Assembly Instructions to make the box organiser for the board game Perditions Mouth With a craft knife and sandpaper, remove the pieces from the sheets of plywood as you do each tray. The pieces are almost fully cut out and have tiny joints to hold them in place while in transit. Remove the required pieces and then lightly sand any rough edges that may occur when removed. This will help to gain a better fit with the joints and make your insert stronger and smarter. Identify the pieces from the plan above. TIP. Sometimes parts of the plywood kit can be bent or warped, a weight such as a heavy book is all that s needed together with rubber bands to hold the assembly flat while the glue sets, clamps are great if you have some. Follow the instructions and you will find it much easier than removing all the pieces first into a heap. Layout the pieces of the map board holder as shown. These pieces will be found on sheets 3,18,19 and 20. Fit the four sides together and strap with rubber bands while the glue sets. Lay out the pieces of the token tray. The pieces can be found on sheets 4,5,6,7 and 8. Now fit the sides. Fit the four dividers as shown. Fit the central divider. Now fit the short divider and the tiny one, as shown.
Finish the tray by fitting the final two dividers as pictured. keep the contents in place. NOTE When the glue has set, there is a small adjustment that is required to allow the lid to fit. Place the lid into the locating cutouts and you will see a small piece needs to be removed with a sharp craft knife. Mark the edge with a pencil or pen. Mark with the pencil the extension of the horizontal cutout, as pictured. The plywood will cut easily. It is best to make the small cut down first, as pictured above, before the horizontal cut but please take care by removing a small amount at a time. Lay out the next box and its parts as shown. The pieces are found on sheets,11 and 12. Carefully dab small amounts of glue between the cut out holes. Now locate the sheet with glue applied onto the base. keep the contents in place.
Lay out the next box and its parts as shown. The parts are found on sheets, 1,3,4,8,11 and 16. Apply glue as shown on last box and locate it on the base as shown. Apply glue carefully to the underside of the cut out frame and locate as shown. keep the contents in place. Layout the pieces as shown. Parts are found on sheets, 16 and 17 Fit the four sides to complete Lay out the parts as shown, these parts are found on sheets,13,15,17 and 20 As previously done apply glue to the underside of the cut out frame and locate on the base.
Fit the four sides as shown. Apply glue between the five shapes pictured and fit the piece with the cutouts on the top as shown. Fit the assembled Rotikka holder into the slot on the side then fit the divider that keeps the Demon in its space. keep the contents in place. The Foam needs to be laid in the top of the tray marked where the divider is, for the demon space, then cut just enough to allow the divider to pass through. Lay out as shown, these are found on sheets, 8,9 and 10 Apply glue and fit the three overlays together, making sure the locating lugs are aligned together, then fit them onto the main base of the box. keep the contents in place. You will find that the Lay out the pieces as shown for Victims and kickstarter. Pieces can be found on sheets,14,15 and 17.
Apply glue and fit the cutout section as show keeping the locating lugs in position on the base Fit the four sides. Finish by fitting the divider as shown. This box has the small piece of foam to help keep the contents in place. Layout the parts of the small card holder as shown. Now do the same with the four larger card holders. Glue the ends and sides together as pictured.