Safety Light Curtain Orion1 Extended pprovals: pplication: For finger and hand detection When the light guard should be close to the hazardous zone When muting or blanking are necessary When several devices should be connected in series (cascading) When space is an issue (no dead zone) Features: Finger and hand detection 7 m and 20 m operating distances (finger and hand detection) Compact dimensions Local reset and EDM Muting and lanking Cascading No dead zone The Orion1 Extended light curtains are used for finger or hand detection, usually quite close to the dangerous machine, when advanced functions like muting or cascading are necessary. Easy to use Muting sensors are connected directly to the light curtain, with no need for a remote extra muting module. No dead zone: the resolution is guaranteed along the whole length of the light curtain with no need for extra mechanical guard. Cascading with the standard units, no separate slave or master units. Faster installation lignment help and a wide angle within the limits of a Type 4 device facilitate alignment. M connectors speed up cabling. Less downtime Since the alignment level is displayed on the unit, the alignment can be improved before an unwanted stop occurs. Coding protects against mutual interferences. Extensive error indication reduces troubleshooting time. Protective tubes and lens shields protect the devices in harsh environments. Muting: the machine stops when a person goes through but not when the cases go through. Floating blanking: a hand through the detection zone will stop the machine and the moving wire will not.
Technical data Functional Safety Data EN ISO 13849-1:2008 PL e, Cat 4 EN 6108-1..4:2010 SIL3; PFH d = 2.64 0-9 ; HFT = 1; Mission time = 20 years EN 62061:200/1:2013 SIL CL 3 Power supply +24 VDC ± 20 % Power consumption Transmitter 3 W max Receiver W max (without load) Outputs 2 PNP Short-circuit protection: 1.4 max Output current: 0. max / output Output voltage ON: Vdd -1 V min Output voltage OFF: 0.2 V max Capacitive load: 2.2 μf at +24 VDC max Current for external lamp 20 m min; 300 m max Connectors with specific cables Transmitter with M-C02PT2T: M- pole male connector Receiver with M-C02PT6R: M- pole male connector Receiver with M-C02PT62RM: M- pole male connector + M- pole male connector Cable length (for power supply) 0 m max Light emission ( l ) Infrared, LED (90 nm) Resolution 14-30 mm Operating distance 0.2 20 m for 30 mm 0.2 7 m for 14 mm mbient light rejection ccording to IEC-61496-2:2013 Operating temperature 0 + 0 C Storage temperature - 2 + 70 C Humidity range 1 9 % (no condensation) Protection class IP6 (EN 6029:2000) Weight 1.3 kg / meter for each single unit Housing material Painted aluminium (yellow RL 1003) Front side material PMM Cap material PT Valox 08 Function settings at delivery The functions are configured with push-buttons on the units. No code Muting EDM enabled utomatic Reset T/X muting 10 min muting time-out Override trigger = level Long range * Two specific cables must be ordered with Orion1 Extended, one for the transmitter and one for the receiver. See next page.
Connection Connection transmitter (1) (2) Test (3) (4) Earth Grey () For the transmitter: M-C02PT2T Connection receiver with muting cable M-C02PT62RM M- connector (1) (2) (3) Reset/cknowledge/lign Green (4) Override1 Pink () OSSD2 Yellow (6) EDM (7) Muting selection Grey (8) Red (9) Violet (10) Grey-pink () Red-blue () OSSD1 Override2 Muting lamp Override status Earth For the receiver when muting: M-C02PT62RM M- connector (1) (2) (3) (4) Grey () Muting2 Muting1 Connection receiver with blanking cable M-C02PT6R, to be used whenever muting is not necessary. M- connector (1) (2) (3) Green (4) Pink () Yellow (6) (7) Grey (8) Red (9) Violet (10) Grey-pink () Red-blue () Reset/cknowledge/lign Teach in OSSD2 EDM OSSD1 Tolerance Lamp Earth For the receiver when no muting: M-C02PT6R * Colors according to standard cables Two specific cables must be ordered with Orion1 Extended, one for the transmitter and one for the receiver.
