Series AMEPR60-AZ up to 5A AC-DC / DC-DC LED Driver / Converter

Transcription

1 Click on Series name for product info on aimtec.com Series AMEPR60-AZ Models Single output FEATURES: AC-DC Constant Current or Constant Over Temperature Protection Voltage LED Driver Over Current Protection Input range VAC/47-440Hz Waterproof Case rated IP68 High Efficiency up to 89% Power Factor Correction Operating temperature -40 to 85 C Dimmable via resistive / 0-10Vdc / PWM 5 Years Limited Warranty Short Circuit Protection Output Max Output Voltage Input Input Model Current OCP / Output Efficiency Range Voltage Voltage Mode of Operation (V) 3 3 OVP Power (%) (VAC/Hz) (VDC) (W) / Constant Current AMEPR AZ Constant Voltage / Constant Current AMEPR AZ Constant Voltage / Constant Current AMEPR AZ Constant Voltage / Constant Current AMEPR AZ Constant Voltage Exceeding the maximum output power will permanently damage the converter 2 The dimming feature is not supported when units are used in Constant Voltage mode only. 3 In constant current mode output current is maximum shown, in constant voltage mode output voltage is the maximum shown. All models can be ordered with optional North American colour input wires (black (L), white (N), green (GND)). Add NA to part number when ordering. Note: Aimtec limited warranty of 5 years is valid based on product operation at datasheet specifications at ambient temperature of 25 C, humidity<75%, nominal input voltage (115/230/277VAC) and at rated output load unless otherwise specified. See AMEPR60-AZ s AC/DC LED drivers have electrical safeguards designed within to protect it from conventional electrical abnormalities with the levels listed in the safety table. Applications for use within rural agricultural, heavy industrial, and other areas or regions which are prone to dirty electrical conditions which would subject any of the above models to excessive voltages surges or spikes, may damage or cause early life failure of product. In this case consideration should be made by the end user to ensure that adequate line or mains surge suppression is installed in front of Aimtec device to ensure the longevity of the products. Failure to identify excessive line surges violations prior to installation may damage sensitive equipment permanently. Input Specifications Parameters Conditions Typical Maximum Units Inrush current <2ms 115VAC VAC 50 A Leakage current 115VAC VAC 0.7 ma AC current 115VAC VAC 0.33 A Power Factor 115VAC VAC 0.93 External fuse 250V/1.5A Start up time 250 ms Surge voltage 2sec 440 V F 052.1e R3.AE 1 of 13 North America only

2 Output Specifications Parameters Conditions Typical Maximum Units Current accuracy (CC Mode) ±3 % Voltage accuracy (CV Mode) ±3 % Line regulation LL-HL ±1 % Load regulation 0-100% load ±3 % Ripple & Noise 4 20MHz Bandwidth 75 mv p-p Hold-up time 90 ms Current adjustment range % Minimum Load Voltage See the models table 4 Tested with 0.1µF (C/C) or (M/C) and 47µF (E/C) parallel capacitors at the end. 5 Note: from 0% to 10% dimming adjustment signal instability may be present. Isolation Specifications Parameters Conditions Typical Rated Units Tested I/O voltage 3 sec/3.5ma 3000 VAC Isolation Resistance 500VDC >1000 MΩ Isolation Capacitance 1000 pf General Specifications Parameters Conditions Typical Maximum Units Switching frequency 130 KHz AMEPR AZ 1.27 Over current protection AMEPR AZ 1.77 AMEPR AZ 2.55 A AMEPR AZ 5.2 Over voltage protection Refer to Constant Current vs. Constant Voltage Mode curve Short circuit protection Continuous Short circuit restart Auto recovery Over temperature protection >105 C Operating temperature With derating over 55 C -40 to +85 o C Maximum case temperature 100 o C Storage temperature -40 to +95 o C Temperature coefficient ±0.02 % / o C Cooling Free air convection Humidity 95 % RH Case material Plastic Potting Epoxy (IP67 rated) Wires UL AWG *20CM Weight 530 g Dimensions (L X W X H) 5.30 x 2.27 x 1.59 inches x x mm MTBF >400,000 hrs (MIL-HDBK-217F at +25 C) Safety Specifications Parameters Agency approvals Standards culus, CE UL8750, UL , EN55022, class B, EN60529(IP68), EN , EN Information Technology Equipment EN55022 Class B Harmonic Current Emissions IEC/EN , Class C Voltage fluctuations and flicker IEC/EN , (EN ) Electrostatic Discharge Immunity IEC Level 3 RF, Electromagnetic Field Immunity IEC Level 2 Electrical Fast Transient / Burst Immunity IEC Level 2 Surge Immunity IEC Level 3 RF, Conducted Disturbance Immunity IEC Level 2 Power frequency Magnetic Field Immunity IEC Level 1 Voltage dips, Short Interruptions Immunity IEC F 052.1e R3.AE 2 of 13 North America only

3 Dimensions Top View (5.30) End View (1.59) (0.66) (2.27) (1.26) (2.27) Side View (1.59) (8.00) (8.00) Input/Output Wires are 18 AWG 20cm (6.24) 2.30 (0.09) Wire connection: Wire Brown Blue Green Red Black Blue (Dimming) White (Dimming) Connection AC L AC N Ground +V output -V Output + Vs dimming -Vs dimming AMEPR60-AZ Analog (resistive) Dimming Application Circuit Model Number Maximum Pot Value (kω) AMEPR AZ AMEPR AZ AMEPR AZ AMEPR AZ F 052.1e R3.AE 3 of 13 North America only

