Lighting Sciences, Inc. Color and Photometric Testing, According to IESNA LM 79 Standards and Procedures, Test Report Files for: Par 30, 9W, DWF, Dimmable, 120V, Glass (SKU #180064) Seesmart 4139 Guardian Street Simi Valley, CA 93063 Tel: 877.578.2536 Fax: 888.239.0959 Web: www.seesmartled.com
Lighting Sciences www.lightingsciences.com Lighting Sciences Inc. 7826 E. Evans Road Scottsdale, Arizona 85260 USA Tel: 480-991-9260 Fax: 480-991-0375 INTENSITY(CANDLEPOWER) SUMMARY ANGLE MEAN CP LMS. ANGLE MEAN CP LMS. 0 232 90 5 5 230 22 95 4 4 10 225 100 3 15 219 61 105 2 2 20 209 110 1 25 198 91 115 1 1 30 184 120 0 35 166 103 125 0 0 40 145 130 0 45 122 94 135 0 0 50 99 140 0 55 77 69 145 0 0 60 57 150 0 65 40 40 155 0 0 70 28 160 0 75 18 20 165 0 0 80 12 170 0 85 8 9 175 0 0 90 5 180 0 ZONAL LUMENS AND PERCENTAGES ZONE LUMENS % LUMINAIRE 0-30 174 33.76 0-40 278 53.71 0-60 440 85.23 0-90 510 98.64 40-90 232 44.92 60-90 69 13.41 90-180 7 1.36 0-180 517 100.00 EFFICACY (LUMENS PER WATT): 53.8 *** THIS IS AN ABSOLUTE TEST *** S/MH: 1.2 SC: 1.2 CERTIFIED BY: PREPARED FOR: SEESMART LED SIMI VALLEY, CA DATE: SEP 30, 2010 TESTED IN ACCORDANCE WITH IES PROCEDURES.
INTENSITY(CANDLEPOWER) DATA ANGLE INTENSITY LUMENS (CANDLEPOWER) 0 232 5 230 22 10 225 15 219 61 20 209 25 198 91 30 184 35 166 103 40 145 45 122 94 50 99 55 77 69 60 57 65 40 40 70 28 75 18 20 80 12 85 8 9 90 5 95 4 4 100 3 105 2 2 110 1 115 1 1 120 0 125 0 0 130 0 135 0 0 140 0 145 0 0 150 0 155 0 0 160 0 165 0 0 170 0 175 0 0 180 0
COEFFICIENTS OF UTILIZATION ZONAL CAVITY METHOD EFFECTIVE FLOOR CAVITY REFLECTANCE =.20 CC 90 80 70 50 30 10 0 WALL 70 50 30 10 70 50 30 10 70 50 30 10 50 30 10 50 30 10 50 30 10 0 RCR 0 1.221.221.221.22 1.191.191.191.19 1.161.161.161.16 1.101.101.10 1.051.051.05 1.011.011.01 0.99 1 1.131.081.051.01 1.101.061.030.99 1.071.041.010.97 0.990.970.94 0.950.930.91 0.920.900.88 0.86 2 1.040.970.910.85 1.020.950.890.84 0.990.930.880.83 0.890.850.81 0.860.820.79 0.830.800.77 0.75 3 0.970.870.790.73 0.940.850.780.73 0.920.840.770.72 0.810.750.71 0.780.730.69 0.750.710.68 0.66 4 0.890.780.700.64 0.870.770.690.63 0.850.750.690.63 0.730.670.62 0.700.650.61 0.680.640.60 0.58 5 0.830.700.620.55 0.800.690.610.55 0.780.680.600.54 0.650.590.54 0.630.580.53 0.620.570.52 0.51 6 0.770.630.550.49 0.750.620.540.48 0.730.610.540.48 0.590.530.48 0.580.520.47 0.560.510.46 0.45 7 0.700.570.490.43 0.690.560.480.43 0.670.560.480.42 0.540.470.42 0.520.460.42 0.510.460.41 0.39 8 0.650.520.430.38 0.640.510.430.37 0.620.500.430.37 0.490.420.37 0.470.410.37 0.460.410.36 0.34 9 0.600.470.380.33 0.590.460.380.33 0.570.450.380.33 0.440.370.32 0.430.370.32 0.420.360.32 0.30 10 0.560.430.340.29 0.550.420.340.29 0.530.410.340.29 0.400.330.29 0.390.330.28 0.380.320.28 0.27 THE ABOVE COEFFICIENTS HAVE BEEN CALCULATED BASED ON LUMINAIRE LUMENS BECAUSE IN AN ABSOLUTE TEST THE BARE LAMP LUMENS ARE UNKNOWN. LIGHTING DESIGN CALCULATIONS MADE USING THESE COEFFICIENTS SHOULD THEREFORE USE THE LUMINAIRE LUMENS IN THE CALCULATION FORMULA LUMINAIRE INPUT WATTS 9.6 LABORATORY RESULTS MAY NOT BE REPRESENTATIVE OF FIELD PERFORMANCE. BALLAST AND FIELD FACTORS HAVE NOT BEEN APPLIED. TEST DISTANCE EXCEEDS FIVE TIMES THE GREATEST LUMINOUS OPENING OF LUMINAIRE.
ELECTRICAL MEASUREMENTS INPUT VOLTAGE: 120.0 VOLTS AC INPUT CURRENT: 0.082 AMPS INPUT POWER: 9.6 WATTS POWER FACTOR: 97.6 PERCENT TOTAL HARMONIC DISTORTION: 15.00 PERCENT OFF STATE POWER: 0.00 WATTS LIGHT OUTPUT LUMENS: EFFICACY: 517 lm 53.8 lm/w SPECTRAL MEASUREMENTS X: 0.3050 y: 0.3145 u/u': 0.1979 v: 0.3061 v': 0.4592 Duv: 0.0003 CRI(R a ): 79.9 CRI(R 9 ): 6.1 CCT: 7108 K RADIANT FLUX: 1758 mw
SIDE VIEW BOTTOM VIEW All testing was conducted in accordance with LM-79-08, Approved Method: Electrical and Photometric Measurements of Solid-State Lighting Products as published by the Illuminating Engineering Society of North America (IESNA). The condition of the item tested was new. Stabilization time before testing exceeded 16 hours. The test results (luminous distribution and flux) were obtained by using a Lighting Sciences series 6000 Type C Moving Mirror Goniophotometer The photometric reference standard used is a set of three incandescent luminous intensity standard lamps calibrated and traceable to the U.S. National Institute of Standards and Technology. The test results (colorimetric and luminous flux) were obtained by using a Lighting Sciences model 4000 Integrating Sphere of either 1 or 2 meters diameter, having an internal reflectance exceeding 0.80. 4π geometry was used. Correction factors were applied for spectral mismatch and selfabsorption. The spectroradiometer employed was a LSC model 500E having a bandwidth of.84. The photometric reference standard used is a set of three incandescent luminous flux standard lamps calibrated and traceable to the U.S. National Institute of Standards and Technology. The colorimetric reference standard used is an incandescent spectral standard lamp calibrated and traceable to the U.S. National Institute of Standards and Technology. Power measurements were obtained with a Yokogawa WT210 power analyzer. Ambient temperature during testing was 25 C ± 1 C, measured using an Omega model DP460. Calibration certificates are on file at the laboratories of Lighting Sciences Inc.