DATA SHEET MITEL Controllers Providing feature-rich IP communication and advanced user applications to corporate local and wide area networks Controllers of devices including software agents 1 of IP phones 1 of SIP devices / users Maximum ACD Agents 1 Maximum 555 IP consoles of analog phones Shipped with: CX II / CXi II 15 15 15 5 15 x ADI DSP modules Power Supply Echo Cancellers AMB MXe III Standard 5 1 5 1 Quad DSP Module Power Supply 6 Echo Cancellers AMB MXe III Expanded 1,5 1, 1, 5 1,5 1 Quad DSP Module Power Supply Echo Cancellers AMB AX 1 1 5 1 Quad DSP Module GB Flash Drive Power Supply Echo Cancellers 1 Engineering rules apply. For low traffic solutions, like Hospitality systems, up to a maximum of 576 devices will be supported, analog devices and up to IP devices. For systems of this size please refer to Mitel system engineering. The Maximum Analog device limit is a nominal figure that depends on the Hardware used to connect the Analog devices. Options include the ASU II and the SX Peripheral Cabinet.
Controllers (cont d) Main Software Storage Media Installed RAM: Available MMC Slots MMC Slots for: Maximum embedded T1/E1 digital trunk modules Maximum embedded BRI modules 1/1/1 MB Ethernet ports Maximum Quad DSP or DSP II modules Maximum Echo Canceller Channels Maximum G.79a compression channels (DSP II=,Quad DSP= Dual DSP=) Maximum T channels of NSU s of digital links (except BRI) Maximum Embedded BRI interfaces ( channels per interface) of Dual FIM modules Dual FIM can be used to connect: Analog Main Board,5 CX II / CXi II GB SATA Solid State Drive or GB SATA Hard Drive 51MB Quad CIM, Single T1/E1, Quad BRI, and DSP II (Do not support Dual trunk modules) See CXi Controller Data connectivity section (1) 96 6 with DSP II 6 LS trunks ONS ports MXe III Standard GB Solid State Drive or GB SATA Hard Drive 51MB 6 Dual FIM, Quad CIM, Single and Dual T1/E1, Quad BRI, Quad DSP, DSP II and Echo Canceller () 6 1 NSU, DSU, Peripheral Cabinets, Triple FIM card and SX Bay 6 LS trunks ONS ports MXe III Expanded GB Solid State Drive or GB SATA Hard Drive 51MB 5 Dual FIM,Quad CIM, Single and Dual T1/E1, Quad BRI, Quad DSP, DSP II and Echo Canceller () 19 19 1 NSU, DSU, Peripheral Cabinets, Triple FIM card and SX Bay 6 LS trunks ONS ports AX GB Flash Drive 51MB Single and Dual T1/E1, Quad BRI, Quad DSP, DSP and Echo Canceller 1 1 (1/1 only) (1) (R NSU only) 1 R NSU Includes Music-on-Hold (1 source supported), Paging (1 paging zone), System Fail Transfer ( circuits). 5 Analog trunks support CLASS Signaling for North America and Latin America. MITEL DATA SHEET
DATA SHEET Controllers (cont d) CX II / CXi II MXe III Standard MXe III Expanded AX Analog Option Board Analog Line card slots 6 of CIM connected ASU s of Fiber and Copper connected SX Bays 6 LS trunks ONS ports 1 7 1 7 1 Tone generators Tone detector circuits ET Channels 6 6 7 DTMF Receivers 19 IP Networking maximum IP trunks between MCD systems IP Networking total max IP trunks SIP trunking total maximum SIP trunks SIP trunking max SIP trunks between peers Maximum controllers in a cluster 999 999 999 999 STP and RSTP Yes Yes Yes Yes Embedded Voicemail ports as standard Maximum embedded voicemail ports 9 Maximum mailboxes 75 75 75 75 Storage hours with SSD 1 with HDD 1 with SDD 1 with HDD 1 with SDD 1 with HDD 5 Maximum messages per mailbox 1 1 1 1 6 The Analog Line card is available in two variants; the ONS circuit card and the LS trunks and 1 ONS extension card. Note the +1 Card supports SFT circuits. 7 Supports up to 19 ET channels when being used in a Trunking Gateway configuration. Up to 999 controllers can be clustered as a single system to support over 65, IP ports. Mitel s System Data Synchronization technology is used to enable feature transparency across a cluster of controllers. 9 Requires a GB flash drive on AX controller. CONTROLLERS
