Illustrated Parts List Rear Tine Tiller Model Series 0 Thru Model Series 0 Shown IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forestcovered, brush-covered or grass-covered land unless the engine s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 6 Cleveland, Ohio 6-00. MTD LLC, P.O. BOX 6 CLEVELAND, OHIO 6-00 PRINTED IN U.S.A. FORM NO. 770-06C.fm (/0)
Model Series 0 5 6 7 8 0 5 6 8 6 7 8 0 0 0 5 5 6 7 6 8 0 5 7
Model Series 0 Part. 70-0 Tap Screw /- x.6. 786-0 Handle Cover w/o Throttle. 70-086 Hex Washer Screw /- x.6. 7-078A Foam Grip 5. 75-06 End Plug 6. 67-00 Clutch Control Assembly 7. 786-08 Return Bracket - LH 8. 786-008 Return Bracket - RH. 6-00 Handle Assembly 0. 7-0A Knob. 7-008 Jam Nut /8-6. 76-00 Cable Clip. 77-00 Shift Control. 75-07 Rubber Washer. ID x.87 OD 5. 7-00 Cotter Pin 6. 76-0 Flat Washer. ID x.6 OD. 7-00A Hex Flange Lock Nut 5/6-8 8. 78-0 Retainer Bracket. 7-07 Flange Lock Nut /8-. 750-0885A Spacer. ID x.6 OD. 78-00 Adjustable Crank Handle. 70-08 Hex Screw 5/6-8 x.0. 786-00 Handle Mounting Bracket - LH. 786-008 Handle Mounting Bracket - RH Part. 76-006 Cap Nut 6. 77-0 Rod 7. 786-0 Rear Tine Shield Flap 8. 70-005 Hex Cap Screw /8-6 x.. 76-0 Flat Washer.75 ID x.6 OD 0. 70-008 Hex Cap Screw 5/6-8 x.75. 78-08 Hex Screw 5/6-8 x.75. 786-0085 Tine Shield. 7-0 Wing Nut. 686-00A End Cover Assembly 5. 786-000 Side Shield 6. 786-0076 Shield Bracket RH 7. 70-076 Hex Cap Screw 5/6-8 x.0 8. 76-06 Lock Washer /8. 7-05 Clevis Pin 0. 7-078 Hex Nut /8-6. 70-08 Hex Cap Screw 5/6-8 x.875. 686-00A Shield Tine Bracket Assembly. 786-0 Depth Stake. 786-0077 Shield Bracket - LH 5. 70-07 Carriage Bolt /8-6 x.0 6. 7-07 Cotter Pin 7. 76-06 Clutch Cable NOTE: For painted parts, please refer to the list of color codes below. Please add the applicable color code, wherever needed, to the part number to order a replacement part. For instance, if a part numbered 700-xxxx is painted Oyster Gray, the part number to order would be 700-xxxx-066. Black 06; Black, Powder 067; Blue, Midnight 0667; Charcoal 08; Grey 068; Grey, Oyster 066; Orange 0606; Red 0650; Red, MTD 068; Silver 06; Yellow 067. 5
8 Model Series 5 6 7 8 0 5 6 8 8 6 0 5 5 6 7 0 5 6 7 8 50 5 5 5 5 55 7
Model Series Part. 70-0 Tap Screw /- x.6. 786-0 Handle Cover w/o Throttle. 76-06 Clutch Cable. 7-078A Foam Grip 5. 67-00 Clutch Control Assembly 6. 75-06 End Plug 7. 70-086 Hex Washer Screw /- x.6 8. 6-006 Handle Assembly. 786-08 Return Bracket - LH 0. 786-008 Return Bracket - RH. 7-0A Knob. 7-008 Jam Nut /8-6. 77-00 Shift Control. 77-00 Handle Adjustment Rod 5. 7-0 Cotter Pin 6. 7-086A Slotted Hex Nut 5/8. 76-0 Bell Washer.6 ID x. OD 8. 7-075 Hex Lock Nut /8-6. 76-00 Cable Clip. 7-0 Torsion Spring. 78-075 Handle Swing Link. 7-07 Flange Lock Nut /8-. 78-0 Retainer Bracket. 7-00A Hex Flange Lock Nut 5/6-8. 78-00 Adjustable Crank Handle 6. 70-05 Hex Cap Screw /8-6 x.0 7. 70-08 Hex Cap Screw 5/6-8 x.0 Part 8. 686-008 Handle Pivot Bracket Assembly. 70-07 Carriage Bolt /8-6 x.0 0. 686-007 Handle Bracket Assembly. 7-0 Wing Nut. 75-07 Rubber Washer. ID x.87 OD. 76-0 Flat Washer. ID x.6 OD. 7-00 Cotter Pin 5. 786-000 Side Shield 6. 70-005 Hex Cap Screw /8-6 x. 7. 76-0 Flat Washer.75 ID x.6 OD. 70-008 Hex Cap Screw 5/6-8 x.75 0. 78-08 Hex Screw 5/6-8 x.75. 786-0 Rear Tine Shield Flap. 786-0085 Tine Shield. 686-00A End Cover Assembly. 77-0 Rod 5. 76-006 Cap Nut 6. 786-0076 Shield Bracket RH 7. 786-0077 Shield Bracket - LH 8. 70-076 Hex Cap Screw 5/6-8 x.0. 7-07 Cotter Pin 50. 7-05 Clevis Pin 5. 686-00A Shield Tine Bracket Assembly 5. 70-08 Hex Cap Screw 5/6-8 x.875 5. 7-078 Hex Nut /8-6 5. 76-06 Lock Washer /8 55. 786-0 Depth Stake NOTE: For painted parts, please refer to the list of color codes below. Please add the applicable color code, wherever needed, to the part number to order a replacement part. For instance, if a part numbered 700-xxxx is painted Oyster Gray, the part number to order would be 700-xxxx-066. Black 06; Black, Powder 067; Blue, Midnight 0667; Charcoal 08; Grey 068; Grey, Oyster 066; Orange 0606; Red 0650; Red, MTD 068; Silver 06; Yellow 067.
