MIC E 1 E 2 CD TAPE OUT POTABE USB MIXE MA OUT MON. PW GA E USB CD TAPE 5 E USB PAY MA HIGH OW PAN HIGH OW BA MONI 1 MONI 12KHz 8Hz 12KHz 8Hz EVE PEAK EVE CIP 1 1 1 CH1 CH2/ MA MIX
MX SEIES MX SEIES
MX SEIES 1 MX SEIES 1. DUCTION...4 2. FEATUES...4. STUCTION...4 4. CON EEMENTS...5 5. CONNECTG DIAGAMS...7 6. WIG CONNECTION...8 7. BOCK DIAGAM...9 8. TECHNICA SPECIFICATIONS...1 9. GUAANTEE...12 1. NOTES...1
MX SEIES Thank you for purchasing the PP PO MX. compact po rtable mixer. MX. mixer features super mini size but equipped with powerful functions. Please carefully read this manual before installation and operation. Thank you again for choosing PP PO MUSIC GEA products. MX SEIES 9 * 1 mic input channels with X and balanced line input. * 1 stereo input channels with CA jack. * Ultra-low noise discrete Mic Preamps with +2V Phantom Power. * 2-band EQ (Warm, natural) in mono and stereo channels. * 1 Gain control in mono channel. * Peak ED in mono channel & master. * 2CA-Track inputs & 2CA-Track outputs * 2CA-Track inputs assign to Main Mix & Monitor outputs. * Main Mix & Monitor outputs use.5mm stereo jack. * Built-in stereo USB/Audio interface * Either USB bus-powered or external adaptor(5vdc 5mA) Make sure MX. mixer is u sed in t he area of ventilation. Do not install or use this product near any direct hear source(such as amplifier or heater). Computer USB power or external voltage converter can also su pply power to MX. mixer. Note: when using computer USB as power supply, please make sure the USB port of the computer must comply with the standards of USB 2.(5V 5mA) 1
MX SEIES 8 MX SEIES Main mix Noise (2 Hz-2 khz) Equalization PEAK Indicator VU Meters Impedance USB SECTION Phantom power Power supply MA OUT(all knob/fader @ dbu, 22 Hz Gain @ unity) Main Mix knob/fader @ -, Channel evel knob/fader @ - Main Mix knob/fader @ db, Channel evel knob/fader @ - 22 khz Filter, -12dBu(A-weighted) -1dBu(A-weighted) Main Mix knob/fader @ db, Channel evel knob/fader @ db -98dBu(A-weighted) Mono channels Stereo channels High db @12 khz High db @12 khz ow db @8 Hz ow db @8 Hz Channel1 +dbu Main eft and ight (1-segment) Clip +dbu Microphone Input 2.6k Ohms ine Input 1k Ohms Tape Input 1k Ohms Main Outputs 12 Ohms Phones Outputs 12 Ohms Tape Output 1K Ohms USB Interface USB 2. full speed compliant ADC & DAC 16-Bit Delta-Sigma,44.1kHz Sampling ates Windows 2,XP or higher, Operating System Mac OS 9..4 or higher, 1.X or higher Mic Pin2/Pin And Pin1(X--1 type balanced 1=GND,2=HOT, +2V =COD) USB Connection DC5V, 5mA Adaptor DC5V, 5mA Power Consumption 2.5W Physical Dimension (*W*H) 98 mm*16 mm*4 mm Weight.48Kg (1.1 lbs) 1 2 5 4 6 7 16 1 11 12 1 14 DC : PW MIC E 1 GA 12KHz 8Hz EVE 5VDC 5mA OFF ON MADE CHA 1 E 2 E USB PEAK EVE CDT APE OUT 1 CD TAPE 5 E USB PAY MA HIGH OW PAN HIGH OW BA MODE SEIA 12KHz 8Hz MONI MON. 1 MONI CIP CH1 CH2/ MA MIX POTABE USB MIXE MA OUT 1 PW 8 9 17 18 19 21 2 12
MX SEIES 1- USB POT This Type B USB port can be used to connect the computer via Type B to A connector. 2- POWE SWITCH To turn on/off the unit. - POWE ED This ED will light up when the unit is powered on. 4- MIC/E JACK This combined jack can be used to connect mono signal, such as X microphone or 1/4" line level. *Note: Please choose balanced cable and MIC to connect. Do not use th e u nba lanced ones. When the unit is powered on, remember not to con nect the high level signal to X MIC, which may dam age the unit. 5- E JACK This CA jack is used for connecting stereo line in signal source. 6- CD/TAPE JACK This CA jack is used for connecting stereo line in signal source. 7- CD/TAPE OUT JACK This CA jack is used for connecting stereo tape recorder. 8- MA OUT JACK This.5mm stereo jack is used to con nect the ac tive stereo speaker. 9- MONI OUT JACK This.5mm stereo jack is used to connect the stereo headphone. 