USER MANUAL LIMITED WARRANTY AMPLIFIERS WDX300.4 : WDX400.4 : WDX800.4 WDX1K : WDX2K : WDX3K : WDX5K. Installation Instructions Owners Manual

Size: px

Start display at page:

Download "USER MANUAL LIMITED WARRANTY AMPLIFIERS WDX300.4 : WDX400.4 : WDX800.4 WDX1K : WDX2K : WDX3K : WDX5K. Installation Instructions Owners Manual"

Bennett Brown
5 years ago
Views:

1 LIMITED WARRANTY DB Drive warrants any products purchased in the U.S.A. from an authorized DB Drive dealer. All products are warranted to be free from defects in material and workmanship under normal use and service for a period of one (1) year when the unit is installed by an authorized DB Drive dealer. Non-authorized dealer installed products carry a one (1) year parts and labor limit - ed warranty. This warranty applies to the original purchase only. DB Drive will either repair or replace (as its option) any unit that had been found to be defective and under warranty provided the defect occurs within: One (1) year, if purchased through an authorized DB Drive dealer with original proof of purchase. AMPLIFIERS WDX300.4 : WDX400.4 : WDX800.4 WDX1K : WDX2K : WDX3K : WDX5K TM This limited warranty periods do not extend to units having been subjected to misuse, abuse, neglect, or accident. Products that in Db Drive s judgment shows evidence of having been altered, modified, or serviced without Db Drive s authorization, will be ineligible under this warranty. To obtain warranty services please contact your retailer or visit our website at for more details. 2K 2000 WATT support@dbdrive.net USER MANUAL Installation Instructions Owners Manual Due to continuous improvement of the product, specifications are subject to change without notice.

3 Low Impedance Stability The DB Drive WDX amplifiers includes built-in variable crossovers. The crossover features a variable frequency selection for precise low pass filtering for all mono amplifiers. The WDX300.4, WDX400.4 and WDX800.4 also offers independent 12dB per octave High Pass and Low Pass X-Over Network. WDX Ohm Stereo (4 Channel) WDX Ohm Stereo (4 Channel) WDX Ohm Stereo (4 Channel) WDX1K - 1 Ohm Mono WDX2K - 1 Ohm Mono WDX3K - 1 Ohm Mono WDX5K - 1 Ohm Mono Bass Boost For added low frequency performance the amplifiers are equipped with a selectable -12dB bass 45Hz

4 INPUT GND REM +12V CH 1 CH CHANNEL STEREO AMPLIFIER CH 3 CH 4 Turn on Remote In-Line Power fuse Mounted within 12 inches from Battery Recommended. 2K 2000 WATT

5 ( WDX1K - WDX2K - WDX3K - WDX5K ) WDX1K, WDX2K, WDX3K and WDX5K RIGHT BASS BOOST GAIN LPF SUBSONIC 0dB 12dB MIN MAX 50Hz 220Hz Off 50Hz SPEAKER OUTPUT INPUT 5K GND REM +12V LEFT 5K ( 1 Ohm Minimum ) CH 3 CH 1 CH 1/2 GAIN HPF LPF X-OVER BASS BOOST SPEAKER OUTPUT INPUT GND REM +12V HPF LP/BP 0dB 12dB MIN MAX 50Hz 5KHz 50Hz 500Hz FULL GAIN HPF LPF X-OVER BASS BOOST CH 4 CH 2 MIN MAX 50Hz 5KHz 50Hz 500Hz HPF LP/BP 0dB 12dB FULL CH 3/ STEREO AMPLIFIER 5K ( 1 Ohm Minimum )

6 ( WDX300.4, WDX400.4, WDX800.4 ) ( WDX1K - WDX2K - WDX3K - WDX5K ) The WDX1K, WDX2K, WDX3K and WDX5K are equipped with a variable 24db slope Lowpass crossover network and a 24db slope subsonic filter. The mono amps also feature a Selectable Bass Boost EQ is set at 45Hz. In some subwoofer enclosure installations it may necessary to use the Phase Shift feature. The Phase Shift button sets the Subwoofer signal between 0 degree setting and 180 degree settings. This will also allow you to fine tune the subwoofer enclosure depending on vehicle location. RIGHT BASS BOOST GAIN LPF SUBSONIC INPUT GND REM +12V CH 1 CH 2 0dB 12dB MIN MAX 50Hz 220Hz Off 50Hz 5K LEFT CHANNEL STEREO AMPLIFIER CH 3 CH 4 ( WDX1K - WDX2K - WDX3K - WDX5K ) INPUT GND REM +12V CH 1 CH 2 RIGHT BASS BOOST GAIN LPF SUBSONIC 0dB 12dB MIN MAX 50Hz 220Hz Off 50Hz 5K CHANNEL STEREO AMPLIFIER CH 3 CH 4 LEFT