Model Series 0 thru 8 0 5 6 7 7 8 0 6 6 5 7 6 8 5 0 8 6
Model Series 0 thru Part. 70-0 Hex Screw /- x.6. 786-00B Shift Cover. 686-005 Crank Shift Assembly. 7-00A Hex Lock Nut 5/6-8 5. 75-0 Spiral Pin 6. 786-0 Shift Cover Mounting Bracket 7. 70-008 Hex Cap Screw 5/6-8 x.75 8. 7-00 Hex Nut 5/6-8. 76-0 Bell Washer.0 ID x.87 OD 0. 70-80 Hex Cap Screw 5/6-8 x.75. 70-007 Hex Washer Screw /8-6 x.5. 6-000 Frame Counterweight. 6-005 Tine Assembly - LH 6-006 Tine Assembly - RH. 7-05 Clevis Pin 5. 7-0B Cotter Pin 6. 6-00 Complete Wheel Ass y - RH ( ) 6-0 Complete Wheel Ass y - LH ( ) 6-08 Complete Wheel Ass y - RH (6 ) 6-0 Complete Wheel Ass y - LH (6 ). 7-0 Clevis Pin 8. 7-00 Cotter Pin. 7-6 Tire Only ( ) 7-0808 Tire Only (6 ) Part. 7-00A Flange Lock Nut 5/6-8. 70-00 Flange Screw 5/6-8 x.. 686-00A Belt Keeper Bracket Ass y. 76-0 Lock Washer 5/6. 70-07 Hex Cap Screw 5/6- x.6. 756-07 Inner Pulley Half 6. 756-07 Outer Pulley Half 7. 75-08 V-Belt 8. 756-005 Flat Idler. 78-08 Bolt 5/6-8 x /-8 x.5 0. 76-06 Flat Washer.65 ID x.0 OD. 756-06 Flat Pulley. 76-005 Spring Washer.0 ID x.870 OD. 7-07 Flange Lock Nut /8-. 76-05 Bell Washer.6 ID x.0 OD 5. 70-05 Hex Cap Screw /8- x.0 6. 786-0080 Idler Bracket 7. 70-07 Hex Cap Screw /8-6 x. 8. 78-0876 Shoulder Nut 7/6-. 76-0 Flat Washer.7 ID x.60 OD 0. 786-000 Belt Cover. 7-0 Hex Lock Nut /. 786-007 Cable Bracket. 686-00 Gear Case Assembly IMPORTANT: For a proper working machine, use Factory Approved Parts. V-BELTS are specially designed to engage and disengage safely. A substitute (non OEM) V-Belt can be dangerous by not disengaging completely.
Model Series 0 thru 5 6 5 6 8 0 7 7 8 0 0 5 6 7 5 6 50 5 5 5 5 8 6 5 0 8 7
Model Series 0 thru Part. 7-078 Shaft Seal.0 Dia. 7-078 Hex Nut 7/6-. 76-007 Bell Washer.5 ID x.0 OD. 7-07 Shaft Seal.75 Dia 5. 76-0865 Snap Ring.50 Dia 6. 686-008 Gear Case Assembly - RH Half 7. 68-05B Shift Assembly. 7-0 Chain - # / Pitch x 0 Links 0. 750-0570 Space.0 ID x.0 OD. 76-06 Thrust Washer.0 ID x.6 OD. 750-06 Spacer.65 ID x.0 OD. 76-058 Thrust Washer.5 ID x. OD. 6-000 Idler Gear Assembly 5. 76-05 Flat Washer.760 ID x.50 OD 6. 750-08 Spacer.75 ID x.886 OD. 7-58 Spur Gear 6T. 6-00 Tine Shaft Assembly 8T. 7-06 Chain - #50 5/8 Pitch x 5 Links. 78-0885 Jack Shaft 5/8 Dia. X..06 Lg. 750-05 Spacer.65 ID x.0 OD. 6-0058 Wheel Shift Assembly. 686-00 Gear Case Assembly - LH Half. 70-086 Hex Washer Screw /- x.6 6. 76-0 Plug 7. 7-056 Ball Bearing w/snap Ring 8. 7-067 Hex Patch L-Nut 7/6- Part. 786-0086 Reinforcement Bracket 0. 7-05 Chain Case Gasket. 70-08 Hex Cap Screw /- x.6. 76-0 Lock Washer /. 76-05 Flat Washer.8 ID x.875 OD. 7-0 Ball Bearing 5. 76-05 Flat Washer 6. 7-5A Spur Gear 6T 7. 7-05 Sprocket T # Chain 8. 76-065 Flat Washer.88 ID x.50 OD. 76-05 Retainer Ring 0. 78-07 Clutch Key. 7-087 Drive Shaft. 7-086 Compression Spring. 7-086 Detent Ball. 78-0 Clutch Collar 5. 7-0 Spur Gear T 6. 76-0 Flat Washer.6 ID x.06 OD 7. 7-06 Wire Ring 8. 76-058 Thrust Washer.5 ID x. OD. 6-006 Intermediate Gear Assembly 50. 78-088 Jack Shaft 5. 76-06 Flat Washer.6 ID x.0 OD 5. 750-0 Spacer.65 ID x.86 OD 5. 6-000 Tine Drive Assembly