A New Carrier Frequency Offset Estimation Algorithm for ASTC MIMO OFDM Based System

Transcription

1 A New Carrier Frequency Offset Estimation Algorithm for ASTC MIMO OFDM Based System Geethapriya, Sundara Balaji, Sriram & Dinesh Kumar KLNCIT Abstract - This paper presents a new Carrier Frequency Offset (CFO) estimation for Algebraic Space Time Code (ASTC) Multiple Input Multiple Output (MIMO) Orthogonal Frequency Division Multiplexing (OFDM) System. In this technique ASTC with golden encoder is used, by this we achieve full rate and full diversity. This system also provides notable improvement in performance by using all subcarriers in the frequency domain. This is achieved by Orthogonal Frequency Division Multiplexing. The orthogonal training sequence are simultaneously transmitted and received from multiple antennas. The receiver estimates CFO by using special algorithm for the range from -1 to 1 of values. Keywords - Algebraic Space Time code (ASTC), Orthogonal Frequency Division Multiplexing (OFDM), Multiple Input Multiple Output (MIMO), Carrier Frequency Offset (CFO). I. INTRODUCTION Nowadays, 4G broadband wireless technology usages are growing day by day and providing high data rate services like video conferencing and multimedia in wideband channels has been increased. High data rate schemes can be provided through Algebraic Space Time Coding (ASTC). But, they require a flat-fading channel to correctly function. So it is necessary to harness their power for wideband systems. The space time codes have good performance, but they suffer from the non-uniform distribution of the energy in the code word. To alleviate this problem, a new family of ASTCs has been proposed in [1] and [2], which have a structure of full-rate and full-diversity 2 2, 3 3, 4 4, and 6 6 space time codes. These codes have a constant minimum determinant as spectral efficiency increases. The name perfect space time codes, which is used for these codes, is suggested by the fact that they satisfy a large number of design criteria and only appear in a few special cases of the classical perfect error-correcting codes, achieving the Hamming sphere packing bound. In this paper, we will use 2 2 and 4 4 perfect codes. Orthogonal frequency-division multiplexing (OFDM) has been adopted in the wireless local area network standards IEEE a [3] and g [4] due to its high spectral efficiency and ability to deal with frequency-selective fading. The combination of OFDM with spectrally efficient multiple-antenna techniques makes the OFDM a good candidate to overcome the frequency selective problems for the perfect 2 2 and 4 4 ASTC codes. Despite the attractive features of both OFDM and ASTC, they are very sensitive to transmitter receiver synchronization imperfections [5]. Thus, the synchronization is crucial for ASTC-multiple-input multiple-output (MIMO)-OFDM-based systems. Frequency synchronization errors destroy the orthogonality among the subcarriers, which results in inter carrier interference (ICI) [6]. Therefore, an accurate carrier frequency offset (CFO) estimation is essential for OFDM receiver design. Various carrier synchronization schemes have been proposed for singleinput single-output OFDM systems. Some schemes rely on pilot or preamble data [8] [14], and some use the inherent structure of the OFDM symbol in either frequency [15] or time domain [16]. For multipleantenna OFDM, data-aided schemes are proposed for receiver diversity and MIMO in [17] and [18], respectively. A blind method for receiver diversity combined with OFDM is proposed in [19]. II. SYSTEM MODEL Our system model consists of Algebraic Space Time Code encoder and decoder; Orthogonal Frequency Division Multiplexing modulator and demodulator; Multiple Input Multiple Output transmitting and 76

