Specifications MPS 602 Video VGA Inputs Gain... Unity Bandwidth... 350 MHz (-3 db) Crosstalk... -50 db @ 10 MHz, -30 db @ 100 MHz Switching speed... <5 ms (max.) HDMI and DTP Maximum data rate... 6.75 Gbps (2.25 Gbps per color) Maximum pixel clock... 165 MHz Resolution... 1920x1200 @ 60 Hz or 1080p @ 60 Hz, 12 bit color and 2K Formats... RGB and YCbCr digital video Standards... DVI 1.0, HDMI, HDCP 1.1, CEA-861E Video input VGA inputs... 2 VGA-QXGA RGBHV, RGBS HDMI inputs... 3 HDMI (or single link DVI-D, with appropriate DVI-HDMI adapters) DTP inputs... 1 DTP 230 input Connectors VGA inputs... 2 female 15-pin HD HDMI inputs... 3 female HDMI, type A DTP input... 1 RJ-45 jack Nominal level VGA inputs... 0.7 Vp-p for RGB Minimum/maximum levels VGA inputs... Analog 0.3 V to 1.5 Vp-p with no offset Impedance... 75 ohms Horizontal frequency... 15 khz to 145 khz Vertical frequency... 30 Hz to 170 Hz Return loss... <-40 db @ 5 MHz Video output Local VGA output... 1 VGA-QXGA, RGBHV, RGBS HDMI output... 1 HDMI (or single link DVI-D) DTP output... 1 DTP 230 output DTP Signal Transmission Distance... up to 230' (70 m) using CAT 5e/6/6a/7 cable or XTP DTP 24 TP cable Cable Requirements... Solid conductor, 24 AWG or better Cable Recommendations... 400 MHz bandwidth, STP (shielded twisted pair) NOTE: Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for optimal performance. Connectors Local VGA output... 1 female 15-pin HD HDMI outputs... 1 female HDMI type A DTP output... 1 RJ-45 jack NOTE: Outputs are selectable from either the HDMI output or DTP output. The switcher does not output to both connectors simultaneously. Analog RGB inputs are digitized for output from either the HDMI or DTP output. Extron MPS 602 Media Presentation Switcher Specifications 1
Nominal levels VGA output... 0.7 Vp-p for RGB Minimum/maximum levels VGA output... Analog, 0.3 V to 1.5 Vp-p Impedance... 75 ohms Return loss (VGA output)... <-40 db @ 5 MHz DC offset... ±5 mv with input at 0 offset (max. allowable, VGA output) Sync (VGA Only) Input type... RGBHV, RGBS Local output type... RGBHV, RGBS Input level... 1.9 V to 5.0 Vp-p Output level... TTL: 5.0 Vp-p (unterminated) for RGBHV, RGBS Input impedance... 510 ohms Output impedance... 75 ohms Max. input voltage... 5.0 Vp-p Max. propagation delay... 30 ns Max. rise/fall time... 4.2 ns Polarity... Positive or negative (follows input) Analog Audio individual audio groups (VGA, HDMI) Gain... Unbalanced output: 0 db; balanced output: +6 db Frequency response... 20 Hz to 20 khz, ±0.5 db THD + Noise MPS 602... 0.01% @ 1 khz at nominal level MPS 602 SA/MA... <0.1% @ 1 khz 3 db below clipping S/N MPS 602... >90 db at maximum output (unweighted) MPS 602 SA/MA... >90 db, 20 Hz to 20 khz, unweighted Crosstalk... <-72 db @ 1 khz or below, <-45 db @ 20 khz Stereo channel separation... >80 db @ 20 Hz to 20 khz CMRR... >75 db @ 20 Hz to 20 khz Audio input (VGA and HDMI video) VGA inputs... 2 stereo, unbalanced/balanced HDMI inputs... 3 stereo, unbalanced/balanced, or 3 embedded digital audio from HDMI DTP inputs... 1 stereo, unbalanced/balanced analog, 1 embedded digital audio from DTP Embedded digital audio source formats... 2-ch PCM Connectors... (5) 3.5 mm, 5-pole captive screw connector VGA inputs... (2) 3.5 mm, 5-pole captive screw connector HDMI inputs... (3) 3.5 mm, 5-pole captive screw connector (3) female HDMI type A DTP inputs... (1) female RJ-45 connector Input Impedance... >10k ohms unbalanced, 20k ohms balanced Nominal level... +4 dbu, -10 dbv configurable Maximum level... +21 dbu, balanced, +15 dbu unbalanced CMRR... >60 db typical @ 1 khz Input gain adjustment... -18 db to +24 db, adjustable per input NOTE: 0 dbu = 0.775 Vrms, 0 dbv = 1 Vrms, 0 dbv 2 dbu Extron MPS 602 Media Presentation Switcher Specifications 2
Audio output... (2) stereo, balanced or unbalanced (variable and fixed outputs) (1) DTP 230 analog audio and 1 embedded digital audio on DTP signal (1) embedded digital audio on HDMI Connectors... (2) 3.5 mm captive screw connector, 5-pole (1) RJ-45 (1) Female HDMI type-a Impedance... 50 ohms unbalanced, 100 ohms balanced Gain error... ±0.5 db channel to channel Maximum level (Hi-Z)... >+16.5 dbu balanced, >+8.2 dbv unbalanced at 1% THD+N Talk-over (ducking) response time (typical) Attack time... instant Release delay... 5 seconds Release time... 1 second Ducking level... 