HEC100RTA48QSCA Rev A1.0 A. Features High Efficiency (Up to 90%). Active Power Factor Correction (Typical 0.96). Isolation Class I (With FG) AllRound Protection: OVP/SCP/OTP/OPP. Fully isolated Metal case with IP67 and damp/ wet location. 110V, PWM, and resistance dimming function. B. Description The HEC100RTA48QSCA Series operate from a 90 ~ 305Vac input range. They are designed to be highly efficient and highly reliable. Features include over voltage protection, short circuit protection, and over temperature protection. C. Models Input Voltage Range Output Voltage Range Note 1 Note 4 90 ~ 305Vac 2848V Output Current 2100mA Max. Output Power Efficiency Power Factor Note 2 Note 2 100 W 90% 0.96 Model Number HEC100RTA48QSCA D. Electronic Specifications Input Specifications Parameter Min. Typ. Max. Input Voltage (V) 90 305 Input Frequency (Hz) 47 Notes 63 1.5 Measured at full load and 100Vac input. 0.5 Measured at full load and 277Vac input. Leakage Current (ma) 0.7 At 277Vac 60Hz input. Inrush Current (A) 40 0.16 A2s At 220Vac input 25 C Cold Start. Duration=100µs, 10%Ipk10%Ipk. 0.9 20 25 Input AC Current (A) Inrush Current (I2t) Power Factor At 277Vac input, full load. THD (%) http://www.hecgroup.com.tw/ service@hecgroup.com.tw TEL:+88663560606 FAX:+88663560505 1
Output Specifications HEC100RTA48QSCA Rev A1.0 Output Current (ma) Io = 2100 ma 1995 2205 No Load Output Voltage (V) Io = 2100 ma Output Ripple Voltage (V) 63 1% Vo max Output Voltage Overshoot (%) 110 At full load condition. Line Regulation (%) ±3 Load Regulation (%) ±5 Turnon Delay Time (s) 0.5 1.0 Measured at 220Vac input. There will be no damage or hazardous conditions occurred with no loading. Measured by 20 MHz bandwidth oscilloscopes and the output paralleled a 0.1uF ceramic capacitor and a 10uF electrolytic capacitor. General Specifications Efficiency (%) Io = 2100 ma Efficiency (%) Io = 2100 ma MTBF (hours) 320,000 Life Time (hours) 100,000 Case Temperature ( C) 85 Dimensions Millimeters(L W H) 70*ψ130 88 90 Measured at full load and 120Vac input. Measured at full load and 277Vac input. Measured at full load 50 C ambient temperature (MILHDBK217F). Measured at rated input voltage with full load, Case temperature=60 C @ Tc point.see life time vs. Tc curve for the details. Protection Functions Over Voltage Protection 1.50 Vomax In the event of an overvoltage condition, the LED Drives shall Shut down o/p voltage, repower on to recover. Over Temperature Protection Short Circuit Protection Shut down o/p voltage with repower on to recovery. No damage shall occur when any output operating in a short circuit condition. The power supply shall be selfrecovery when the fault condition is removed. http://www.hecgroup.com.tw/ service@hecgroup.com.tw TEL:+88663560606 FAX:+88663560505 2
HEC100RTA48QSCA Rev A1.0 Environmental Specifications Operating Temperature ( C) 40 +70 Humidity: 20% RH to 80% RH; See Derating Curve for more details. Storage Temperature ( C) 40 +80 Humidity: 10% RH to 90% RH. Safety and EMC Compliance Safety Category Standard UL/CUL UL8750, UL 1012, CSA C22.2 No. 107.1 CE EMI Standards EN 55015 EN 6100032 EN 6100033 FCC Part 15 EMS Standards EN 6100042 EN 6100043 EN 613471, EN61347213. Notes Conducted emission Test & Radiated emission Test. Harmonic current emissions. Voltage fluctuations & flicker. FCC 47 CFR Part 15 Subpart B, ICES003 Issue 4 ANSI C63.42003 Notes Electrostatic Discharge (ESD): 8 KV air discharge, 4 KV contact discharge. RadioFrequency Electromagnetic Field Susceptibility TestRS. EN 6100044 Electrical Fast Transient / BurstEFT: Level 2, Criteria A. EN 6100045 EN 6100046 EN 6100048 EN 61000411 EN 61547 Surge Immunity Test: AC Power Line: line to line 2 KV. line to group 4 KV. Conducted Radio Frequency Disturbances TestCS. Power Frequency Magnetic Field Test. Voltage Dips. Electromagnetic Immunity Requirements Applies To Lighting Equipment. Notes: 1. Normal input voltage range 100~277Vac. 2. Measured at input 220V with a full load. 3. All specifications are typical at 25 C unless otherwise stated. 4. Constant current operation region is preferably 50%~100% rated output voltage. This is the suitable operation region for LED related applications, but please reconfirm special electrical requirements for some specific system design. 5. Derating may be needed under low input voltages. Please check the static curve for more details. 6. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must requalify EMC Directive on the complete installation again http://www.hecgroup.com.tw/ service@hecgroup.com.tw TEL:+88663560606 FAX:+88663560505 3
HEC100RTA48QSCA Rev A1.0 E. Dimming Control The dimmer control is operated from an input signal (DC voltage / PWM signal / Variable Resistor). Please refer to the diagram. Notes: 1. If the dimming pin is not used, Dimming pin can be open. 110V Dimming Voltage (V) 1 + 10.8 PWM Signal 5 10 + 10.8 0~10KΩVariable Resistor (Ω) 0 +10K http://www.hecgroup.com.tw/ service@hecgroup.com.tw TEL:+88663560606 FAX:+88663560505 4
HEC100RTA48QSCA Rev A1.0 DC Voltage Dimming Curve PWM Signal Dimming Curve Variable Resistor Curve http://www.hecgroup.com.tw/ service@hecgroup.com.tw TEL:+88663560606 FAX:+88663560505 5
HEC100RTA48QSCA Rev A1.0 F. Electronic Curve Derating Curve Static Curve Power Factor Characteristics Curve Efficiency Characteristics Curve http://www.hecgroup.com.tw/ service@hecgroup.com.tw TEL:+88663560606 FAX:+88663560505 6
HEC100RTA48QSCA Rev A1.0 Life Time vs. Case Temperature Curve G. Mechanical Outline http://www.hecgroup.com.tw/ service@hecgroup.com.tw TEL:+88663560606 FAX:+88663560505 7
HEC100RTA48QSCA Rev A1.0 H. RoHS Compliance Outline Our products comply with the European Directive 2011/65/EU, calling for the elimination of lead and other hazardous substances from electronic products. I. Revision History Change Date Rev. Description of Change Item From To 20141208 A1.0 Revised Static Curve / / http://www.hecgroup.com.tw/ service@hecgroup.com.tw TEL:+88663560606 FAX:+88663560505 8