DR-AN-10-MO 10 GHz Analog Driver

Transcription

1 light.augmented R-AN-1-MO The Photline R-AN-1-MO is a wideband RF amplifier module designed for analog applications at frequencies up to 12 GHz. The Photline R-AN-1-MO is characterized by a low Noise Figure and a linear transfer function whose 1 db compression point is above 21 dbm. It exhibits flat Group elay and Gain curves with reduced ripple over the entire bandwidth. FEATURES Output voltage up to 9 V pp Linear amplifier The Photline R-AN-1-MO operates from a single power supply for safety and ease of use, and offers gain control over 3 db. The amplifier comes in a compact 2 mm x 2.6 mm housing with K type RF connectors (compatible SMA) and with an optional heat sink. This amplifier module is ideally suited to drive optical modulators for analog applications. Flat gain up to 12 GHz Single voltage power supply Low group delay variation APPLICATIONS LiNbO 3 modulators OFM, RF over fiber Linear amplification Clock amplifier Research & evelopment OPTIONS Heat-sink Performance Highlights Parameter Min Typ Max Unit Cut-off frequencies k 11 G - Hz Output voltage - 9 V pp Gain db Saturated output power dbm Output power 1dB comp db Harmonics dbc Noise Figure 3-6 db Measurements for V bias 1 /

2 R-AN-1-MO C Electrical Characteristics Parameter Symbol Min Typ Max Unit Supply voltage (fixed) V bias V Current consumption I bias ma Gain control voltage V amp V Electrical Characteristics Parameter Symbol Condition Min Typ Max Unit Lower frequency f 3dB, lower -3 db point - - khz Upper frequency f 3dB, upper -3 db point GHz Gain S 21 Small signal, f < 1 GHz db Gain ripple - f < 1 GHz - - ±1. db Input return loss S 11 f < 1 GHz db Output return loss S 22 f < 1 GHz db Isolation S 12 f < 1 GHz db Output power 1dB P 1dB 2 GHz < f < 1 GHz dbm Saturated output power P sat 2 GHz < f < 1 GHz dbm Output voltage V out Linear - 7 Maximum swing - 9 V pp Noise Figure NF 2 GHz < f < 1 GHz 3-6 db Harmonics 1dB, f < GHz dbc Power dissipation P Small signal W Conditions: S parameters conditions : P in = -3 dbm, T amb = 2 C, W system Absolute Maximum Ratings Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operational sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect device reliability. Parameter Symbol Min Max Unit RF input voltage V in -.6 V pp Supply voltage V bias 13 V C current I bias 4 ma Gain control voltage V amp 1.3 V Power dissipation P diss -.2 W Temperature of operation T op + W Storage temperature T st C 2 /

3 R-AN-1-MO S 21 and Group elay s S 12 S 21 (db) ,2 1,1 S 21 1,,9,8,7,6, Group delay,4,3,2,1, Group elay (ns) S 12 (db) S 22 S S 22 (db) S 11 (db) Saturated Output Power Curve Noise Figure Curve P1dB (dbm) Noise figure (db) /

4 R-AN-1-MO Electrical Schematic iagram Mechanical iagram and Pinout All measurements in mm n2.3(x4) x The heatsinking of the module is necessary. It s user responsability to use an adequate heatsink. Refer to page for ixblue recommended heatsink. PIN Function Operational Notes IN RF In K-connector female OUT RF Out K-connector male 1 CREATION V bias Power supply voltage Set IN. at typical operating specification ESCRIPTION E LA REVISION ECHELLE : TOL. GEN. : MATIERE : TRAITEMEN V amp Output voltage amplitude adjustment Adjust for 1:1 gain control tuning- - Encombrement PL-964-MC- 16, rue Auguste Jouchoux 21 BESANCON- FRANCE Tél. : +33 () Fax : +33 () Ce document est la proprieté de PHOTLINE Technologies et ne peut être reproduit ou com 4 /

5 R-AN-1-MO Mechanical iagram and Pinout with HS-MO2 Heatsink All measurements in mm 26 f 4.3 f 7_21_PT_SP_E M2x.4-6H About us CREAT 1 IN. Photonics includes ixblue ixfiber brand that produces specialty optical fibersecand HELLEBragg : 1 :1 components and ixblue Photline brand that provides optical modulation solutions based on ESCRIPTION E based fiber T OL. GEN.: ixblue gratings optics the company lithium niobate (LiNbO3) modulators and RF electronic modules. ixblue Photonics serves a wide range of industries: sensing and instruments, defense, telecommunications, and 16, rue Augustespace Jouchoux 21 BESANCON- FRANCE fiber lasers as well as research laboratories all over the world. Tél. : +33 () Fax : +33 () Ce document est la proprieté de PHOTLIN Ixblue reserves the right to change, at any time and without notice, the specifications, design, function or form of its products described herein. All statements, specification, technical information related to the products herein are given in good faith and based upon information believed to be reliable and accurate at the moment of printing. However the accuracy and completeness thereof is not guaranteed. No liability is assumed for any inaccuracies and as a result of use of the products. The user must validate all parameters for each application before use and he assumes all risks in connection with the use of the products 3, rue Sophie Germain 2 Besançon - FRANCE Tel. : +33 () Fax : + 33 () /