Copper Core & Coil Transformer
Transformer Stomach Pain Normal Operation: Transformer internal structures and windings are subjected to mechanical forces due to the magnetic forces. Through fault current passing through a transformer. Forces can reach millions of pounds, pulling the coils up, down, and apart 60/50 times per second.
Transformer Stomach Pain By designing the internal structure very strong to withstand these forces over a long period of time, service life can be extended. Notice in Figure 1 that the internal low-voltage coil is being pulled downward, while the high-voltage winding is pulled up, in the opposite direction. At the same time, the right-hand part of the figure shows that the highand low-voltage coils are being forced apart.
Transformer Stomach Pain Keep in mind that these forces are reversing 50/60 times each second. It is obvious why internal structures of transformers must be built incredibly strong. Many times, if fault currents are high, these forces can rip a transformer apart and cause electrical faults inside the transformer itself. This normally results in arcing inside the transformer that can result in explosive failure, submitting the equipment to catastrophic failure.
Free Bucking Mechanical Failure The picture to the side is an example of a free bucking mechanical failure of an inner winding resulting from radial forces in compression on the winding. Note, even though there is mechanical failure, there wasn t a dielectric failure of this winding yet.
Shouldn t Your Transformers Be As Tough As the People Using Them?
Duratrans Transformer The New Industry Standard
Duratrans Transformer
Duratrans Power Range KVA Range - 75kVA to 6000kVA Voltage - up to 25kV Available with dual primary voltages Void free windings Superior mechanical strength Designed for extreme environmental conditions Tested per ANSI C57.12.91 Thermal performance
Duratrans Transformer Proven Harsh Environment Technology Coil Distortion Prevention Technology Corrugated Duct Technology Unique OVAL Technology
Advantages of Duratrans Transformer Safety for people and property No Fire Hazard No maintenance or pollution Applicable for damp and high dust contaminated environments Improved performance against seismic and high vibration areas Environmentally Friendly
Duratrans Technology Application Types Distribution Transformers Substation Transformers VFD transformers Rectifier Transformers Booster Transformers Auto Transformers Shovel Duty Transformers Mine Load Centers
Duratrans Benefits Non Explosive, Flame Retardent and Self Extinguishing Can be designed for use in tempretures -60c to +60c (40c is ANSI standard) Ideal for high humidity and where splasing water is an issue Coils are moisture resistant No timely drying out period required prior to energizing Seals out all environmental contaminants Mechanicly robust to prevent coil distortion Corrugated ducting to increase cooling efficiency
Duratrans Transformer
Power Distribution - Surface
Power Distribution - Underground
What is an Arc Flash..? Where a flashover of electric current leaves its intended path and travels through the air from one conductor to another, or to ground. The Results are often violent when a human is in close proximity to the arc flash, serious injury and even death can occur. Arc Flash can be caused by: Typical Results Dust Burns (immediate and cell deterioration following) Dropping tools Fire Accidental touching Flying objects (molten metal) - OSHA and NFPA (National Fire Protection Association) Blast pressure (upwards of 2,000 lbs. / sq. ft.) Condensation Sound Blast (140 db loud as a gun) Material failure Heat (upwards of 35,000 F 5 times surface temperature of the sun Corrosion Costs: Sometimes in excess of $1 million Faulty Installation Severity The Solution Factors 1. Proximity of the worker to the flash 2. Temperature 3. Time for circuit to break
Arc Guard Mine Power Center Eliminates Potential Arc Flash Injury Passive Control of Arc Does NOT depend on light or electronics Complies with ANSI IEEE Arc Resistant Requirements All surface-underground electrical equipment Type tested at KEMA Power Labs
Arc Guard Mine Power Center
Hot Circuit Detector Smart Plug High Impedance 3 phase voltage detection Loss of phase trips circuit Reverse rotation trips circuit 120v-25kv voltage range Phase sequence +/- 240VAC, 10amp contact output for control The only commercially available connector with voltage sensing May be gear or line mounted (480-595v)
Thank You Questions