Premium Low-Profile Benches for Dutch Buckets Single Row

Important Information READ THIS DOCUMENT BEFORE YOU BEGIN Thank you for purchasing this premium low-profile bench. When properly assembled and maintained, this product will provide years of reliable service. These instructions include helpful hints and important information needed to safely assemble and properly maintain the bench. Please read these instructions before you begin. If you have any questions during the assembly, contact Customer Service at 1.800.245.9881 for assistance. SAFETY PRECAUTIONS Wear eye protection. Wear gloves when handling metal pipes and top. Use a portable GFCI (Ground Fault Circuit Interrupter) when working with power tools and cords. REQUIRED TOOLS The following list identifies tools needed to assemble bench. Additional tools may be needed. Variable speed drill (cordless with extra batteries works best) Small hammer and gloves Ratchet and socket set or 1/2" wrench ASSEMBLY PROCEDURE Following the instructions as presented helps ensure proper assembly. The steps outlining assembly are as follows: 1. Verify all parts are included in shipment. Notify customer service for questions or concerns. 2. Read these instructions and all additional documentation included with shipment before you begin. 3. Gather tools. 4. For best results, assemble components on a flat, level surface in the order they are presented in these instructions. 5. Read care and maintenance information. CARE AND MAINTENANCE Proper care and maintenance is important. Check these items periodically to properly maintain bench. Check connections and all fasteners to verify that they remain tight. Do not climb or stand on the frame at anytime. Verify all weight on bench top is evenly distributed. Promptly repair or replace all damaged parts and frame members. If the bench is disassembled and moved, inspect all parts and connections before reassembling and use. For replacement parts, call 800.245.9881 for assistance. 2

Important Information PICTORIAL GUIDE The following graphics and photos will help identify the different parts of your bench. (Some parts may not be shown.) ATTACH LEVELER INSERTS TO EACH LEG Levelers help set a slope to your bench for some growing applications. Before you begin assembling the bench frame, assemble the leveler inserts and attach each one to a bench leg as shown below. FA4482B Tek Screw Leg Tube FALB34B Neo-Bonded Washer FA4482B Tek Screw FAH337B Leveler 100441 Nut Setter Complete these steps to install each insert: 1. Slide one insert into bottom of a leg tube. Tap gently with a small hammer if needed to seat in place. 2. Secure using an FA4482B Tek screw. Install screw through frame tube and wall of the insert. Install Tek screw on either side of tube center line to prevent contact with adjusting bolt. 3. Add a nut to each FAH337B bolt and install bolt so that it is fully turned into the threaded plate of the insert. See photo to the right. STEP 2 3

FRAME ASSEMBLY Tighten all frame bolts until snug. Do not overtighten. Assembly Instructions 115050 (12" x 72") 115033 113178 TTS15L00550S1 leg tube with leveler installed. See previous page. FA4482B & 115047 Expanded Metal Top ATTENTION: Evenly space Tek screws and neo-bonded washers around perimeter of frame to secure expanded metal top. 4

Assembly Instructions 115051 (12" x 144") FRAME ASSEMBLY Tighten all frame bolts until snug. Do not overtighten. 115047 FA4482B & 115033 TTS15L00550S1 leg tube with leveler installed. See page 3. 113177 Side Rail ATTENTION: Evenly space Tek screws and neo-bonded washers around perimeter of frame to secure expanded metal top. 5