User's Manual. VHF Wireless Microphone System. Guangdong Takstar Electronic Co., Ltd.

Transcription

1 User's Manua VHF Wireess Microphone System Guangdong Takstar Eectronic Co, Ltd Business Centre of Domestic Saes: Te: / Fax: Production Base: Bocady Industria Viage, Longqiao Road, Longxi Bouo Huizhou Guangdong , China Wwwtakstarcom

2 Specification: Mute Contro: Noise Lock Frequency Deviation: 18kHz Frequency Response: 80Hz-15kHz Frequency Stabiity: 0005% S/N Ratio: > 70dB Tota Harmonic Distortion: 05 % (at 1kHz) Number of Channes: 2 Channes Receiving Sensitivity:-80dBm Operating Range: 50m in Open Area Resonance Interference Rate: 50dB Fase Image Interference Rate: 80dB Receiver Power Suppy: DC 12V/300mA Transmitter Power Suppy: 9V Battery Transmit Power: + 10dBm Carrier Frequency Band: VHF-H Output Type: Separate and Mixed Output (auto-seecting) Deivery Incudes: CD/VCD/LD/ TS WM VHF OK (50~100 ) (40~18000Hz) VHF-H,, 4V ALC,, -,,, OK -1- Receiver 1 pc Handhed Microphone 2 pcs Audio Output Cabe 1 pc Power Adaptor 1 pc User's Manua 1 pc Bet-Pack Transmitter 2 pcs (TS-6310A) Tie-cip Microphone 2 pcs (TS-6310A) Headworn Microphone 1 pc (TS-6310A) 9V batteries 2pcs -12-

3 Troubeshooting: 1 :, 9V : "OPEN", Phenomena The receiver is returned on, but the indicator does not ight Cause Check if the adaptor is we connected, and if the socket is broken 2 "ON",, 3,, 4 "MIC" 5,, The RF indicator ights whie speaking, but no output signa is avaiabe When the using distance gets shorter, the signa becomes unstabe Check if the power switch is in the midde position, or the voume contro is on the minimum position 1 Put out the antenna 2 Check if the batteries are running off and repace them with the fresh ones if needed 3 Check if the receiver is put in inappropriate position, ie on the ground or at the corner of the wa or in a strong eectromagnetic fied, pease change its position ALC Sound quaity gets worse 1 The battery of the microphone is running off, pease repace it with fresh one 2 Check if there is same frequency signa probem, do not use two units with same frequency at the same time in the same area (The distance must be at east 100m between two units with same frequency) Remarks: If there are any other troubes or probems observed, pease do not open and repair it by yourseves Pease, first contact our distributors or directy come back to us We wi try our best to provide you with professiona and efficient service

4 CAUTION: 1 The receiver shoud be more than 1m above the foor and more than 1m away from the was 2 For better effect, pease do not put the microphone in the dead ange pace whie using 3 Pease be carefu whie operating the system, any impacts, pumps or misuse can cause mafunction 4 Do not expose the system directy to sun and rain, and keep it away from magnetic fied 5 Any change or modification on the construction of this device, which are not expressy approved by the party responsibe for compiance, coud cause a mafunction and void the user's authority to operate the equipment 6 Do not disassembe the unit by yoursef, as there may be high votage inside 7 Specifications are subject to change without prior notice 1, 220V/50~60Hz 2, 3 A B, 90 4 :,,, 5, "RF",,

5 Receiver: 1, 2 3,, 4, 5,, 6, 7 1 Pug the connector of the power adaptor into the socket of power Source, pease make sure the power votage is AC 220V/50~60Hz 2 Turn on the power switch, the power indicator ights 3 Pu out the antenna A & B and make them perpendicuar to the unit Audio Output Connection (auto-seecting): If the mix output is needed, ony use 1 audio output cabe and connect it with any output socket If independent output is required, pease connect another cabe 5 The RF indicator of receiver wi ight when turning on the transmitter Pease swive the voume knob to adjust the sound 6 When not using the receiver for a ong time, pease disconnect it from the power adaptor Working Principe of Receiver: POWER VOL STABLEZING CIRC QUARTZ CRYSTAL OSC SAME CIRC ANT HF FIL HF AMP ULTRA HETERODYNE RECEPTION AUDIO AMP DE-EMPHASIS MUTE DYNAMIC EXP CIRC AUTO-SELECTING OUTPUT AUX OUT HIGH PIL DETECT CIRC FOR MUTE INDICATOR

6 Operationa Instructions: Microphone: 1 Handhed Microphone: Rotate the battery cover anti-cockwise, and put a 9V battery into the battery compartment with proper poarities, then rotate the battery cover cockwise ti it is tight enough Bet-pack Transmitter: Open the battery cover by pressing the OPEN sign, then put in the batteries (Caution: the battery must be in 2 Correct Poarities Push the microphone power switch to the ON position If the power indicator doesn't ight, pease check if the battery is fu enough or the battery poarities are correct 3 If the mute function is needed, pease push the switch to the midde position, then the microphone wi be in mute state and the unit is sti working 4 Pug the tie-cip or headset microphone into the MIC socket of the bet pack transmitter 5 When not using the microphone for a ong time, pease take out the batteries from the microphone base in order to avoid damaging the unit By chemica eakage from the battery Working Principe of Microphone: : : 18kHz :80Hz-15kHz : 0005% : >70dB : 05%(1kHz) : : -80dBm : 50 : 50dB : 80dB : DC 12V/300mA : 9V : 10dBm :VHF-H AL C AUDIO AMP DCNR PRE- EMPHASIS BATT FM MODE QUARTZ CRYSTAL OSC HIF PWR AMP VOL STABILIZING CIRC 9V

7 Introduction: For many reasons, ow frequency among others, traditiona wireess microphone systems can be easiy interfered, especiay by such equipment Features: Adopting VHF-H frequency band for obviating interference Frequency as CD, VCD and LD To sove this probem, Takstar designed the professiona TS, WM series wireess microphones, which adopt a series of Using mutieve high frequency and mid frequency narrowband Fiter for fuy eiminating signa disturbing measures to improve its functions, advance frequency using mutieve high Low-votage power suppy design keeps it working even at 4V frequency and mid frequency narrowband fiter, muripe noise detect and contro They feature aso the specia functions of avoiding interference from the outside TS-6310 wireess microphone system is suitabe for any pubic speeches and karaoke performances It features ong distance (50-100m), high fideity tone quaity and wide frequency response range ( Hz) with ow distortions, which wi assure you a peasant using everywhere at any moment Unique ALC circuitry for avoiding distortion from high voume Low votage indication avaiabe for handhed microphone Specia circuitry for eiminating noise shock wave from switch Quartz crysta osciator circuitry for extremey stabe frequency Adopting audio companding technique for reducing the noise and Increasing the dynamic range Function of effectivey reducing the howing Independent unbaanced and mixed outputs for convenienty connecting sound mixer and Karaoke ampifier Rugged and durabe handhed microphone design