0 db to 30 db, adjustable (default: +6 db) Audio output power amplifier MPS 602 SA... 1 stereo (default) or 2 mono, 2 channels total MPS 602 MA... 1 mono, 70 V line Connector MPS 602 SA... (1) 5 mm screw lock captive screw connector, 4-pole MPS 602 MA... (1) 5 mm screw lock captive screw connector, 2-pole Load Impedance MPS 602 SA... 4 ohms minimum MPS 602 MA... 50 ohms minimum Output Power MPS 602 SA... 25 watts per channel, 8 ohms, 1 khz, 0.1% THD 50 watts per channel, 4 ohms, 1 khz, 0.1% THD MPS 602 MA... 100 watts 70V, 1 khz, 0.1% THD THD + Noise... 0.1% @ 1 khz, 3 db below clipping Amplifier type... Class D Microphone/line input... 1 mono balanced or unbalanced Connector... (1) 3.5 mm captive screw connector Impedance... 10k ohms unbalanced, 20k ohms balanced Nominal level... -60 dbv (1 mv), +4 dbu, -10 dbv, adjustable Equivalent input noise... <-117 dbv (1.4 uvrms) when gain is set to 40 db Maximum level... +12 dbv (2 Vrms) when gain is set to 0 db CMRR... >60 db typical @ 1 khz Input gain adjustment... -18 db to +60 db, 1 db steps, adjustable per input Microphone volume range... -66 db to +12 db Microphone DC power... +48 VDC +10% (can be turned on or off) NOTE: Mic/Line audio is not embedded on DTP analog audio output, or digital embedded audio. Control/remote switcher Serial control port... 1 RS-232, 3.5 mm captive screw connector, 3-pole, rear panel Baud rate and protocol... 9600 baud, 8 data bits, 1 stop bit, no parity Serial control pin configuration... 2 = Tx, 3 = Rx, 5 = GND USB control ports... 1 front panel female mini USB, type B USB standards... USB 2.0, high speed Program control... Extron Simple Instruction Set (SIS ) Extron MPS 602 Media Presentation Switcher Specifications 3
Control/remote external device (RS-232/IR over DTP) NOTE: Protocol is mirrored between the connected DTP 230 endpoints and the "Over DTP" input and output ports. Signals from a control device pass into each "Over DTP" port, are embedded with the DTP signal, and sent to individual DTP 230 Tx or Rx endpoints for control of remote sink or source devices. The "Over DTP" ports are pass-through connections to DTP endpoints. There is no RS-232 or IR insertion from the MPS 602 control ports to the "Over DTP" ports. Quantity/type... (2) RS-232 and IR via (2) 3.5 mm 5-pole captive screw connectors Serial control pass-through ports... (2) bidirectional RS-232 MPS 602 input/dtp Tx... (1) RS-232 (1) 3.5 mm 5-pole captive screw connector (shared with IR port) MPS 602 output/dtp Rx... (1) RS-232 (1) 3.5 mm 5-pole captive screw connector (shared with IR port) Baud rate... 300 to 38400 baud Protocol... 8 or 7 data bits 1 or 2 stop bits no parity (default), even or odd parity Serial control pin configuration... 1 = Tx, 2 = Rx, 3 = GND IR control pass-through ports... (2) bidirectional TTL level (0 to 5 V) modulated infrared control from 30 khz up to 60 khz MPS 602 input/dtp Tx... (1) RS-232 (1) 3.5 mm 5-pole captive screw connector (shared with RS-232 port) MPS 602 output/dtp Rx... (1) RS-232 (1) 3.5 mm 5-pole captive screw connector (shared with RS-232 port) IR control pin configuration... 3 = GND, 4 = IR Tx, 5 = IR Rx General Power supply... Internal Input: 100-240 VAC, 50-60 Hz Power consumption MPS 602, full load... 22 W MPS 602 SA, full load, amp at 1/8 power... 44 W MPS 602 MA, full load, amp at 1/8 power... 44 W Remote power capability... Supports up to two endpoints (one DTP Tx, one DTP Rx) Temperature/humidity... Storage -40 to +158 F (-40 to +70 C) / 10% to 90%, noncondensing Operating +32 to +122 F (0 to +50 C) / 10% to 90%, noncondensing Cooling... Convection, no vents Thermal dissipation MPS 602, full load... 69 BTU/hr MPS 602 SA, full load, amp at 1/8 power... 102 BTU/hr MPS 602 MA, full load, amp at 1/8 power... 102 BTU/hr Extron MPS 602 Media Presentation Switcher Specifications 4
Mounting Rack mount... Yes, with included brackets Enclosure type... Metal Enclosure dimensions... 1.75" H x 17.4" W x 8.5" D (1U high, full rack wide) 4.4 cm H x 43.2 cm W x 21.6 cm D (Depth excludes connectors and knobs. Width excludes rack ears.) Product weight... 7.0 lbs (3.2 kg) Shipping weight... 10 lbs (5 kg) Vibration... ISTA 1A in carton (International Safe Transit Association) Regulatory compliance Safety... CE, c-ul, UL EMI/EMC... CE, C-tick, FCC Class A, VCCI, ICES Environmental... Complies with the appropriate requirements of RoHS, WEEE Warranty... 3 years parts and labor NOTE: All nominal levels are at ±10%. NOTE: Specifications are subject to change without notice. 8.0-062813-D3 Extron MPS 602 Media Presentation Switcher Specifications 5