Pattern #1 High Neck Peplum Pullover Photo on page 48 and 49, instructions begin on page 80. Updated: 31Jan2013 1. The stitch key for chart 2 was omitted. 2. SLEEVES With smaller needles, cast on 60 sts using tubular cast-on method. Change to larger needles. Set up row (RS) [P2, k1] 4 times, [p2, work row 1 of chart 1 over 6 sts, p3, work row 1 of chart 1 over 6 sts ] twice, [p2, k1] 4 times, p2. Row 2 K2, [p1, k2] 4 times, [work row 2 of chart 1, k3, work row 2 of chart 1, k2] twice, [p1, k2] 4 times. Cont in this way, working 4-row trim rep of chart 1 only until piece measures 2½"/6.5cm from beg. Beg chart 2 Note The full 14-row rep of chart 1 will now be worked. Work chart 2 for sleeve as foll: work rows 37 74, then rows 3 74, then row 3 to end. Set-up row (RS) P14, work chart 1 over 6 sts, p1, work row 37 of chart 2 over 18 sts, p1, work chart 1 over 6 sts, p14. Next row (WS) K14, work in chart pats as established over center 34 sts, k14. Cont as directed to final bind off: Bind off rem 32 (32, 30, 30) sts. Pattern #4 Cabled Peplum Pullover Photo on page 52, instructions begin on page 83. 1 / 8
Updated: 14Mar2013 1. A corrected stitch key has been published. 2. In Chart 4 Row 2 (WS) should be P2. (The M should be deleted) Corrections to the peplum begin after Beg charts with the 4th dec row (chart row 15) and are un derlined. Next (dec) row (RS) Rib to marker, sm, work row 15 of chart 1, rib 2, p2tog, *rib 5, p2tog; rep from * once more, rib to chart 2 sts, work row 15 of chart 2, rib 6, p2tog; **rib 5, p2tog, rep from ** once more, work to end 6 sts dec d. Work 3 rows in pat. Next (dec) row (RS) Rib to marker, sm, work row 19 of chart 1, k1, p2tog, [rib 4, p2tog] twice, rib to chart 2 sts, work row 19 of chart 2, rib 3, p2tog, [rib 4, p2tog] twice, work to end 6 sts dec d. Work 3 rows in pat. Beg chart 4 Next (dec) row (RS) Rib to marker, sm, work row 23 of chart 1, p2tog, k1, p1, p2tog, rib 3, p2tog, k1tbl, M1, k1tbl for twist-st column, work row 1 of chart 4, p1, work row 23 of chart 2, p1, work row 1 of chart 4, k1tbl, M1, k1tbl for twist-st column, p2tog, rib 3, p2tog, rib 2, p2tog, k0, work row 23 of chart 3, rib to end 6 sts dec d. Work in pats for 3 rows more, working sts in twist-st column on WS as p1tbl, k1, p1tbl, and on RS row as k1tbl, k1, k1tbl. Next (dec) row (RS) Rib to marker, sm, work row 27 of chart 1, p1, k1, p2tog, k2, p2tog, work twist-st column, work row 5 of chart 4, work row 27 of chart 2, work row 5 of chart 4, work twist-st column, p2tog, k2, p2tog, k1, p1, k2, work row 27 of chart 3, rib to end 4 sts dec d. Work in chart and rib pats as established until piece measures 16"/40.5cm from beg, end with a WS row 107 (113, 119, 131) sts. 2 / 8
Pattern #6 Empire Peplum Cardi Photo on page 54, instructions begin on page 86. Updated: 24Aug2015 1. Beg increase segment chart Row 1 (WS) Rib 5 sts, place marker (pm), p1, [p11, pm] 9 (10, 10, 11) times, rib 5 sts. Row 3 (WS) Rib 5 sts, sl marker, p1, [work row 3 of chart] 9 (10, 10, 11) times, rib 5. 2. The directions for the 2-st RC should read as follows: K2tog and leave these 2 sts on LH needle, then k the first st again and sl both sts from needle. 3. Under Skirt, after row 17, work 1 row even in St st, then work 1 additional bobble row as foll: Row 19 (RS) Rib 5 sts, *MB, k5; rep from * to last 6 sts, MB, rib 5 sts. Cont as written. Pattern #7 Diamond Peplum Pullover Photo on page 55, instructions begin on page 87. Updated: 02Jul2013 3 / 8
BACK Armhole shaping Bind off 3 (4, 5, 6, 9) sts at beg of next 2 rows. Next (dec) row (RS) K3, ssk, knit to last 5 sts, k2tog, k3 80 (90, 100, 106, 112) sts. Pattern #11 Cable Panel Dress Photo on page 58, instructions begin on page 89. Updated: 12Dec2012 3-st LPC Sl 2 sts to cn and hold to front, p1, k2 from cn. Pattern #15 Cape Pullover Photo on page 62, instructions begin on page 93. Updated: 27Mar2013 Lower back trim 4 / 8
With circular needle and B, beg at lower marker, pick up and k 19 sts cont as written. Pattern #16 Cable Panel Poncho Photo on page 63, instructions begin on page 94. Updated: 15Feb2013 Lower edging With RS facing, longer circular needle and CC, pick up and k 114 sts along lower edge of back. Purl 1 row. Row 1 (RS) Knit. Row 2 (WS) Purl. Row 3 (RS) Purl. Row 4 (WS) Knit. Row 5 (RS) Purl. Rep rows 2 5 once more, then rep rows 2 and 3. Bind off. Rep for lower edge of front. Sew side seams of edging. Pattern #21 Textured Pullover Photo on page 68, instructions begin on page 97. Updated: 22Apr2013 The instructions for completing the right sleeve were inadvertently omitted. After you decrease to 26 (28, 30) sts. Work even in St st for 3 /7.5cm. Bind off. 5 / 8
Pattern #22 Textured Cardigan Photo on page 69, instructions begin on page 99. Updated: 08Nov2013 1. Corrections to Charts 1 and 2 have been posted. [PDF 26KB] 2. Corrections are underlined. Center Cable Panel Row 5 Rep row 1. Beg charts Next row (RS) K1 work to end of chart, k1. Pattern #25 Socks Photo on page 58, instructions begin on page 89. Updated: 13Dec2012 Rnd 11 (inc) * Rib 6 sts, LIR, LIL, p1, work to marker; rep from * once more 76 sts. 6 / 8
Pattern #26, Cabled Toque Photo on page 71, instructions begin on page 102. Updated: 02Jan2013 5-st RC dec 1 Sl 2 sts to cn, hold to back, k2, k1 from cn, ssk 1 st from cn with next st 1 st dec d. Pattern #27, Cabled Helmet Hat Photo on page 72, instructions begin on page 103. Updated: 27Feb2015 For the earflap, the first inc row should read as foll: Next (inc) row (RS) K2, M1, pm, k2, pm, M1, k2 8 sts. Beg Cable Pat in Rows Next row (WS) K3, sm, work row 2 of cable pat in rows, sm, k3. Pattern #28, Leg Warmers Photo on page 73, instructions begin on page 103. Updated: 31Jan2013 7 / 8
After casting on: Next rnd *K2, p1; rep from * around. Rep this rnd 9 times more for k2, p1 rib. Beg foot and heel Rnd 1 [K2, p1] twice, 4-st RC dec, [p4, 4-st RC dec] twice, p1, [k2, p1] twice, work chart pat, p1 48 sts. Pattern #35 Cabled Cardigan Photo on page 78, instructions begin on page 109. Updated: 22Jan2013 A corrected chart has been published. [PDF 38KB] 8 / 8