Mitel CXi II Controller Data Connectivity Integral -port powered Layer 1/1 Ethernet switch with embedded.af support Has an additional GigE capable LAN port Provides connection to additional switch ports and router Also has a 1/1 WAN port that is an Internet Gateway WAN port provides connection to an ISP for Internet access (e.g., DSL or cable) WAN port provides NAT and firewall capabilities WAN port does not support IP networking Digital Trunk Connectivity Dual Embedded Digital Trunk Module (MXe III Controller and AX Controller) Each module has two E1/T1 trunk interfaces (links) Provides PRI / QSIG / T1-D / DASS II / DPNSS / IDA-P protocol through the controller (No NSU required) Each interface can run a different protocol, either PRI, QSIG, or T1-D Does not support: Min / Max, NFAS, D-Channel Backup or TDM XNET (Hybrid XNET is supported). Use external router for IP networking Same as you would with a CX II, MXe III, AX Controller Embedded Wireless Phones SpectraLink Polycom.11b* or Mitel IP-DECT wireless phones supported.11b or IP-DECT access points supported *.11b access points must be SpectraLink SVP compliant SIP Lineside and Trunking specifications Please see the SIP CoE MCD RFC specifications document on Mitel OnLine for up to date SIP specification support. MITEL DATA SHEET
DATA SHEET Single Embedded Digital Trunk Module (CX II / CXi II / MXe III / AX Controllers) Each module has a single E1 / T1 trunk interface (link) Provides PRI / QSIG / T1-D / DASS II / DPNSS / IDA-P protocol through the controller (No NSU required) Resiliency (switches to secondary controller) Does not support: Min / Max, NFAS, D-Channel Backup or TDM XNET (Hybrid XNET is supported). Embedded BRI Module (CX II / CXi II / MXe III / AX Controllers) The Embedded BRI module has four Basic Rate Circuits (total 6kbs channels) Each channel may be configured as either a: T (trunk) interface for links from a BRI Central Office (CO) S (subscriber) interface for connecting up to eight BRI devices. NOTE: S interfaces support only basic call features such as calling number display for BRI devices (BRI call handling such as Hold or Transfer are not supported). BRI devices are not line powered from the embedded BRI module. NOTE: This module does not support U interfaces. Dimensions Controller Analog Services Unit (ASU) Network Services Unit (NSU) Height CX II / CXi II / MXe III.5 in. (.9 cm.) (U) AX 1.5 in. (9.9 cm.) (7 U) ASU 1.75 in. (.5 cm.) (1 U) ASU II. in. (. cm.) ( U) 1.75 in. (.5 cm.) (1 U) Peripheral Cabinet 19. in. (. cm.) Width CX II / CXi II / MXe III 17.75 in. (5.1 cm.) (19 in. rack mountable) AX 17. in. (. cm.) 17.75 in. (5.1 cm.) (19 in. rack mountable) 17.75 in. (5.1 cm.) (19 in. rack mountable) 1. in. (5. cm.) Depth CX II / CXi II.5 in. (1.9 cm.) MXe III.5 in. (51. cm.) AX 1.7 in. (5. cm.) ASU 15.5 in. (9. cm.) ASU II 1. in. (. cm.) 15.5 in. (9. cm.) 19. in. (. cm.) Weight CX II / CXi II 19. lb. (.9 kg.) MXe III lb. (1.7 kg.) AX 9.7 Ib. (1.1 kg.) ASU 1.61 lb. (.1 kg.) ASU II 1.1 lb. (6. kg.).1 lb. (.7 kg.) 71. lb. (.6 kg.) CONTROLLERS 5
