Two. T.NageswaraRao II. MULTI O. particularly. of Two-port and. currents are given by (2) voltage-timee. the.

Transcription

1 Two and Three Outpu Ports Soft Switched DC- DC Converter- A Comparative Analysis T.NageswaraRao 1 and V.C. Veera Reddy 2 Abstract-This paper presents a comprehensive comparative study of two and three output ports DC-DC converter with Zero Voltage Switching (ZVS) of main switches. A multiport converterr promises cost-effective, flexiblee and more efficient energy processing by utilizing only a single power stage. Zero Voltage Switching (ZVS) alleviates the switching losses and improves the converter overall efficiency. Zero voltage switching can be achieved with the help of coupled inductor which also regulates the input current during the load disturbances. The proposed multi output port converter with soft switching is simple and efficient. The analysis is carried out for closed loop control of DC-DCC converter with two and three output ports to substantiate that the proposed circuit can support extended multiple outputs. The simulation results for the same are presented in this paper. Furthermore, for the two-port and three-port converters a PI-loop based control strategy is proposed to maintain constant output voltage irrespective of supply disturbances. II. MULTI O OUTPUT PORT DC-DC CONVERTER A Multi Outputt port DC-DCC converter without ZVS arrangement is shown in Fig.1where several output voltages are provided by nserting capacitors in series. Voltages of the capacitors are controlled by the inductor current and correct switching states to share the energy stored in the inductor with each capacitor. For the present work two and threee output ports are considered. Key Words- Multiport DC-DCC converter, Two Output DC-DCC Converter, Three Output DC-DC Converter, Single stage converter, Zero Voltage Switching, Soft Switching, Closed Loop Control of DC-DC Converter. M I. INTRODUCTION ULTIPORT DC-DC converters are particularly interesting for sustainable energy generation systemss where diverse sources and storage elements are to be integrated [4-7]. This paper presents a ZVS of Two-port and Three-port bidirectional DC-DC converter using a coupled inductor. A simple and effective duty ratio control method is proposed to extend the ZVS operating range when input voltages vary widely. Soft-switching conditions over the full operating range are achievable by adjusting the duty ratio of the voltage applied to the coupled winding in response to the dc voltage variations at the port[2,9]. Keeping the volt-second product (half-cycle voltage-timee integral) equal for all the windings leads to ZVS conditions over the entire operating range. 1 Research Scholar, Sathyabama University, Chennai, India 2 Professor and Head of Department of EEE, S. V.U. College of Engineering, Tirupati, India. ID: 1 tnageswararao90@gmail.com, 2 veerareddy_vc@yahoo.com Fig.1 Multiport DC-DC for N output voltage and Converter The steady-state equations currents are given by (1) (2) Where K=1 N; ; V i -Input Voltage and D k is duty ratio of K th port switch 95

2 III.SIMULATION RESULTS FOR TWO PORT CONVERTER T DC-DC Proposed ZVS based two out puts DC-DC converterr simulation circuit is shown in Fig.2. The input DC voltage is 100 V and is shown in Fig.3. The gate pulse for the main switch M t1 and voltage across M t1 are shown in Fig.4. The gate pulse for the auxiliary switch M t2 and voltage acrosss M t2 are shown in Fig.5.The two output voltages are shown in Fig.6. Sum of both the outpu voltages is shown in Fig.7 Fig.4 Gate Pulse and V ds AcrossMain SwitchM t1 (ZVS) Fig.2 ZVS based two output DC-DC Converterr Simulation Diagram Fig.5 Gate Pulse and V ds Across auxiliary SwitchM t2 Fig.. 6 Output voltage V 1 and V 2 Fig.3 DC input voltage 96

3 Fig.7 Sum of two output voltages (V 1 +V 2 ) From Fig.4 it is observed that the switching of main switch M t1 is done at zero voltage. Hence this ensures soft switching. As observed from Fig.6 the two output voltages are V 1 =110V and V 2 =120V. From this it is concluded thatt due to ZVS of main switch, the switching losses are reduced. To achieve this, a single coupled inductor is used. Therefore the proposed ZVS based two output ports DC- DC converter has high efficiency and boosting capability compared to the conventional topologies. Since only one inductor is used, the circuit complexities are reduced. The closed loop system with supply disturbance is shown in Fig.8. The input voltage with this disturbance and corresponding sum of the two output voltages are shown in Fig.9. Fig.9 Input and sum of all two output voltages (V 1 +V 2 ) with supply voltage disturbance-closed observed that in closed loop control, loop control From Fig.9, it is whenn input voltagee is increased at 0.2 Sec., the sum of two output voltages rises slightly but at 0.28 Sec settles at the original value(230v). Therefore a constantt volatge is maintained at the output side irrepective of supply disturbances. I IV.SIMULATION RESULTS FOR THREE PORT CONVERTER T DC-DC Proposed ZVS based three out put DC-DC converter simulation circuit is shown in Fig.10. The gate pulse for the mainn switch M t1 and voltage across M t1 are shown in Fig.11. Thee gate pulse for the auxiliary switch M t2 and voltage across M t2 are shown in Fig.12.The gate pulse for the auxiliary switch M t3 and voltage across M t3 are shown in Fig.13. The three output voltages are shown in Fig.14 Fig.8 Closed loop system with Supply Disturbance Fig.10 ZVS based three output DC-DC Converter Simulation Diagram 97

