[1] Submitted by Ana White [2] on Wed, 2012-08-08 12:20 [1] I've been wanting a few cedar planters for the front of my house, and had some leftover cedar fence pickets to use up. This was a quick and Page 1 of 11
easy project, and I absolutely love how it turned out! Every time I come home, I admire my planters! And the best part is, they are so inexpensive to make! For the cost of a store bought planter, you could line your driveway with DIY cedar planters! I estimate this project will cost around $20 to build using cedar fence pickets and whitewood boards on the trim. ($3) 2-1x3 @ 8 feet long ($1) 1-1x2 @ 8 feet long ($6) 3-5 1/2" wide x 72" long cedar fence pickets ($2) 1-2x2 @ 8 feet long $8 leftover for screws and glue Good luck building! Please share your photos when done, I can't wait to see your planters! Summary: Build cedar planters for less than $20! Free easy step by step plans from Ana-White.com CategoriesProject Type: Outdoor [3] Room: Outdoor [4] Skill Level: Beginner [5] Style: Cottage Style Furniture Plans [6] Estimated Cost: Under $20 [7] Dimensions: Dimensions shown above. Dimensions: Page 2 of 11
2-1x3 @ 8 feet long 1-1x2 @ 8 feet long 3-5 1/2" wide x 72" long cedar fence pickets 1-2x2 @ 8 feet long 2 1/2" exterior pocket hole screws 1 1/4" exterior screws or galvanized nails exterior wood glue Tools: Page 3 of 11
[8] [9] Page 4 of 11
[10] [11] [12] Cut List: 10-1x3 @ 17" 5-1x2 @ 17" 4-2x2 @ 23 3/4" 12 - cedar fence pickets @ 17 3/4" long (shortened by 1/4" from diagrams to allow for saw blade width and dog eared end) General Instructions: Please read through the entire plan and all comments before beginning this project. It is also advisable to review the Getting Started Section. Take all necessary precautions to build safely and smartly. Work on a clean level surface, free of imperfections or debris. Always use straight boards. Check for square after each step. Always predrill holes before attaching with screws. Use glue with finish nails for a stronger hold. Wipe excess glue off bare wood for stained projects, as dried glue will not take stain. Be safe, have fun, and ask for help if you need it. Good luck! Step 1 Page 5 of 11
[13] Start by first building your four panels. I sized this plan to allow for an 1/8" gap between the cedar pickets as they will shrink/expand with moisture and let's just face it - the cedar fence pickets are not going to be perfect! I used 1 1/4" galvanized nails and exterior glue from the insides. Step 2 Page 6 of 11
[14] On all four of your panels, drill 2-1 1/2" pocket holes on the inside, behind each 1x3 on the ends. This will put screws through the fence pickets, 1x3s and then into your legs. Join two of the panels to the legs as shown in diagram. Step 3 Page 7 of 11
[15] And then add the remaining two panels to create your planters. Adjust for square. Step 4 Page 8 of 11
[16] Now don't think that this whole planter needs to be filled with dirt!!! Unless you are planning on harvesting potatoes in there! I put my bottom 6" down from the top to keep the planter lighter and use less dirt. Start by attaching cleats to sides at desired height. Step 5 Page 9 of 11
[17] And then lay the remaining scrap boards down to create a bottom for either gardener's cloth or just set a plastic planter on top. Done deal! Finishing InstructionsPreparation Instructions: Fill all holes with wood filler and let dry. Apply additional coats of wood filler as needed. When wood filler is completely dry, sand the project in the direction of the wood grain with 120 grit sandpaper. Vacuum sanded project to remove sanding residue. Remove all sanding residue on work surfaces as well. Wipe project clean with damp cloth. It is always recommended to apply a test coat on a hidden area or scrap piece to ensure color evenness and adhesion. Use primer or wood conditioner as needed. Page 10 of 11
Source URL: http://www.ana-white.com/2012/08/plans/cedar-planters-less-20 Links [1] http://www.ana-white.com/2012/08/plans/cedar-planters-less-20 [2] http://www.ana-white.com/users/ana-white [3] http://www.ana-white.com/category/plans/project-type/outdoor [4] http://www.ana-white.com/category/plans/room/outdoor [5] http://www.ana-white.com/category/plans/skill-level/beginner [6] http://www.ana-white.com/category/plans/style/cottage [7] http://www.ana-white.com/category/plans/estimated-cost/under-20 [8] http://www.kregtool.com/files/anawhite/anawhite.asp [9] https://www.ryobitools.com/power-tools/products/details/537 [10] https://www.ryobitools.com/power-tools/products/details/92 [11] https://www.ryobitools.com/power-tools/products/details/552 [12] https://www.ryobitools.com/power-tools/products/details/187 [13] http://www.ana-white.com/sites/default/files/3154813486_1344446 443.jpg [14] http://www.ana-white.com/sites/default/files/3154813487_1344446 443.jpg [15] http://www.ana-white.com/sites/default/files/3154813488_1344446 443.jpg [16] http://www.ana-white.com/sites/default/files/3154813489_1344446 443.jpg [17] http://www.ana-white.com/sites/default/files/3154813490_1344446 443.jpg Page 11 of 11