1- GA CON It is used for adjust the level of mono input. 11- HIGH This treble control can be used to reduce the HF noise or boost the sound of percussion. 12- OW This bass control can be used to boost male or effect of drum & bass. Type: Frequency esponse Distortion (THD&N) MIC E (Equivalent Input Noise) CM Channel USB MIXE Mic Input to any Output (Gain @ db,ated output level) MX SEIES 1 Hz to 4 khz(, -1dB) 1 Hz to 1 khz(, -db) Mic Input to MA Output (Gain @ db,ated output level @ 2 Hz-2 khz bandwidth).1%(a-weighted) Input: Channel PUT MIC (s =, Gain @ Max., -118dBu(A-weighted) 2 Hz-2 khz bandwidth) Mic in to main out (Gain @ Max.,@ 1 khz) 7dB 8 Input Gain Mono Channel MIC: to 5dB,E:-5 to +db (2 Hz-2 khz) Stereo Channel Attenuation ine in, 1/4" TS Main Out,1 khz relative to dbu, 22 Hz 22 khz Filter, Gain @ unity. (Crosstalk) (2 Hz-2 khz) Main Mix knob/fader @ - -79dBu(A-weighted) Channel evel knob/fader @ - -79dBu(A-weighted) ated Output evel Maximum Output evel Maximum Voltage Gain (EQ and PAN/ BA knob @ db, Other all knob or fader @ max,1 khz, s=6 ) Main, monitor, tape output (all knob/fader @ dbu,1 khz) dbu Main, monitor, tape output (all knob/fader @ dbu,1 khz, 22 Hz 22 khz Filter,THD @ 1%) +17dBu Mono Channel MIC PUT MA OUT(.5 jack stereo) 69dBu Mono Channel MIC PUT M onitor(.5 jack stereo) 78dBu Mono Channel MIC PUT TAPE OUT(CA) 69dBu Mono Channel E PUT MA OUT(.5 jack stereo) 5dBu Stereo Channel E PUT MA OUT(.5 jack stereo) 16dBu TAPE PUT MA OUT(.5 jack stereo) 6dBu TAPE PUT M onitor(.5 jack stereo) 9dBu 11
MX SEIES MX SEIES Block Diagram 1 1- PAN/BA This is the panorama control or balanced control. This control is used for stereo effect field of the signal. Set this control in middle position, signal levels of Channel & will be same. When the control is set to top stop, only Channel receives the signal, Channel can not. Vice versa. 14- PEAK ED This is clip ED indicator of mono level. When this ED illumin ates, it means that PF mono level is clipped. - EVE CON This is channel level control, which is used for adjusting the level of corresponding channels. 16- E /USB PAY This is path control of the stereo sound source. When this control is engaged, the signal of channel 2/ comes from USB PAY(computer); when the control is disengaged, the signal will be from CA j acks of channel 2/. 17- CD/TAPE MA This is the assignment control of stereo line le vel. When this control is engaged, the signal of CD/TAPE will be assigned to MA MIX OUT. When the control is disengaged, the assignment will be disconnected. 18- CD/TAPE MONI This is the assignment control of stereo line lev el. When t his control is engaged, the signal of CD/TAPE will be assigned to MONI OUT. When the control is disengage d, MONI OUT will receive the sig nal from MA MIX OUT. 19- MONI This is monitor control use d for adjusting the m onito r out put l evel. 2- MA MIX This is main mix control used for adjusting the main mix output level. 21- CIP ED(&) This is main mix level clip ED. When this ED lights up, main mix level will be clipped.
MX SEIES MX SEIES In-line Connection MIC 1 CD PAYE COMPUTE ACTIVE SPEAKES For X Connector For these applications the unit provides 1/4" TS and X connectors to easily interface with most professional audio devices. Follow the configuration examples below for your particular connection. Pin2 (+) Pin (-) Pin1 ( ) X Type Balanced E 2 MIC E 1 Balanced CDT APE OUT POTABE USB MIXE TIP G SEEVE MON. SEEVE G TIP MA OUT PW HEADPHONE TIP G SEEVE ing ing 1 2 1 2 ing 1 2 ing ing ing ing Cente r Screen Cente r Screen.5mm to.5mm GA E USB CD TAPE TIP G SEEVE E USB PAY 5 HIGH OW PAN Unbalanced TIP SEEVE 1 MONI 12KHz 8Hz DAT EVE MONI MA HIGH OW BA 12KHz 8Hz CIP DAT O TAPE ECODE TIP G SEEVE PEAK EVE TIP SEEVE 1 CH1 SEEVE G TIP 1 CH2/ SEEVE TIP SEEVE G TIP CA Connection 1 MA MIX Mp PAYE USB Connection