o-ring grease can be used to hold the o-ring in the groove during installation.

Transcription

1 42G1215A-XT-1 ANTENNA GUIDE OM Rev 1 December 2013 The 42G1215A-XT-1 is an active antenna designed to operate at the GPS L1 and L2 frequencies, and MHz. The antenna is aircraft certified for navigation. This guide provides the information needed to install and use the antenna. ADDITIONAL EQUIPMENT REQUIRED A device with an antenna input port that both receives the RF signal and provides 2.5 to 24.0 VDC to the antenna is required to set up the 42G1215A-XT-1. (NovAtel GPS receivers provide the necessary power through their antenna RF connectors.) Coaxial cable with a male TNC connector INSTALLING THE ANTENNA Both the input DC power and the output RF signal flow over a single coaxial cable connected to the unit's TNC female connector. The antenna is attached to a surface by means of an ARINC-743 Bolt Pattern. Four screws pass through the housing of the antenna. Install the antenna as follows: 1. Place the o-ring into groove on the antenna base (o-ring supplied). User-supplied o-ring grease can be used to hold the o-ring in the groove during installation. 2. Pre-drill the mounting holes and the connector hole on the surface. Refer to the Mechanical Drawings section of this guide for details on the ARINC-743 mounting pattern. 1

2 3. Attach the antenna to the surface using the four mounting screws supplied. The o-ring will compress and create a seal between the surface and the antenna. Ref. # Description 1 Antenna 2 Countersink screws 3 Mounting surface 4 O-ring 5 Pre-drilled mounting holes 4. Remove the dust cap from the antenna s TNC connector. 5. Attach the male TNC connector of the coaxial cable to the antenna s TNC connector. Ref.# Description 1 Antenna screwed into place 2 Surface 3 TNC connector (male) 4 Coaxial cable (female) 6. Attach the other end of the coaxial cable to the antenna input port of the receiving device. The receiving device must be able to provide power as detailed in the SPECIFICATIONS section of this guide. All NovAtel GPS receivers provide the necessary power through their antenna RF connectors. 2

3 The graphic above shows examples of where the 42G1215A-XT-1 antenna may be located on an aircraft or vehicle (not to scale). ANTENNA CARE The 42G1215A-XT-1 is designed to withstand the elements, including rain, snow and dust. However, to ensure your antenna performs optimally, keep the radome clean and brush off any ice and snow. In addition, ensure the TNC connector remains clean and dry and replace the dust cap when a cable is not connected. 3

4 L1 ELEVATION GAIN PATTERN Max = 4.71 db L2 ELEVATION GAIN PATTERN Max = 3.36 db db 0 4

5 SPECIFICATIONS RF 3 db pass band (typical) L1: ±12 MHz L2: ±12 MHz Out-of-band rejection (typical) > 40 dbc (±50 MHz) Gain at zenith ( = 90 ) L1:+4.7 dbicl2:+3.3 dbic Gain roll-off (zenith to L1:+6.5 dbl2:+7.1 db LNA gain (typical) L1: 31dB / L2: 33 db ±2 db Polarization Right-hand circular Noise figure (typical) 3.0 db Nominal impedance 50 VSWR 1.5 : 1 Input voltage Current (typical) POWER VDC 35 ma PHYSICAL W: mm / Dimensions L: mm / H: mm / Weight 198 g (7.0 oz.) ENVIRONMENTAL Maximum altitude 21,336 m (70,000 ft.) Operating temperature -55 C to +85 C (-67 F to Storage temperature -55 C to +85 C (-67 F to Designed to meet these standards DO-160D DO228 MIL-C-5541 MIL-E-5400 MIL-I-45208A MIL-STD-810 SAE J1455 5

6 MECHANICAL DRAWINGS Dimensions are in inches followed by [mm] HEIGHT ARP 6

7 PHASE CENTRE Please refer to the Mechanical Drawings before reading this section. HEIGHT = Vertical phase centre offset from antenna reference point or antenna reference plane (ARP), see the MECHANICAL DRAWINGS section of this guide. For relative offset numbers and phase centre variation (PCV) tables, please visit the U.S. National Geodetic Survey (NGS) website at Look for ANTCOM ACC42G1215A_XT1. Please check our website for updates to this manual at and the websites mentioned above. If you need any further advice on this matter, please visit our website at Other methods of contacting Customer Service can be found on the last panel of this guide. 7

8 WARRANTY POLICY NovAtel Inc. warrants that its Global Positioning System (GPS) products are free from defects in materials and workmanship, subject to the conditions set forth below, for the following periods of time: GPSAntenna Modules: One (1) Year from date of sale Cables and Accessories: Ninety (90) Days from date of sale Date of sale shall mean the date of the invoice to the original customer for the product. NovAtel's responsibility respecting this warranty is limited solely to product repair at an authorized NovAtel location only. Determination of repair will be made by NovAtel personnel or by technical personnel expressly authorized by NovAtel for this purpose. The foregoing warranties do not extend to (i) nonconformities, defects or errors in the products due to accident, abuse, misuse or negligent use of the products or use in other than a normal and customary manner, environmental conditions not conforming to NovAtel s specifications, or failure to follow prescribed installation, operating and maintenance procedures, (ii) defects, errors or nonconformities in the products due to modifications, alterations, additions or changes not made in accordance with NovAtel s specifications or authorized by NovAtel, (iii) normal wear and tear, (iv) damage cause by force of nature or act of any third person, (v) shipping damage; or (vi)service or repair of product by the dealer without prior written consent from NovAtel. In addition, the foregoing warranties shall not apply to products designated by NovAtel as beta site test samples, experimental, developmental, preproduction, sample, incomplete or out of specification products or to returned products if the original identification marks have been removed or altered. The warranties and remedies are exclusive and all other warranties, express or implied, written or oral, including the implied warranties of merchantability or fitness for any particular purpose are excluded. NovAtel shall not be liable for any loss, damage or expense arising directly or indirectly out of the purchase, installation, operation, use or licensing or products or services. In no event shall NovAtel be liable for special, indirect, incidental or consequential damages of any kind or nature due to any cause. There are no user-serviceable parts in the GPSAntenna and no maintenance is required. If the unit is faulty, replace with another unit and return the faulty unit to NovAtel Inc. You must obtain a RETURN MATERIAL AUTHORIZATION (RMA) number by calling NovAtel Customer Service at NOVATEL (U.S. and Canada only) or before shipping any product to NovAtel or a dealer. Once you have obtained an RMA number, you will be advised of proper shipping procedures to return any defective product. When returning any product to NovAtel, please return the defective product in the original packaging to avoid damage. ** Before shipping any material to NovAtel or our Dealer, obtain a Return Material Authorization (RMA) number from the point of purchase. You may also visit our web site ( and select Support Repair Request from the side menu. Questions or Comments If you have any questions or comments, please contact NovAtel Customer Support using one of methods provided below. support@novatel.com Web: Phone: NOVATEL (International) or (U.S. & Canada) Fax: Copyright 2013 NovAtel Inc. All rights reserved. Unpublished rights reserved under international copyright laws. 8