7 Built-in Crossover ( 4 Channel: WDX300.4, WDX400.4, WDX800.4 ) The WDX300.4, WDX400.4 and WDX800.4 amplifier allow you to select the crossover mode (High-Pass, Full Range or Low Pass / Band Pass) and desired crossover point for channels 1-2 and 3-4. For example if you wish to use a 2-way loud speaker on channels 1-2, simply set the block out any unwanted low frequencies. If you wish to run a subwoofer on channels 3-4, simply set the crossover switch to LP/BP. RATED Ω: RATED Ω: RATED Ω Bridgeable: Frequency Response: Damping Factor 4Ω): Low Level Input: Independent Selectable X-over for F / R: Variable High Pass Filter (12 db slope): Variable Low Pass Filter (12 db Slope): Selectable Bass 45Hz: Working Voltage: WDX x 60W 4 x 120W 2 x 180W 20Hz ~ 22KHz 200< 105db 6V mV HPF / LPF /BP 50Hz ~ 5KHz 50Hz ~ 500Hz 0--12dB WDX x 80W 4 x 160W 2 x 240W 20Hz ~ 22KHz 200< 105db 6V mV HPF / LPF /BP 50Hz ~ 5KHz 50Hz ~ 500Hz 0--12dB WDX x 110W 4 x 220W 2 x 330W 20Hz ~ 22KHz 200< 105db 6V mV HPF / LPF /BP 50Hz ~ 5KHz 50Hz ~ 500Hz 0--12dB If you wish to run a component midrange on either channels 1-2 or 3-4 set the crossover switch to LP/BP. Then use both HPF and LPF frequency controls to create the desired band pass frequency range. THESE SETTING CAN BE USE ON CHANNELS 1-2 OR 3-4 INDEPENDENTLY OR FOR ALL CHANNELS RATED Ω: RATED Ω: RATED Ω: Frequency Response: Damping Factor 4Ω): Low Level Input: Variable Low Pass Filter (12 db Slope): Variable Subsonic Filter (12 db Slope): Selectable Bass Included Remote Level Control: Working Voltage: WDX1K 1 x 1000W 1 x 500W 1 x 250W 20Hz ~ 250Hz 100< 95db 7.5V mV 50Hz ~ 220Hz 10Hz ~ 50Hz 45Hz Yes WDX2K 1 x 2000W 1 x 1000W 1 x 500W 20Hz ~ 250Hz 100< 95db 7.5V mV 50Hz ~ 220Hz 10Hz ~ 50Hz 45Hz Yes CH 3 CH 1 CH 1/2 GAIN HPF LPF X-OVER BASS BOOST Adjust HP to desired frequency CH 4 CH 2 HPF LP/BP 0dB 12dB MIN MAX 50Hz 5KHz 50Hz 500Hz FULL GAIN HPF LPF X-OVER BASS BOOST MIN MAX 50Hz 5KHz 50Hz 500Hz HPF LP/BP 0dB 12dB FULL CH 3/ STEREO AMPLIFIER HP must be set to 50Hz Adjust LP to desired frequency RATED Ω: RATED Ω: RATED Ω: Frequency Response: Damping Factor 4Ω): Low Level Input: Variable Low Pass Filter (12 db Slope): Variable Subsonic Filter (12 db Slope): Selectable Bass Included Remote Level Control: Working Voltage: WDX3K 1 x 3000W 1 x 1500W 1 x 750W 20Hz ~ 250Hz 100< 95db 7.5V mV 50Hz ~ 220Hz 10Hz ~ 50Hz 45Hz Yes WDX5K 1 x 5000W 1 x 2500W 1 x 1250W 20Hz ~ 250Hz 100< 95db 7.5V mV 50Hz ~ 220Hz 10Hz ~ 50Hz 45Hz Yes Example HP Example LP Dimensions Length Height Width Adjust HP to desired frequency Adjust LP to desired frequency WDX300.4 WDX400.4 WDX800.4 WDX1K WDX2K WDX3K WDX5K 8.66" / 220mm 13.3" / mm 15.75" / mm 9"/ 228.6mm 12" / 304.8mm 15.24" / mm 19.69" / mm 2.25" / 57.15mm 6.54" / mm 2.25" / 57.15mm 2.25" / 57.15mm 6.54" / mm 6.54" / mm 2.25" / 57.15mm 6.54" / mm 2.25" / 57.15mm 2.25" / 57.15mm 6.54" / mm 6.54" / mm 2.25" / 57.15mm 6.54" / mm Example BP 12

8 NOTES PROBLEM LOOK FOR SOLUTION No Output Blown fuse Replace Bad RCA Cable(s) Replace +12V at power terminal Check connection +12V at remote terminal Check connection Grounding point are clean and tight Check for ground w/meter Head unit s fader not in center position Set to center position Master and slave settings Confirm correct setting Low Output Check level adjustments Bad RCA cable(s) Improper level matching Master and slave settings Replace Re-adjust Confirm correct settings Engine Noise Grounding points are clean and tight Check for ground w/meter Ground all components at same point Ground at same point Try different grounding point Change for better ground Bad RCA cable(s) Replace Use high quality shielded RCA cables Rejects inducted noise Low vehicle charging system and/or battery Fix and/or replace Red protection L.E.D. illumintaed Speaker short Check speakers connection for short circuit Speaker grounding out Make sure speaker wires do not touch chassis ground Impedance too low Check speaker impedance Overheating Check mounting location for adequate air circulation. Speaker impedance too low

AMPLIFIERS. Bi2200Tx Bi4200Fx. Bi1400Mx Bi2400Mx Bi3000Mx

AMPLIFIERS. Bi2200Tx Bi4200Fx. Bi1400Mx Bi2400Mx Bi3000Mx LIMITED WARRANTY Bass Inferno warrants any products purchased in the U.S.A. from an authorized Bass Inferno dealer. All products are warranted to be free from defects in material and workmanship under