ATV212HU22M3X variable speed drive ATV kW - 3hp - 240V - 3ph - wo EMC - IP21

Transcription

1 Product data sheet Characteristics ATV212HU22M3X variable speed drive ATV kW - 3hp - 240V - 3ph - wo EMC - IP21 Product availability : Stock - Normally stocked in distribution facility Price* : USD Main Range of product Altivar 212 Product or component type Device short name Product destination Product specific application Assembly style Phase Motor power kw Motor power hp Sep 23, 2018 Variable speed drive ATV212 Asynchronous motors Pumps and fans in HVAC With heat sink 3 phases 2.2 kw 3 hp [Us] rated supply voltage V % Supply voltage limits V Supply frequency Hz % Network frequency EMC filter Line current Complementary Apparent power Prospective line Isc Continuous output current Maximum transient current Speed drive output frequency Nominal switching frequency Switching frequency Hz Without EMC filter 7.3 A 240 V 8.7 A 200 V 4 kva 240 V 5 ka 10.6 A 230 V 11.7 A 60 s Hz 12 khz khz with derating factor khz adjustable 1 Disclaimer: This documentation is not intended as a substitute for and is not to be used for determining suitability or reliability of these products for specific user applications

2 Speed range Speed accuracy Torque accuracy +/- 15 % Transient overtorque Asynchronous motor control profile Regulation loop Motor slip compensation Local signalling Output voltage Isolation Type of cable Electrical connection Tightening torque Supply Analogue input number 2 Analogue input type Sampling duration Response time +/- 10 % of nominal slip 0.2 Tn to Tn 120 % of nominal motor torque +/- 10 % 60 s Voltage/Frequency ratio, 2 points Voltage/Frequency ratio, 5 points Flux vector control without sensor, standard Voltage/Frequency ratio - Energy Saving, quadratic U/f Voltage/Frequency ratio, automatic IR compensation (U/f + automatic Uo) Adjustable PI regulator Adjustable Automatic whatever the load Not available in voltage/frequency ratio motor control 1 LED red DC bus energized <= power supply voltage Electrical between power and control IEC cable without mounting kit F (45 C) copper 90 C XLPE/EPR IEC cable without mounting kit 1 45 C copper 70 C PVC UL 508 cable with UL Type 1 kit 3 40 C copper 75 C PVC Terminal 0 in² (2.5 mm²) AWG 14 VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES Terminal 6 mm² AWG 10 L1/R, L2/S, L3/T 11.5 lbf.in (1.3 N.m) 11.5 lb.in L1/R, L2/S, L3/T 0.6 N.m VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES Internal supply for reference potentiometer (1 to 10 kohm) 10.5 V DC +/- 5 % <= 10 A overload and short-circuit protection Internal supply 24 V DC V <= 200 A overload and short-circuit protection Switch-configurable voltage VIA V DC 24 V max Ohm 10 bits Configurable voltage VIB V DC 24 V max Ohm 10 bits Configurable PTC probe VIB probes 1500 Ohm Switch-configurable current VIA ma 250 Ohm 10 bits 2 ms +/- 0.5 ms F discrete 2 ms +/- 0.5 ms R discrete 2 ms +/- 0.5 ms RES discrete 3.5 ms +/- 0.5 ms VIA analog 22 ms +/- 0.5 ms VIB analog 2 ms +/- 0.5 ms FM analog 7 ms +/- 0.5 ms FLA, FLC discrete 7 ms +/- 0.5 ms FLB, FLC discrete 7 ms +/- 0.5 ms RY, RC discrete Accuracy +/- 0.6 % VIA for a temperature variation 60 C +/- 0.6 % VIB for a temperature variation 60 C +/- 1 % FM for a temperature variation 60 C Linearity error Analogue output number 1 Analogue output type Discrete output number 2 Discrete output type Minimum switching current Maximum switching current Discrete input type Discrete input logic +/ % of maximum value input VIA +/ % of maximum value input VIB +/- 0.2 % output FM Switch-configurable voltage FM V DC 7620 Ohm 10 bits Switch-configurable current FM ma 970 Ohm 10 bits Configurable relay logic FLA, FLC NO cycles Configurable relay logic FLB, FLC NC cycles Configurable relay logic RY, RC NO cycles 3 ma 24 V DC configurable relay logic 5 A 250 V AC resistive cos phi = 1 L/R = 0 ms FL, R 5 A 30 V DC resistive cos phi = 1 L/R = 0 ms FL, R 2 A 250 V AC inductive cos phi = 0.4 L/R = 7 ms FL, R 2 A 30 V DC inductive cos phi = 0.4 L/R = 7 ms FL, R Programmable F 24 V DC level 1 PLC 4700 Ohm Programmable R 24 V DC level 1 PLC 4700 Ohm Programmable RES 24 V DC level 1 PLC 4700 Ohm Positive logic (source) F, R, RES <= 5 V >= 11 V Negative logic (sink) F, R, RES >= 16 V <= 10 V 2

