student Manual MODEL WINDOW

The Magic Circle Basic Lesson. Developed by The Alexandria Seaport Foundation

CBSE Sample Paper Class 10 Mathematicss

JK XY LJ LJ ZX KL KL YZ LJ KL YX KJ. Final Exam Review Modules 10 16, 18 19

Chapter 1. Trigonometry Week 6 pp

SolidWize. Online SolidWorks Training. Simple Sweep: Head Scratcher

2. Here are some triangles. (a) Write down the letter of the triangle that is. right-angled, ... (ii) isosceles. ... (2)

1 st Subject: 2D Geometric Shape Construction and Division

Technical Drawing Paper 1 - Higher Level (Plane and Solid Geometry)

Shelf, Treasure Chest, Tub. Math and Quiet!! Center, A. Quiet Dice for Make. (Talk! = Walk!) A. Warm Up or Lesson, CONTINUE ON!! B.

Inscribed Angles. Investigating Central Angles and

Engineering Graphics, Class 5 Geometric Construction. Mohammad I. Kilani. Mechanical Engineering Department University of Jordan

Angle Measure and Plane Figures

SOL Review April Class work-nallari Math 8 Measurement & Geometry SOL -CAT Questions 13 SOL 8.6a, 8.7a-b, 8.8a-b,8.9,8.10a-b&8.

14.1 Central Angles and Inscribed Angles

MATHEMATICS GEOMETRY HONORS. OPTIONS FOR NEXT COURSE Algebra II, Algebra II/Trigonometry, or Algebra, Functions, and Data Analysis

Locus Locus. Remarks

1. Convert 60 mi per hour into km per sec. 2. Convert 3000 square inches into square yards.

BRITISH COLUMBIA SECONDARY SCHOOL MATHEMATICS CONTEST, 2006 Senior Preliminary Round Problems & Solutions

Module 1H: Creating an Ellipse-Based Cylindrical Sheet-metal Lateral Piece

If the sum of two numbers is 4 and their difference is 2, what is their product?

Constructions. Unit 9 Lesson 7

ENGINEERING GRAPHICS

3 Kevin s work for deriving the equation of a circle is shown below.

Performance Task: In the image below, there are three points (J, K, and I) located on different edges of a cube.

Table of Contents. Constructions Day 1... Pages 1-5 HW: Page 6. Constructions Day 2... Pages 7-14 HW: Page 15

Downloaded from

Geometer s Skethchpad 8th Grade Guide to Learning Geometry

MODELING AND DESIGN C H A P T E R F O U R

Elementary Geometric Drawings Angles. Angle Bisector. Perpendicular Bisector

Regents Review # In the accompanying diagram, PC is tangent to circle at C and PAB is a secant. If PC = 8 and PA = 4, find AB.

The University of the State of New York REGENTS HIGH SCHOOL EXAMINATION GEOMETRY

The Texas Education Agency and the Texas Higher Education Coordinating Board Geometry Module Pre-/Post-Test. U x T'

Period: Date Lesson 2: Common 3-Dimensional Shapes and Their Cross- Sections

2. 8, 6, 4, 2, 0,? [A] 2 [B] 2 [C] 3 [D] 1 [E] New Item. [A] 5 and 4 [B] 5 and 10 [C] 7 and 6 [D] 9 and 10

Analytic Geometry EOC Study Booklet Geometry Domain Units 1-3 & 6

Optimization Exploration: The Inscribed Rectangle. Learning Objectives: Materials:

FSA Geometry EOC Getting ready for. Circles, Geometric Measurement, and Geometric Properties with Equations.

7th Grade Drawing Geometric Figures

Challenges from Ancient Greece

The University of the State of New York REGENTS HIGH SCHOOL EXAMINATION GEOMETRY. Wednesday, January 29, :15 a.m. to 12:15 p.m.

Geometric Puzzle Medley

Grade 7 Mathematics Item Specifications Florida Standards Assessments

Math Section 4.3 Unit Circle Trigonometry

Transcription:

Geometry 9-1 1) Name a secant 1) Complete the table: Name a diameter Name a tangent Geometry 9-2 1) Find JK 2) Find the measure of 1 Geometry 9-2 2) 3) At 2:00 the hands of a clock form an angle of

2) Complete the table: Geometry 9-1 1) Name a secant Name a diameter Name a tangent 2) Find the measure of 1 Geometry 9-2 1) Find JK 3) At 2:00 the hands of a clock form an angle of Geometry 9-2 2)

Name No. 1) 1) Find x and y 2) Sketch a circle O with radius of length 17 and chord of length 30. How far is the chord from O? 2) Find x and y 3) A plane P cuts sphere O in a circle that has diameter 20. If the diameter of the sphere is 30, how far is the plane from O? 3) Find x, y, and z

1) Find x and y Name No. 1) 2) Find x and y 2) Sketch a circle O with radius of length 17 and chord of length 30. How far is the chord from O? 3) Find x, y, and z 3) A plane P cuts sphere O in a circle that has diameter 20. If the diameter of the sphere is 30, how far is the plane from O?

1) Find x 1) 2) Find x 2) 3) Find x 3)

1) 1) Find x 2) 2) Find x 3) 3) Find x

1) Using the diagram below, name: O OT c. RL d. SR e. SR f. L g. LH 4) When a triangle is inscribed in a semicircle, what 2 facts can you state about its angles? What fact can you state about the diameter of the circle? c. 2) When a plane intersects a sphere, what do you know about the figure formed by this intersection? 5) When a line is tangent to a circle, what occurs at the point of tangency? 3) When a quadrilateral is inscribed in a circle, what 2 facts can you state about its interior angles? 6) Describe the relationship between the measure of an intercepted arc of a circle and the measure of its corresponding: central angle inscribed angle c. angle formed by a secant and a tangent

4) When a triangle is inscribed in a semicircle, what 2 facts can you state about its angles? What fact can you state about the diameter of the circle? c. 1) Using the diagram below, name: O OT c. RL d. SR e. SR f. L g. LH 5) When a line is tangent to a circle, what occurs at the point of tangency? 2) When a plane intersects a sphere, what do you know about the figure formed by this intersection? 6) Describe the relationship between the measure of an intercepted arc of a circle and the measure of its corresponding: central angle 3) When a quadrilateral is inscribed in a circle, what 2 facts can you state about its interior angles? inscribed angle c. angle formed by a secant and a tangent

7) Describe 3 situations where the measure of an angle equals half the difference of its intercepted arcs: 10) When 2 chords intersect within a circle, what do you know about the lengths of the segments of the chords? c. 8) When is the measure of an angle equal to the half the sum (or average) of its intercepted arcs? 11) Describe the following: concurrent circles externally tangent circles c. internally tangent circles d. common internal tangent e. common external tangent 9) When a chord and a radius intersect within a circle at 90, identify two important results: 12) When the following intersect outside a circle, what do you know about the lengths of their segments? 2 secants 1 secant and 1 tangent c. 2 tangents

10) When 2 chords intersect within a circle, what do you know about the lengths of the segments of the chords? 7) Describe 3 situations where the measure of an angle equals half the difference of its intercepted arcs: c. 11) Describe the following: concentric circles 8) When is the measure of an angle equal to the half the sum (or average) of its intercepted arcs? externally tangent circles c. internally tangent circles d. common internal tangent e. common external tangent 12) When the following intersect outside a circle, what do you know about the lengths of their segments? 2 secants 9) When a chord and a radius intersect within a circle at 90, identify two important results: 1 secant and 1 tangent c. 2 tangents