2 receiving antennas. These models are explained in following sections. A. MIMO OFDM MODEL The Input data generated as random and mapped as QPSK. Here 128 data bits are generated. A multicarrier system can be efficiently implemented in discrete time using an inverse DFT (IDFT) to act as a modulator and an DFT to act as a demodulator. The transmitted data are the frequency domain coefficients and the samples at the output of the IFFT stage are time domain samples of the transmitted wave form. Fig. 1 shows a typical MIMO-OFDM implementation. variation, we introduce the best perfect algebraic code known as Golden codes with other tow well famous algebraic space time codes, TAST and DAST. 1) Golden Encoder: The code is a STBC obtained using a division algebra, which is full rate, full diversity, and has a nonzero lower bound on its coding gain, which does not depend on the constellation size. The code word in the form of 2 2 is written as: (1) 2) TAST Encoder: The TAST code is a space time algebraic code obtained using the integer algebra, with rate R = Nt = 2 Symbole/uc(usedcodeword), and diversity D = Nt Nr = 4. Each space time layer is associated with his proper algebraic space ' in order to alleviate the problem of ISI (Inter-Symbol-Interferences). The code word in the form 2 2 is expressed as: Fig. 1 : ASTC-MIMO-OFDM system model B. ASTC ENCODERS Each information in the sequence of data at time n i is encoded by the ASTC encoder into two stream constellations represented by the code word X Nc N t where N t refers to number of transmitted antennas and N c is the number of used subcarriers. By their construction the channel was under the Quasi-Static assumption, and does not take into account neither the time variation nor the selectivity channel case. To spread their power regarding the bit rate and the BER performance into the selective channel case with time θ = exp(iλ);λ R;φ = θ 2 3) DAST Encoder: (2) The DAST code is a diagonal space time algebraic code obtained using the turned constellations of integer algebra, with rate 1 Symbole/uc, and full diversity. The code word in the form of 2 2is described as follows: M = 1 2 X Dast = H nt. diag Mv 3 1 θ 1 θ ; θ = exp iπ 4 ; H nt = Hadamardmatrixofn t degree. 77

3 M is the notation matrix of n t = 2 degree. The encoded signal is OFDM modulated by using the following equation, u k = n t q N k=1 x n q. exp j2πnk N x n is the Encoder output. n t is number of transmitters. N is number of carriers. k is number of sub carriers. (4) III. CARRIER FREQUENCY OFFSET ESTIMATION ALGORITHM In the equation (6)r x is the received signal with offset and the symbol carries values less than 1. The Carrier Frequency Offset can be estimated from the equation (7) and it is the estimated Carrier Frequency Offset. This estimation can be done with any of the Algebraic Space Time Code encoders like Tast, Dast and Golden encoders. IV. SIMULATION RESULTS AND DISCUSSION We consider an OFDM orthogonal pilot symbol with a total of N = 128 subcarriers and no virtual subcarriers. Here we use two antennas at both transmitter and receiver side. So, number of transmitter n t is 2 and number of receiver n r is 2. The data generated are in the form of a row vector and size if the vector is The simulation results are as follows. In Carrier Frequency Offset estimation algorithm the first step is receiving the transmitted signal. The received signal has interference and noise with it. The received signal r x with noise can be represented as given below. r x = N 1 k=1 u k is the OFDM output. w is the AWGN noise. u k + w (5) In this equation w is additive noise with the received signal. From this the Carrier Frequency Offset should be estimated. The following equations explain how the CFO is estimated from the received signal. This equation represent received signal with offset. r x is the received signal. r x = r x e jπ (6) is the offset. The CFO can be estimated from the following equation, = N 1 r x r x 0 cis the Estimated output ASTC. r x is the received signal. (7) Fig. 2 : Golden Encoder of ASTC. Fig. 3 : DAST Encoder of ASTC. 78

4 Fig. 4 : TAST Encoder of ASTC. Fig. 7: DAST encoder of ASTC with Offset. Fig. 8 : Normalized CFO vs. Estimated CFO Fig. 5 : Golden encoder of ASTC with Offset. The result shows the variation between the data with interference and without interference before transmission. The final figure shows the comparison between the estimated CFO and the Normalized CFO. V. CONCLUSION This paper presented a new algebraic CFO estimation technique for MIMO-OFDM systems over frequency-selective fading channels employing ASTCs. The CFO was estimated by simple algorithm. The results of estimation are perfect and by using ASTC encoders we gain full rate and full diversity. VI. REFERENCES Fig. 6 : TAST encoder of ASTC with Offset. [1] J. C. Belfiore, G. Rekaya, and E. Viterbo, The golden code: A 2 2full-rate space-time code with nonvanishing determinants, IEEE Trans. Inf. Theory, vol. 51, no. 4, pp , Apr

