PHOTOLTR FTURD RTGL RGHT GL BRRL D-Operated Long-Range with uperior Durability poxy-encapsulated sensors provide reliable sensing without adjustments. Features 3 mm plastic threaded barrel vailable in opposed, retroreflective and fixed-field modes Designed for use in harsh sensing environments dvanced diagnostics warn of marginal sensing conditions or output overload ordsets and brackets see page 78 Opposed, -3 V D ensing Mode Range onnection Models P Models PP OPPOD 6 m 2 m 6 mitter 4-Pin uro QD 6Q mitter 2 m 6R P6R 4-Pin uro QD 6RQ P6RQ nfrared LD Polar Retro, -3 V D ensing Mode Range onnection Models P Models PP Visible Red LD P 6 m 2 m 6LP P6LP POLR RTRO 4-Pin uro QD 6LPQ P6LPQ Fixed-Field, -3 V D ensing Mode Range onnection Models P Models PP FD-FLD - 2 mm - 4 mm - 6 mm 2 m 6FF2 P6FF2 4-Pin uro QD 6FF2Q P6FF2Q 2 m 6FF4 P6FF4 4-Pin uro QD 6FF4Q P6FF4Q 2 m 6FF6 P6FF6 4-Pin uro QD 6FF6Q P6FF6Q nfrared LD For more specifications see page 79. onnection options: model with a QD requires a mating cordset (see page 78). 76 For 9 m cable, add suffix W/3 to the 2 m model number (example, 6LP W/3). Retroreflective range is specified using a BRT-3 retroreflector. ctual sensing range may differ, depending on the efficiency and reflective area of the retroreflector used. ee ccessories for more information.
LOT & R MTUR FBR OPT -Operated Long-Range with uperior Durability poxy-encapsulated sensors provide reliable sensing without adjustments. Features 3 mm plastic threaded barrel vailable in opposed, retroreflective and fixed-field modes Designed for use in harsh sensing environments Uses innovative dual-indicator system to reduce complexity of monitoring sensor performance ordsets and brackets see page 78 Opposed, 2-25 V ensing Mode Range onnection Models LO Models DO OPPOD 6 m 2 m 3 mitter 4-Pin Micro QD 3Q mitter 2 m W3R RW3R 4-Pin Micro QD W3RQ RW3RQ nfrared LD Polar Retro, 2-25 V ensing Mode Range onnection Models LO Models DO Visible Red LD P 6 m 2 m W3LP RW3LP POLR RTRO 4-Pin Micro QD W3LPQ RW3LPQ Fixed-Field, 2-25 V ensing Mode Range onnection Models LO Models DO FD-FLD - 2 mm - 4 mm - 6 mm 2 m W3FF2 RW3FF2 nfrared LD 4-Pin Micro QD W3FF2Q RW3FF2Q 2 m W3FF4 RW3FF4 4-Pin Micro QD W3FF4Q RW3FF4Q 2 m W3FF6 RW3FF6 4-Pin Micro QD W3FF6Q RW3FF6Q For more specifications see page 8. onnection options: model with a QD requires a mating cordset (see page 78). For 9 m cable, add suffix W/3 to the 2 m model number (example, W3LP W/3). Retroreflective range is specified using a BRT-3 retroreflector. ctual sensing range may differ, depending on the efficiency and reflective area of the retroreflector used. ee ccessories for more information. More information online at bannerengineering.com 77
PHOTOLTR FTURD RTGL RGHT GL BRRL ordsets uro QD (for Q models) ee page 96 Threaded 4-Pin Length traight Right-ngle.83 m MQD-46 MQD-46R 4.57 m MQD-45 MQD-45R 9.4 m MQD-43 MQD-43R Micro QD (for Q models) ee page 99 Length Threaded 4-Pin traight Right-ngle.83 m MQ-46 MQ-46R 4.57 m MQ-45 MQ-45R 9.4 m MQ-43 MQ-43R dditional cordset information available. ee page 92. Brackets ee page 866 ee page 869 ee page 869 ee page 87 MB85F MB3 MB3F.. MBM3P Other ccessories Reflectors pertures ee page 94 ee page 966 dditional brackets and information available. ee page 866. ø 4. mm 22.5 mm 45 mm 5.5 mm ø 3. mm Opposed, Polarized Retroreflective and Fixed-field Models uffix, R, LP and FF 78
LOT & R MTUR FBR OPT D pecifications upply Voltage and urrent upply Protection ircuitry Output onfiguration Output Rating Output Protection ircuitry Output Response Time Delay at Power-up Repeatability ndicators onstruction to 3 V dc (% max. ripple); upply current (exclusive of load current): Opposed mitters: 25 m Opposed Receivers: 2 m Polarized Retroreflective: 3 m Fixed-Field: 35 m Protected against reverse polarity and transient voltages olid-state dc switch; three-wire hookup; choose Light Operate (LO) or Dark Operate (DO) models Light Operate: Output conducts when the sensor sees its own (or the emitter s) modulated light Dark Operate: Output conducts when sensor sees dark 5 m max. (each) in standard hookup; When wired for alarm output, the total load may not exceed 5 m OFF-state leakage current: less than µ at 3 V dc O-state saturation voltage: less than V at m dc; less than.5 V at 5 m dc Protected against false pulse on power-up and continuous overload or short circuit of outputs Opposed: 3 milliseconds O;.5 milliseconds OFF Polarized Retroreflective and Fixed-Field: 3 milliseconds O/OFF milliseconds; outputs are non-conducting during this time Opposed: 375 microseconds Polarized Retroreflective and