4 AMEPR60-AZ Analog (0-10V) Dimming Application Circuit Series AMEPR60-AZ AMEPR60-AZ PWM (1KHz) Dimming Application Circuit Temperature Graph F 052.1e R3.AE 4 of 13 North America only

5 Efficiency Vs. Input Voltage & Output Current (Constant Current Mode) AMEPR AZ (%) Efficiency VS. Input Voltage & Output Current 230Vac, 1.2, 115Vac, 0.24, 277Vac, , 115Vac Vac, , 277Vac, 0.24, Vac 277Vac Vac, 0.24, AMEPR AZ (%) Efficiency VS. Input Voltage & Output Current 277Vac, Vac 1.7, 110Vac, 0.34, 110Vac, , Vac 230Vac, Vac 0.34, F 052.1e R3.AE 5 of 13 North America only

6 AMEPR AZ (%) Efficiency VS. Input Voltage & Output Current 230Vac, 2.5, 277Vac, Vac 2.5, 115Vac, 0.5, 115Vac, Vac 2.5, 230Vac, 0.5, Vac Vac, 0.5, 74.2 AMEPR AZ (%) Efficiency VS. Input Voltage & Output Current 110Vac, 1, 230Vac, , Vac, 1, Vac, 110Vac 277Vac, 5, Vac, Vac 5, Vac F 052.1e R3.AE 6 of 13 North America only

7 PFC Value vs. Output Load Current (Constant Current Mode) AMEPR AZ Series AMEPR60-AZ (PF) PF VS. Output Current 115VAC, 0.6, 115VAC, 115VAC 1.2, 230VAC, , 230VAC, 230VAC 1 1.2, 277VAC, , 277VAC, , 290VAC, , 290VAC, VAC 1.2, VAC 305VAC AMEPR AZ (PF) PF VS. Output Current 115VAC, 0.85, 115VAC, 1.7, 230VAC, , 230VAC, 1 1.7, 277VAC, , 277VAC, , 290VAC, , 290VAC, , VAC 230VAC 277VAC 290VAC 305VAC F 052.1e R3.AE 7 of 13 North America only

8 AMEPR AZ (PF) PF VS. Output Current 115VAC, 1.25, 115VAC, 115VAC 2.5, 230VAC, , 230VAC, 1 2.5, 277VAC, , 277VAC, 230VAC , 290VAC, , 290VAC, VAC 2.5, VAC 305VAC AMEPR AZ (PF) PF VS. Output Current 115VAC, 2.5, 115VAC, 5, 230VAC, 230VAC, , , 277VAC, 277VAC, , , 290VAC, 290VAC, , , VA C 230VA C 277VA C F 052.1e R3.AE 8 of 13 North America only

9 PFC Value vs. Output Power AMEPR AZ Vac 115Vac 230Vac 264Vac 277Vac 290Vac 305Vac % 20% 30% 40% 50% 60% 70% 80% 90% 100% AMEPR AZ Vac 115Vac 230Vac 264Vac 277Vac 290Vac 305Vac % 20% 30% 40% 50% 60% 70% 80% 90% 100% F 052.1e R3.AE 9 of 13 North America only

10 Constant Current vs. Constant Voltage Mode AMEPR AZ Constant Currnet Vs Constant Voltage Vac, 36, 1.2 Vac, 50, Vac, 50.4, 0Vac, 52, 0 (V) AMEPR AZ Constant Currnet Vs Constant Voltage Vac, 24, 1.7 Vac, 36, Vac, 36.7, 0Vac, 38, 0 (V) F 052.1e R3.AE 10 of 13 North America only

11 AMEPR AZ Constant Currnet Vs Constant Voltage Vac, 12, 2.5 Vac, 24, Vac, 24.7, 0Vac, 26, 0 (V) AMEPR AZ Constant Current Vs Constant Voltage Vac, 5, 5 Vac, 12, Vac, 12.6, 0 Vac, 14, 0 (V) F 052.1e R3.AE 11 of 13 North America only

12 Dimming Control (Output Current vs. Radj) AMEPR AZ Output Current VS.Dimming Resistance Vac, 4.037, Vac, 2.333, & Vac, & 1.414, Vac, & , Vac, & , Vac, & , Vac, 0.48 & 0.32, 230 Vac, & 0.191, 230 Vac, 0.093, & Vac, 0, 0 Vac, 10.69, 1.2 (KΩ) AMEPR AZ Output Current VS. Dimming Resistance Vac, 6.35, Vac, 3.16, Vac, & 1.93, Vac, 1.19 & 1.25, Vac, 1.02 & 0.83, 230 Vac, & 0.554, 230 Vac, & 0.354, 230 Vac, & 0.202, 230 Vac, 0.079, & Vac, 0, 0 Vac, 36.53, 1.7 (KΩ) F 052.1e R3.AE 12 of 13 North America only

13 AMEPR AZ Output Current VS. Dimming Resistance 0 Vac, 10.3, Vac, 5.07, Vac, & 3.11, Vac, & , Vac, & , Vac, 115 Vac, 1.25 & 0.666, 0.93, 2301 Vac, & 0.411, Vac, & , 230 Vac, , 0 Vac, 52, (KΩ) AMEPR AZ Output Current vs. Dimming Resistance Vac, 20.2, 4.5 Vac, 10.8, Vac, & 6.4, Vac, & 4.6, Vac, & 3.1, Vac, , & Vac, & 1.6, Vac, 115 & 1, Vac, & 0.43, Vac, 0, 0 Vac, 50, 5 (KΩ) NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25 C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec s standard Terms of Sale available at F 052.1e R3.AE 13 of 13 North America only