5 [2] S. Yang, J. C. Belfiore, G. Rekaya, and B. Othman, Perfect space time block codes for parallel MIMO channels, IEEE Trans. Inf. Theory, vol. 13, pp , Jul [3] Information Technology- Telecommunications and Information Exchange Between Systems- Local and Metropolitan Area Networks- Specific Requirements Part 11: Wireless LAN Medium Access Control (MAC) and Physical Layer (PHY) Specifications Amendment 1: High-Speed Physical Layer In the 5 GHz Band, ISO/IEC :1999/Amd 1:2000(E); IEEEStd a, [4] Further Higher-Speed Physical Layer Extension in the 2.4 GHz Band,IEEE Std g, [5] A. Bannour, M. L. Ammari, Y. Sun, and R. Bouallegue, On the capacity of ASTC-MIMO- OFDM system in a correlated Rayleigh frequency selective channel, in Proc. IEEE 73rd VTC Spring, 2011, pp [6] A. H. Al-Dweik and M. R. Renfors, Blind estimation of large carrier frequency offset in wireless OFDM systems, IEEE Trans. Veh. Technol., vol. 56, no. 2, pp , Mar BANNOUR et al.: CFO ESTIMATOR FOR ASTC-MIMO-OFDM SYSTEMS 2475 [7] A. Salberg and A. B. Swami, Doppler and frequency-offset synchronizationin wideband OFDM, IEEE Trans. Wireless Commun., vol. 4, no. 6,pp , Nov [8] P. H.Moose, A technique for orthogonal frequency division multiplexing frequency offset correction, IEEE Trans. Commun., vol. 42, no. 10,pp , Oct [9] M. Morelli and U. Mengali, An improved frequency offset estimator for OFDM applications, IEEE Commun. Lett., vol. 3, no. 3, pp ,Mar [10] H.-K. Song, Y.-H.You, J.-H.Paik, and Y.-S. Cho, Frequency-offsetsynchronization and channel estimation for OFDM-based transmission, IEEE Commun. Lett., vol. 4, no. 3, pp , Mar [11] Y. Sun, Z. Xiong, and X. Wang, EM-based iterative receiver design withcarrier-frequency offset estimation for MIMO-OFDM systems, IEEE Trans. Commun., vol. 53, no. 4, pp , Apr [12] T. Roman, M. Enescu, and V. Koivunen, Joint time-domain tracking ofchannel and frequency offsets formimo-ofdm systems, Wireless Pers. Commun., vol. 31, no. 3/4, pp , Dec [13] H. Minn, N. Al-Dhahir, and Y. Li, Optimal training signals for MIMOOFDMchannel estimation in the presence of frequency offset and phasenoise systems, IEEE Trans. Commun., vol. 54, no. 10, pp ,Oct [14] M. Ghogho and A. Swami, Training design for multipath channel andfrequency-offset estimation in MIMO systems, IEEE Trans. Commun., vol. 54, no. 10, pp , Oct [15] U. Tureli, L. Hui, and M. Zoltowski, A high efficiency carrier estimatorfor OFDM communications, in Proc. 31st Asilomar Conf. Signals, Syst.Comput., 1997, pp [16] J. J. van de Beek,M. Sandell, and P. O. Borjesson, ML estimation of timeand frequency offset in OFDM systems, IEEE Trans. Signal Process.,vol. 45, no. 7, pp , Jul [17] A. Czylwik, Synchronization for systems with antenna diversity, inproc. IEEE VTS 50th VTC- Fall, 1999, vol. 2, pp [18] A. N. Mody and G. L. Stüber, Synchronization for MIMO OFDM systems, in Proc. IEEE Global Telecommun. Conf., 2001, pp [19] U. Tureli, D. Kivanc, and H. Liu, Multicarrier synchronization withdiversity, in Proc. IEEE VTS 54th Veh. Technol. Conf. VTC-Fall, 2001,pp [20] Y. Xiao, X. Lei, and S. Li, Improved CP-based carrier frequency offsetestimator for OFDM systems, in Proc. Int. Conf. Wireless Commun.,Netw. Mobile Comput., 2007, pp