UNISONIC TECHNOLOGIES CO., LTD DESCRIPTION Glass passivated, sensitive gate triacs in a full pack plastic envelope, intended for use in general purpose bidirectional switching and phase control applications, where high sensitivity is required in all four quadrants. SYMBOL ORDERING INFORMATION Ordering Number Pin Description Package Lead Free Halogen Free 1 2 3 Packing L-x-TF3-R G-x-TF3-R TO-22F MT1 MT2 G Tube Note: Pin Assignment: G: Gate MARKING 1 of 6 Copyright 215 Unisonic Technologies Co., Ltd
ABSOLUTE MAXIMUM RATING PARAMETER SYMBOL RATINGS UNIT -5 5(Note2) Repetitive Peak Off-State Voltages -6 V DRM 6(Note2) V -8 8 RMS On-state Current Full sine wave, T HS 92 C I T(RMS) 12 A Non-Repetitive Peak. On-State Current t =2 ms 9 Full sine wave, T J =125 C prior to surge, with I TSM A reapplied V DRM(MAX) t =16.7 ms I 2 t For Fusing (t = ms) I 2 t 4 A 2 s T2 + G+ 5 Repetitive Rate of Rise of On-state Current T2 + G- 5 after Triggering di T /dt T2 - G- 5 I TM =12 A, I G =.2 A, di G /dt=.2a/µs T2 - G+ A/µs Peak Gate Voltage V GM 5 V Peak Gate Current I GM 2 A Peak Gate Power P GM 5 W Average Gate Power (Over any 2ms period) P G(AV).5 W Operating Junction Temperature T J 125 C Storage Temperature T STG -4 ~ +15 C Notes: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 2. Although not recommended, off-state voltages up to 8V may be applied without damage, but the triac may switch to the on-state. The rate of rise of current should not exceed 15A/µs. THERMAL RESISTANCES PARAMETER SYMBOL MIN TYP MAX UNIT Thermal resistance Junction to Ambient In Free Air θ JA 55 C/W Thermal resistance Junction to mounting base Full cycle 4. C/W θ JC Half cycle 5.5 C/W ISOLATION LIMITING VALUE & CHARACTERISTIC (T HS =25 C, unless otherwise specified) PARAMETER SYMBOL MIN TYP MAX UNIT Repetitive peak voltage form all three terminals to external heatsink (R.H. 65%,clean and dustfree) V ISOL 15 V Capacitance from MT2 to external heatsink (f =1MHz) C ISOL 12 pf STATIC CHARACTERISTICS (T J =25 C, unless otherwise specified) PARAMETER SYMBOL TEST CONDITIONS MIN TYP MAX UNIT T2 + G+ 2.5 ma Gate Trigger Current I GT V D =12V, I T =.1A T2 + G- 4. ma T2 - G- 5. ma T2 - G+ 11 25 ma T2 + G+ 3.2 3 ma Latching Current I L V D =12V, I GT =.1A T2 + G- 16 4 ma T2 - G- 4. 3 ma T2 - G+ 5.5 4 ma Holding Current I H V D =12 V,I GT =.1A 2.5 2 ma On-State Voltage V T I T =15 A 1.4 1.65 V Gate Trigger Voltage V GT V D =12V, I T =.1A.7 1.5 V V D =4V, I T =.1A, T J =125 C.25.4 V Off-State Leakage Current I D V D =V DRM(MAX), T J =125 C.1.5 ma UNISONIC TECHNOLOGIES CO., LTD 2 of 6
DYNAMIC CHARACTERISTICS (T J =25 C, unless otherwise specified) PARAMETER SYMBOL TEST CONDITIONS MIN TYP MAX UNIT Critical Rate of Rise of Off-State Voltage Gate Controlled Turn-On Time dv D /dt t GT V DM = 67% V DRM(MAX),T J =125 C, Exponential waveform, gate open circuit I TM =16A,V D = V DRM(MAX), I G =.1A, di G/ dt=5a/μs 5 V/µs 2 µs UNISONIC TECHNOLOGIES CO., LTD 3 of 6
TYPICAL CHARACTERISTICS Maximum On-State Dissipation, Ptot Vs RMS On-state Current, I T(RMS), Whereα=Conduction Angle. Ptot (W) T 2 mb(max) (C) 95 α=18 15 5 α α 5 IT(RMS) (A) α=12 α=9 2.5 α=6 α=3 1 117.5 125 15 Maximum Permissible Non-Repetitive Peak Onstate Current I TSM, Vs Pulse Width t p,for Sinusoidal Currents,t p 2ms. ITSM (A) di T /dt limit T T2-G+ quadrant T J initial=25 Cmax us us 1ms ms ms T(s) I T I TSM time Maximum Permissible Repetitive RMS On-state Current I T(RMS), Vs Surge Duration, For Sinusoidal Currents, f=5hz, T MP 99 C I T(RMS) (A) 25 2 15 5 Normalised Gate Trigger Voltage V GT (T J )/V GT (25 C), Vs Junction V GT (T J ) Temperature, T J V GT (25 C) 1.6 1.4 1.2 1.8.6.1.1 1 Surge Duration (S).4-5 5 T J ( C) 15 UNISONIC TECHNOLOGIES CO., LTD 4 of 6
TYPICAL CHARACTERISTICS(Cont.) Normalised Holding Current I H (T J )/I H (25 C), Vs Junction Temperature, T J I H (T J ) I H (25 C) 3 2.5 2 1.5 1.5 4 3 2 I T (A) T J =125 C T J =25 C Typical And Maximum On-state Characteristic V OUT =1.75V R S =.316Ohms typ max -5 5 T J ( C) 15.5 1 1.5 2 V T (V) 2.5 3 UNISONIC TECHNOLOGIES CO., LTD 5 of 6
UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD 6 of 6