Preliminary Technical Data FEATURES TL082 / TL08 compatible Low input bias current: 0 pa max Offset voltage: 5mV max (ADTL082A/ADTL08A) 9 mv max (ADTL082/ADTL08) ±5 V to ±5 V operation Low noise: 5 nv/ Hz Wide bandwidth: 6 MHz Slew rate: 20V/µs CMRR: 80 db min Total Harmonic Distortion: 0.003 % Supply current:.2 ma typ Unity-gain stable APPLICATIONS General purpose amplification Power control and monitoring Active filters Industrial / process control Data acquisition Sample and hold circuits Integrators Input buffering PIN CONFIGURATIONS Low Cost JFET Input Operational Amplifiers ADTL082/ADTL08 OUT A -IN A 2 + IN A -V 3 AD8682 / ADTL082 (Not to Scale) 8 + V OUT B 6 -IN B 5 + IN B Figure. 8-Lead SOIC (R-8) OUT A -IN A 2 +IN A 3 V- ADTL082A (Not to Scale) 8 V+ OUT B 6 -IN B 5 +IN B Figure 2. 8-Lead MSOP (RM-8) OUT A OUT D AD868 / IN A - 2 3 -IN D ADTL08 + IN A 3 ADTL08 2 + IN D + V -V + IN B 5 (Not to Scale) 0 + IN C IN B - 6 9 -IN C OUT B 8 OUT C Figure 3. -Lead SOIC (R-) OUT A OUT D -IN A +IN A V+ +IN B -IN B OUT B 2 3 5 6 ADTL08A (Not to Scale) 3 2 0 9 8 -IN D +IN D V- +IN C -IN C OUT C Figure. -Lead TSSOP (RU-) GENERAL DESCRIPTION The ADTL082 and ADTL08 are JFET-input amplifiers providing industry-leading performance over TL08x devices. The ADTL082A and ADTL08A are improved versions of TL08x A-, I- and Q- grades. The ADTL082 and ADTL08 offer improvements over the TL08x standard and C-grades. The ADTL08x family offers lower noise, offset voltage, offset drift over temperature, and bias current over the TL08x. In addition, the ADLT08x family has better common-mode rejection and slew rate. These op amps are ideal for various applications including Rev. PrA Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use. Specifications subject to change without notice. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices. Trademarks and registered trademarks are the property of their respective owners. process control, industrial and instrumentation equipment, active filtering, data conversion, buffering, and power control and monitoring. The A-grade amplifiers are available in lead-free packaging. The standard grades are available in both leaded and lead-free packaging. For high precision grades of these devices, see the ADA000-2 (dual) and ADA000- (quad). The ADTL082A and ADTL08A are specified over the extended industrial (- to 25 C) temperature range. The ADTL082 and ADTL08 are specified over the commercial ( to C) temperature range. One Technology Way, P.O. Box 906, Norwood, MA 02062-906, U.S.A. Tel: 8.329.00 www.analog.com Fax: 8.6.33 2006 Analog Devices, Inc. All rights reserved.
ADTL082/ADTL08 TABLE OF CONTENTS Features... Applications... Pin Configurations... General Description... Revision History... 2 Specifications... 3 Preliminary Technical Data Absolute Maximum Ratings... Thermal Resistance... ESD Caution... Typical Performance Characteristics...5 Outline Dimensions...8 Ordering Guide...9 REVISION HISTORY /06 Rev Pr0: Initial Version 3/06 Rev PrA
Preliminary Technical Data ADTL082/ADTL08 SPECIFICATIONS VCC = ±5 V, VCM= 0 V, TA = 25 o C, over all grades unless otherwise noted Table. Parameter Symbol Conditions Min Typ Max Unit INPUT CHARACTERISTICS Offset Voltage VOS ADTL082 / ADTL08 2 9 mv C TA C 5 mv ADTL082A / ADTL08A.5 5 mv -C TA 25 C (A grade) 9 mv Offset Voltage Drift VOS/ T C TA C (all grades) 2.0 6.5 μv/ C -C TA 25 C (A grade) 2.0.5 μv/ C Input Bias Current IB 0.2 20 pa C TA C (all grades) 00 pa -C TA 25 C (A grade) 550 pa Input Offset Current IOS 0. 0.5 pa C TA C (all grades) 50 pa -C TA 25 C (A grade) 250 pa Input Voltage Range VCM - 2 V Common-Mode Rejection Ratio CMRR VCM = 0 V to 5.0 V 80 86 db Open-Loop Input Impedance RIN 0 MΩ Large Signal Voltage Gain AVO RL = 2 kω, VO = -0 V to 0 V 60 00 V/mV OUTPUT CHARACTERISTICS Maximum Output Voltage Swing VO,MAX RL = 0 kω ±2 ±3.5 V C TA C (all grades) ±2 V -C TA 25 C (A grade) ±2 V RL = 2 kω ± ±3 V C TA C (all grades) ±0 ±2 V -C TA 25 C (A grade) ±0 ±2 V Short-Circuit Output Current ISC ±20 ma POWER SUPPLY Power Supply Rejection Ratio PSRR VDD = 5.V to 30 V 80 86 db Supply Current per Amplifier ISY.0.2 ma C TA C (all grades) 2.2 ma -C TA 25 C (A grade) 2.5 ma DYNAMIC PERFORMANCE Slew Rate SR RL = 2 kω 20 V/μs Gain Bandwidth Product GBP 6 MHz Phase Margin φm Degrees Total Harmonic Distortion THD VIN = 6 VRMS, f = khz, AV = +, RL = 2kΩ 0.003 % Channel Separation CS f = 0 khz 20 db NOISE PERFORMANCE Voltage Noise Density en f = khz 5 nv/ Hz