3 Acceleration and deceleration ramps Braking to standstill Protection type Dielectric strength Insulation resistance Frequency resolution Communication port protocol Connector type Automatic based on the load Linear adjustable separately from 0.01 to 3200 s By DC injection Motor phase break motor Break on the control circuit drive Thermal power stage drive Overvoltages on the DC bus drive Against exceeding limit speed drive Against input phase loss drive With PTC probes motor Input phase breaks drive Line supply overvoltage and undervoltage drive Line supply undervoltage drive Overcurrent between output phases and earth drive Overheating protection drive Short-circuit between motor phases drive Thermal protection motor 2830 V DC between earth and power terminals 4230 V DC between control and power terminals >= 1 MOhm 500 V DC for 1 minute 0.024/50 Hz analog input 0.1 Hz display unit APOGEE FLN BACnet LonWorks METASYS N2 Modbus 1 RJ45 1 open style Physical interface 2-wire RS 485 Transmission frame Transmission rate Data format Type of polarization RTU Number of addresses Communication service Option card Operating position Width Height Depth Product weight Power dissipation in W Air flow Specific application IP degree of protection Variable speed drive application selection Motor power range AC-3 Motor starter type 9600 bps or bps 8 bits, 1 stop, odd even or no configurable parity No impedance Monitoring inhibitable Read device identification (43) Read holding registers (03) 2 words maximum Time out setting from 0.1 to 100 s Write multiple registers (16) 2 words maximum Write single register (06) Communication card LonWorks Vertical +/- 10 degree 4.21 in (107 mm) 5.63 in (143 mm) 5.91 in (150 mm) 3.97 lb(us) (1.8 kg) 120 W Gal/hr(US) (41 m3/h) HVAC IP21 Building - HVAC : compressor for scroll Building - HVAC : fan Building - HVAC : pump kw at V 3 phases Variable speed drive Environment Electromagnetic compatibility Conducted radio-frequency immunity test level 3 IEC Voltage dips and interruptions immunity test IEC /50 µs - 8/20 µs surge immunity test level 3 IEC Electrical fast transient/burst immunity test level 4 IEC

4 Pollution degree 3 IEC Electrostatic discharge immunity test level 3 IEC Radiated radio-frequency electromagnetic field immunity test level 3 IEC IP degree of protection IP20 on upper part without blanking plate on cover EN/IEC IP20 on upper part without blanking plate on cover EN/IEC IP21 EN/IEC IP21 EN/IEC IP41 on upper part EN/IEC IP41 on upper part EN/IEC Vibration resistance 1 gn Hz EN/IEC mm Hz EN/IEC Shock resistance 15 gn 11 ms IEC Environmental characteristic Classes 3C1 IEC Classes 3S2 IEC Noise level Operating altitude 51 db 86/188/EEC ft ( m) limited to 2000 m for the Corner Grounded distribution network with current derating 1 % per 100 m <= ft (1000 m) without derating Relative humidity % without condensation IEC % without dripping water IEC Ambient air temperature for operation Ambient air temperature for storage F ( C) without derating > F (> C) with derating factor F ( C) Standards EN EN environments 1 category C1 EN environments 1 category C2 EN environments 1 category C3 EN environments 2 category C1 EN environments 2 category C2 EN environments 2 category C3 EN IEC IEC environments 1 category C1 IEC environments 1 category C2 IEC environments 1 category C3 IEC environments 2 category C1 IEC environments 2 category C2 IEC environments 2 category C3 IEC UL Type 1 Product certifications Marking CSA C-Tick NOM 117 UL CE Ordering and shipping details Category ATV HP 230 VOLT Discount Schedule CP4D GTIN Nbr. of units in pkg. 1 Package weight(lbs) Returnability Y Country of origin ID Offer Sustainability Sustainable offer status RoHS (date code: YYWW) REACh Product environmental profile Green Premium product Compliant - since Schneider Electric declaration of conformity Schneider Electric declaration of conformity Reference not containing SVHC above the threshold Reference not containing SVHC above the threshold Available 4

5 Product end of life instructions California proposition 65 Product Environmental Profile Available WARNING: This product can expose you to chemicals including: Substance 1 Lead and lead compounds which is known to the State of California to cause cancer and birth defects or other reproductive harm More information For more information go to Contractual warranty Warranty period 18 months 5