4 Fig.11 Gate Pulse and V ds Across Main SwitchM t1 (ZVS) Fig.14 Three Output port voltages V 1, V 2 and V 3 From Fig.4 it iss observed that the switching of main switch M t1 is achieved at zero voltage. Hence this ensures soft switching. Ass observed from Fig.7 the three output voltages are approximately equal to 99V. From this it is concluded that duee to ZVS of main switch, the switching losses are reduced. Thee closed loop system with supply disturbance is shown in Fig.15. The input voltage with this disturbance and corresponding sum of all the three output voltages are shown in Fig.16. Fig.12 Gate Pulse and V ds Across auxiliary SwitchM t2 Fig.13 Gate Pulse and V ds Across auxiliary SwitchM t3 Fig.15 Closed loop system with source side disturbance 98

5 PWM, in Proc. IEEE Appl. Power Electron. Conf. Expo(APEC 06), Dallas, TX, Mar. 2006, pp [7] H. Al-Atrash, F. Tian, and I. Batarseh, Tri-modal half-bridge converter topology for three-port interface, IEEEE Trans. Power Electron., vol.22, no. 1, pp , Jan [8] M. Marchesoni and C. Vacca, New dc dc converter for energy storage system interfacing in fuel cell hybrid electric vehicles, IEEE Trans. Power Electron, vol. 22, no. 1, pp , Jan [9].J. L. Duarte, M. Hendrix, and M. G. Simoes, Three-port bidirectional converter for hybrid fuel cell systems, IEEE Trans. Power Electron, vol. 22, no. 2, pp , Mar [10] Arash A Boora, Firuz, Arindam Ghosh A General Approach to Control a Positive Buck-Boost Converter to Achieve Robustness against Input Voltage Fluctuations and Load Changes, IEEE conference proceedings, PESC Fig.16Input and sum of all three output voltages(v 1 +V 2 +V 3 ) with supply voltage disturbance-closed loop control From Fig.16, it is observed that in closed loop control, when input voltage is increased at 0.3 Sec., the sum of alll three output voltages rises slightly but settles at original value after 0.4 sec. Therefore a constant volatge is maintained at the output side. V.CONCLUSION A novel ZVS (Single coupled Inductor) based DC-DCC converter with two and three ouput ports is proposed. From the simulation results it is concluded that soft switching of main switch is achieved due to which the losses are minimized. From the simulation results it is also concludedd that the closed loop system with PI controller maintains constant output volatge irrespective of disturabance in the supply voltage in two and three output ports converter. From the simulation results for two port converter it is concluded that the proposed converter acts as boost converter since the output volatges are greater than the input supply voltage.therefore the proposed ZVS based multi-port DC-DC converter has high efficiency compared to the conventional topologies and also it supports extendedd multiple outputs. REFERENCES [1]. A. Nami F. Zare A. Ghosh F. Blaabjerg, Multi-output DC DCC converters based on diode-clamped converters configuration:topology and control strategy, IET Power Electronics, 2010, Vol. 3, Iss. 2, pp [2] N. D. Benavides and P. L. Chapman, Power budgeting of a multiple inputbuck-boost converter, IEEE Trans. Power Electron, vol. 20, no.6, pp , Nov [3] H. Tao, A. Kotsopoulos, J. L. Duarte, and M. A. M. Hendrix, Multi- input bidirectional dc dc converter combining DC-link and magnetic-coupling for fuel cell systems, in Proc. IEEE Ind. Appl.Soc. Conf. Annu. Meeting (IAS 05), Hong Kong, China, Oct. 2005,pp [4] D. Liu and H. Li, A ZVS bi-directional dc dc converter for multiple energy storage elements, IEEE Trans. Power Electron, vol. 21, no. 5,pp , Sep [5] H. Tao, A.Kotsopoulos, J. L. Duarte, and M. A. M. Hendrix, Family of multiport bidirectional dc dc converters, Proc. Inst. Elect. Eng., vol.153, no. 3, pp , May [6] H. Tao, A. Kotsopoulos, J. L. Duarte, and M. A. M. Hendrix, Triple- half-bridge bidirectional converter controlled by phase shift and AUTHORS PROFILE T.NageswaraRao is a Research Scholar at Sathybama University, Chennai, India. He obtained B.Tech. from, JNTU, Hyderabad, Andhra Pradesh, India in 1977,M.S. from BITS, Pilani, India in 1991 and M.E in Applied Electronics from Sathyabama University, Chennai, India in His areas of interest includeelectrical Machines, Control Systems and Power Electronics. He has 31years of teaching experience in Engineering Colleges. He has authored text books onn Basic Electrical Engineering, Circuit Theory and Control Systems. He is presently working as a Professor and Head in the department of ECE at SRR Engineering College, Chennai, India. Dr.. V.C. Veera Reddy obtained his M.E & Ph.D. degrees from SriVenkateswara University, Tirupati, Andhra Pradesh, India in 1981 & He is presently working as Professor and Head, Department of EEE, S.V.U College of Engineering. He pursued research in the areaa of Power Systems. He has 31 years of teaching experience. Under his guidance 8 scholars received the Ph.D and 6 more are on the verge of completion.he is a life member of CSE, IETE, and former member of IEEE. He has published 47 papers in the area of Power Systems in various journals. 99