ADTL082/ADTL08 ABSOLUTE MAXIMUM RATINGS Table 2. Parameter Rating Supply Voltage 36V Input Voltage GND to VDD Differential Input Voltage TBD Output Short-Circuit to GND Indefinite Storage Temperature Range -65 C to +5C Operating Temperature Range -C to +25 C Lead Temperature Range (Soldering 60 sec) 30C Junction Temperature 5C Stresses above those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only; functional operation of the device at these or any other conditions above those indicated in the operational section of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability. Preliminary Technical Data THERMAL RESISTANCE Table 3. Thermal Resistance Package Type θja θjc Unit 8-Lead SOIC_N (R-8) 58 3 C/W 8-Lead MSOP (RM-8) 20 5 C/W -Lead SOIC (R-) 20 36 C/W -Lead TSSOP (RU-) 80 35 C/W ESD CAUTION
ADTL082/ADTL08 Preliminary Technical Data OUTLINE DIMENSIONS 5.00 (0.968).80 (0.890) 5.0 5.00.90.00 (0.5) 3.80 (0.9) 0.0 (0.000) 0.0 8 5.2 (0.0500) 6.20 (0.20) 5.80 (0.228).5 (0.0688).35 (0.0532) 0.5 (0.020) 0.3 (0.022) 0. (0.006) 0.50 (0.096) 0.25 (0.0099) 5.2 (0.0500) 0.0 (0.05) COMPLIANT TO JEDEC STANDARDS MS-02-AA CONTROLLING DIMENSIONS ARE IN MILLIMETERS; INCH DIMENSIONS (IN PARENTHESES) ARE ROUNDED-OFF MILLIMETER EQUIVALENTS FOR REFERENCE ONLY AND ARE NOT APPROPRIATE FOR USE IN DESIGN..05.00 0.80.50.0.30 PIN 8 0.5 0.05 0.65 0.30 0.9 6.0.20 MAX 0.20 0.09 0.0 COMPLIANT TO JEDEC STANDARDS MO-53-AB- 0.5 0.60 0.5 Figure 22. 8-Lead Small Outline Package [SOIC_N] Narrow Body (R-8) Dimensions shown in millimeters and (inches) 3.20 3.00 2.80 Figure 2. -Lead Thin Shrink Small Outline Package [TSSOP] (RU-) Dimensions shown in millimeters 8.5 (0.35) 8.55 (0.3366) 0.95 0.85 0.5 3.20 3.00 2.80 0.5 0.00 PIN 8 5 0.65 0.38 0.22 0.0 5.5.90.65.0 MAX 0.23 0.08 COMPLIANT TO JEDEC STANDARDS MO-8-AA Figure 23. 8-Lead Mini Small Outline Package [MSOP] (RM-8) Dimensions shown in millimeters 0.80 0.60 0.0.00 (0.55) 3.80 (0.96) 0.0 (0.0039) 0.0 8.2 (0.0500) 0.5 (0.020) 0.3 (0.022) 6.20 (0.2) 5.80 (0.2283).5 (0.0689).35 (0.053) 0. (0.006) COMPLIANT TO JEDEC STANDARDS MS-02-AB CONTROLLING DIMENSIONS ARE IN MILLIMETERS; INCH DIMENSIONS (IN PARENTHESES) ARE ROUNDED-OFF MILLIMETER EQUIVALENTS FOR REFERENCE ONLY AND ARE NOT APPROPRIATE FOR USE IN DESIGN. 0.50 (0.09) 5.2 (0.0500) 0.0 (0.05) Figure 25. -LeadStandard Small Outline Package [SOIC] (R-) Dimensions shown in millimeters
Preliminary Technical Data ADTL082/ADTL08 ORDERING GUIDE Model Temperature Range Package Description Package Option ADTL082R C to +C 8-Lead SOIC_N R-8 ADTL082R-REEL C to +C 8-Lead SOIC_N R-8 ADTL082R-REEL C to +C 8-Lead SOIC_N R-8 ADTL082RZ C to +C 8-Lead SOIC_N R-8 ADTL082RZ-REEL C to +C 8-Lead SOIC_N R-8 ADTL082RZ-REEL C to +C 8-Lead SOIC_N R-8 ADTL082ARZ C to +25 C 8-Lead SOIC_N R-8 ADTL082ARZ-REEL C to +25 C 8-Lead SOIC_N R-8 ADTL082ARZ-REEL C to +25 C 8-Lead SOIC_N R-8 ADTL082ARUZ C to +25 C 8-lead MSOP RM-8 ADTL082ARUZ-REEL C to +25 C 8-lead MSOP RM-8 ADTL08R C to +C -Lead SOIC_N R- ADTL08R-REEL C to +C -Lead SOIC_N R- ADTL08R-REEL C to +C -Lead SOIC_N R- ADTL08RZ C to +C -Lead SOIC_N R- ADTL08RZ-REEL C to +C -Lead SOIC_N R- ADTL08RZ-REEL C to +C -Lead SOIC_N R- ADTL08ARZ C to +25 C -Lead SOIC_N R- ADTL08ARZ-REEL C to +25 C -Lead SOIC_N R- ADTL08ARZ-REEL C to +25 C -Lead SOIC_N R- ADTL08ARUZ C to +25 C -lead TSSOP RU- ADTL08ARUZ-REEL C to +25 C -lead TSSOP RU- Z = Pb-free part 2006 Analog Devices, Inc. All rights reserved. Trademarks and registered trademarks are the property of their respective owners.