Connection examples Connection to a RT9 safety relay +24V +24V 1 Transmitter Receiver 1 +24V 2 TEST 2 3 RESET/CKN 3 ERTH 4 OVERRIDE1 4 Green OSSD2 Pink EDM 6 Yellow MUTING SELECTION 7 OSSD1 8 Grey OVERRIDE2 9 Red MUTING LMP 10 OVERRIDE STTUS Violett Grey / Pink K1 S14 S34 X1 X4 1 13 23 ERTH Red / RT9 1 - + 2 MUTING2 2 3 Muting sensors S13 S44 S24 Y14 14 24 MUTING1 4 ORION1 Extended 1 1 V2 V1 ORION1 Extended in muting mode with - manual reset - EDM deactivated Note: manual reset should be activated Connection to a Pluto 20 Safety PLC +24V +24V 1 Transmitter Receiver +24V 1 2 TEST 3 2 RESET/CKN 3 ERTH 4 OVERRIDE1 4 Green OSSD2 Pink EDM 6 Yellow MUTING SELECTION 7 OSSD1 8 Grey OVERRIDE2 9 Red MUTING LMP 10 Violett K10 OVERRIDE STTUS Grey / Pink CH CL I0 I1 I6 I7 +24V ERTH Red / Pluto bus Power Q3 Inputs, individual failsafe MUTING2 2 3 Muting sensors Pluto 20v2 MUTING1 4 Failsafe inputs / Indication outputs (not failsafe) / Dynamic outputs Relay output, individual failsafe ORION1 Extended I0 I1 I2 I7 Identifier input IDFIX Power 0L Q0 1L ID ORION1 Extended in muting mode with - manual reset - EDM deactivated 1 1 Note: manual reset should be activated V3 V4
Models and ordering information Orion1-4-14-030-E 2TL022301R0100 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 300 mm Orion1-4-14-04-E 2TL022301R0200 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 40 mm Orion1-4-14-060-E 2TL022301R0300 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 600 mm Orion1-4-14-07-E 2TL022301R0400 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 70 mm Orion1-4-14-090-E 2TL022301R000 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 900 mm Orion1-4-14-10-E 2TL022301R0600 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 100 mm Orion1-4-14-0-E 2TL022301R0700 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 00 mm Orion1-4-14-13-E 2TL022301R0800 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 130 mm Orion1-4-14-10-E 2TL022301R0900 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 100 mm Orion1-4-14-16-E 2TL022301R1000 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 160 mm Orion1-4-14-180-E 2TL022301R00 Orion1 Extended Transmitter + Receiver - R = 14 mm - H = 1800 mm Orion1-4-30-030-E 2TL022303R0100 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 300 mm Orion1-4-30-04-E 2TL022303R0200 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 40 mm Orion1-4-30-060-E 2TL022303R0300 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 600 mm Orion1-4-30-07-E 2TL022303R0400 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 70 mm Orion1-4-30-090-E 2TL022303R000 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 900 mm Orion1-4-30-10-E 2TL022303R0600 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 100 mm Orion1-4-30-0-E 2TL022303R0700 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 00 mm Orion1-4-30-13-E 2TL022303R0800 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 130 mm Orion1-4-30-10-E 2TL022303R0900 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 100 mm Orion1-4-30-16-E 2TL022303R1000 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 160 mm Orion1-4-30-180-E 2TL022303R00 Orion1 Extended Transmitter + Receiver - R = 30 mm - H = 1800 mm Cables M-C02PT2T 2TL02231R0100 Transmitter cable for Orion1 Extended M-C02PT6R 2TL02231R0200 Receiver cable for Orion1 Extended when no muting M-C02PT62RM 2TL02231R0300 Receiver cable for Orion1 Extended when muting PT-C1PT 2TL02231R1000 Cascade cable for Orion1 Extended, 1 m PT-C0PT 2TL02231R00 Cascade cable for Orion1 Extended, 0. m PT-C00PT 2TL02231R00 Cascade cable for Orion1 Extended, 0.0 m M-C61 2TL02006R0000 Straight M- female connector with 6 m shielded cable M-C101 2TL02006R1000 Straight M- female connector with 10 m shielded cable M-C201 2TL02006R1400 Straight M- female connector with 20 m shielded cable M-C6 2TL02006R7200 Straight M- female connector with 6 m shielded cable M-C10 2TL02006R7300 Straight M- female connector with 10 m shielded cable M-C20 2TL02006R700 Straight M- female connector with 20 m shielded cable Spare parts (delivered with products originally) JSM Orion01 2TL022310R0000 4 standard brackets for Orion1 & Orion2 ccessories Orion TP-14 2TL022310R200 Orion Test Piece 14 mm Orion TP-30 2TL022310R300 Orion Test Piece 30 mm Orion Laser 2TL022310R000 Orion Laser pointer JSM Orion01 2TL022310R0000 4 standard brackets for Orion1 & Orion2 JSM Orion06 2TL022310R0400 Kit for mounting of Orion1 & Orion2 in Stand (4 pieces) JSM Orion07 2TL022310R000 Kit for mounting of Orion1 & Orion2 in Stand (6 pieces) JSM Orion 2TL022310R0900 Kit for mounting of Orion1 Mirror in Stand Orion Stand Plate 2TL0223R000 Orion Plate kit for adjustment of protective stand Orion1 Mirror* Deviating mirror to be mounted in Orion Stand with 1 kit JSM Orion Orion Stand* Protective stand * These accessories are available in different sizes. More information on www.abb.com/jokabsafety.
Dimensions 2TLC17203L0201 ll dimensions in millimeters Model Lt (mm) L (mm) Orion1-4-xx-030-E 10 306.30 Orion1-4-xx-04-E 300 46.30 Orion1-4-xx-060-E 40 606.30 Orion1-4-xx-07-E 600 76.30 Orion1-4-xx-090-E 70 906.30 Orion1-4-xx-10-E 900 106.30 Orion1-4-xx-0-E 100 06.30 Orion1-4-xx-13-E 00 136.30 Orion1-4-xx-10-E 130 106.30 Orion1-4-xx-16-E 100 166.30 Orion1-4-xx-180-E 160 1806.30 xx = Resolution (14-30 mm) Varlabergsvägen SE-434 39 Kungsbacka Tel. +46 (0) 21-32 0 00 www.abb.com/jokabsafety