Operational Environment Temperature Controller to 1 F ( to 5 C) Analog Services Unit (ASU and ASU II) to 1 F ( to 5 C) Network Services Unit (NSU) to 1 F ( to 5 C) Peripheral Cabinet to 1 F ( to 5 C) Humidity 5 95% relative humidity, non condensing 5 95% relative humidity, non condensing 5 95% relative humidity, non condensing 5 95% relative humidity, non condensing Max. Heat Dissipation fully loaded CX II / CXi II 17 BTUs per hour MXe III 75 BTUs per hour AX 1 BTUs per hour ASU 17 BTUs per hour ASU II 6 BTUs per hour 6 BTUs per hour 7 BTUs per hour Air Flow 6 cubic ft. / min. at maximum output of fans AX 11 cubic ft. 15 cubic ft. / min. at maximum output of fans Acoustic Emissions Max 5dBA continuous, 75dBA intermittent (<1% duty cycle) Max 5dBA continuous, 75dBA intermittent (<1% duty cycle) Conversion factors: One watt is equal to.1 BTUs per hour. One ton of refrigeration is equal to 1, BTUs per hour or.5 Kilowatts, and.75 kilowatt-hour is equal to one ton of refrigeration. System Input Power Requirements Input / Disconnect Controller Analog Services Unit Network Services Unit (ASU and ASU II) (NSU) IEC-C1 Class 1 AC Receptacle Receptacles on AX and MXe III with redundant power IEC-C1 Class 1 AC Receptacle IEC-C1 Class 1 AC Receptacle Input Voltage / Frequency Rating 1 VAC 5 / 6 Hz 1 VAC 5 / 6 Hz 1 VAC 5 / 6 Hz Input Power CX II / CXi II 5 W MXe III W MXe III Expanded 5 W AX W ASU 75 W max ASU II 15 W max Universal NSU W R NSU W AC Source 9 6 VAC 9 6 VAC 9 6 VAC Frequency Range 7 6 Hz 67 6 Hz 67 6 Hz 6 MITEL DATA SHEET
DATA SHEET Glossary ACD Automatic Call Distribution ASU Analog Services Unit BRI Basic Rate Interface BTU British Thermal Unit CAS Channel Associated Signaling CCS Common Channel Signaling CIM Copper Interface Module CLASS Custom Local Access Signaling Services DASSII Digital Access Signaling System # DID / DDI Direct Inward Dial / Direct Dial In DNI Digital Network Interface DPNSS Digital Private Network Signaling System DSP Digital Signal Processor DTMF Dual Tone Multi-Frequency FIM Fiber Interface Module IP Internet Protocol ISDN Integrated Services Digital Network LS Loop Start Trunk MCD Mitel Communications Director MMC MITEL Mezzanine Card MOH Music on Hold MSDN NFAS NSU OPS PRI QSIG RSTP SIP STP T VM XNET Mitel Superswitch Digital Network Non-Facilities Associated Signaling Network Services Unit Off Premises, long loop analog PBX ports Primary Rate Interface, ISDN Q-Signaling Protocol Rapid Spanning Tree Protocol Session Initiation Protocol Spanning Tree Protocol ITU protocol to send FAX transmission across IP Networks Voice Mail Switched Networking Trunking Gateway A Controller used specifically to land PSTN trunks and route them onto a User Gateway User Gateway A Controller / Server used specifically to manage and control Telephones. External traffic is routed via a Trunking Gateway Controller Mitel s telephony platform that runs Mitel Communications Director (MCD) CONTROLLERS 7
Global Headquarters Tel: +1(61) 59-1 Fax: +1(61) 59-7 U.S. Tel: +1() 961-9 Fax: +1() 961-17 EMEA Tel: +()191- Fax: +()191- CALA Tel: +1(61) 59-1 Fax: +1(61) 59-75 Asia Pacific Tel: +61() 9 95 Fax: +61() 9 951 www.mitel.com For more information on our worldwide office locations, visit our website at www.mitel.com/offices THIS DOCUMENT IS PROVIDED TO YOU FOR INFORMATIONAL PURPOSES ONLY. The information furnished in this document, believed by Mitel to be accurate as of the date of its publication, is subject to change without notice. Mitel assumes no responsibility for any errors or omissions in this document and shall have no obligation to you as a result of having made this document available to you or based upon the information it contains. M MITEL (design) is a registered trademark of Mitel Networks Corporation. All other products and services are the registered trademarks of their respective holders. Copyright 11, Mitel Networks Corporation. All Rights Reserved. GD _911 PN 5171RO-EN