Fixed-Field 75 microseconds Repeatability and response are independent of signal strength. Two LDs: olid Green: Power O Flashing Green: output overload olid Yellow: Light operate (LO) output energized Flashing Yellow: marginal excess gain Housings are thermoplastic polyester. Lenses are polycarbonate or acrylic; one jam nut included. nvironmental Rating Leakproof design rated M 6P, P67. QD models rated P69K per D 45-9. onnections 2 m or 9 m attached cable, or 4-pin uro-style quick-disconnect fitting. QD cordsets are ordered separately. ee page 78. Operating onditions Temperature: -4 to +7 Relative humidity: 9% at 5 (non-condensing) Vibration and Mechanical hock ertifications ll models meet Mil. td. 22F requirements. Method 2 (Vibration; frequency to 6 Hz, max., double amplitude.6-inch acceleration G). Method 23B conditions H& (hock: 75G with unit operating; G for non-operation) OLB chemical compatibility pending on some models; contact Banner ngineering for details More information online at bannerengineering.com 79
PHOTOLTR FTURD RTGL RGHT GL BRRL pecifications upply Voltage and urrent upply Protection ircuitry Output onfiguration Output Rating Output Protection ircuitry 2 to 25 V ac (5/6 Hz). verage current: 2 m Peak current: 2 m at 2 V ac, 5 m at 2 V ac, 75 m at 25 V ac Protected against transient voltages olid-state ac switch; three-wire hookup; choose Light Operate (LO) or Dark Operate (DO) models Light Operate: Output conducts when the sensor sees its own (or the emitter s) modulated light Dark Operate: Output conducts when sensor sees dark 3 m max. (continuous) Fixed-Field: derate 5 m/ above +5 nrush capability: amp for 2 milliseconds, non-repetitive OFF-state leakage current: less than µ O-state voltage drop: 3 V at 3 m ac; 2 V at 5 m ac Protected against false pulse on power-up Output Response Time Delay at Power-up Repeatability ndicators onstruction Opposed: 6 milliseconds O; 8 milliseconds OFF Polarized Retroreflective and Fixed-Field: 6 milliseconds O/OFF milliseconds Opposed: 2 milliseconds Polarized Retroreflective and Fixed-Field: 4 milliseconds Repeatability and response are independent of signal strength Two LDs: olid Green: Power O olid Yellow: Light sensed Flashing Yellow: marginal excess gain Housings are thermoplastic polyester. Lenses are polycarbonate or acrylic; one jam nut included. nvironmental Rating Leakproof design rated M 6P, P67. QD models rated P69K per D 45-9. onnections 2 m or 9 m attached cable, or 4-pin Micro-style quick-disconnect fitting. QD cordsets are ordered separately. ee page 78. Operating onditions Temperature: -4 to +7 Relative humidity: 9% at 5 (non-condensing) Vibration and Mechanical hock ll models meet Mil. td. 22F requirements. Method 2 (Vibration; frequency to 6 Hz, max, double amplitude.6-inch acceleration G). Method 23B conditions H& (hock: 75G with unit operating; G for non-operation) ertifications 8
LOT & R MTUR FBR OPT xcess Gain urves (Fixed-Field mode performance based on 9% reflectance white test card) = nfrared LD P = Visible Red LD Polarized Polarized Retroreflective Mode Fixed-Field Mode G. m (.33') eries m m m (3.3') (33') (33') DT G. m (.33') eries Polarized Retro with BRT-3 Reflector. m m m (.33') (3.3') (33') DT G mm (.4") eries Fixed-field mode with 2 mm far limit cutoff mm mm (.4") (4") DT mm (4") Ø 6 mm spot size @ 35 mm focus Ø 2 mm spot size @ 2 mm cutoff Using 8% gray test card: cutoff distance will be 95% of value shown. Using 6% black test card: cutoff distance will be 9% of value shown. Range: 6 m LD: Range: 6 m LD: P : 2 mm LD: Fixed-Field Mode Fixed-Field Mode G mm (.4") eries Fixed-field mode with 4 mm far limit cutoff mm mm (.4") (4") DT mm (4") Ø 7 mm spot size @ 35 mm focus Ø 25 mm spot size @ 4 mm cutoff Using 8% gray test card: cutoff distance will be 9% of value shown. Using 6% black test card: cutoff distance will be 85% of value shown. G mm (.4") eries Fixed-field mode with 6 mm far limit cutoff mm mm (.4") (4") DT mm (4") Ø 7 mm spot size @ 35 mm focus Ø 3 mm spot size @ 6 mm cutoff Using 8% gray test card: cutoff distance will be 85% of value shown. Using 6% black test card: cutoff distance will be 75% of value shown. : 4 mm LD: : 6 mm LD: Beam Patterns = nfrared LD P = Visible Red LD Polarized ffective Beam: 23 mm Polarized Retroreflective Mode 75 mm 5 mm eries 3" 2" 5 mm mm eries Polarized Retro 6" 4" 25 mm " 5 mm 2" with BRT-3 Reflector 25 mm " 5 mm 2" 5 mm 2" mm 4" 75 mm 3" 5 mm 6" 5 m (5') 3 m 45 m (') (5') DT 6 m (2') 75 m (25').5 m (5') 3. m 4.5 m (') (5') DT 6. m (2') 7.5 m (25') Range: 6 m LD: Range: 6 m LD: P More information online at bannerengineering.com 8