PASS4TEST. IT Certification Guaranteed, The Easy Way! We offer free update service for one year

Transcription

1 PASS4TEST \ We offer free update service for one year

2 Exam : Title : Conducting Cisco Unified Wireless Site Survey (CUWSS) v2.0 Vendor : Cisco Version : DEMO Get Latest & Valid Exam's Question and Answers 1 from Pass4test. 1

3 NO.1 While performing an active mesh survey with a Cisco 1550 Access Point, the status LED turns solid red. What does this indicate? A. Access Point is operational B. CAPWAP discovery is in progress C. Firmware failure D. Radio is off E. Mesh authentication failure Answer: C NO.2 Refer to the exhibit. Get Latest & Valid Exam's Question and Answers 2 from Pass4test. 2

4 In testing the post-deployment WLAN network you have discovered an AP that has been placed in a difficult area. The AP cannot be easily moved because of various requirements. The client performance of various Apple and Microsoft operating system-based products does not meet expectations. Which two options can help mitigate the performance issue? (Choose two.) A. Add additional APs. B. Replace the AP with an AP and external antenna. Get Latest & Valid Exam's Question and Answers 3 from Pass4test. 3

5 C. Increase the AP power level to maximum. D. Change the AP location to one that is less RF hostile. E. Rotate the AP 90 degrees to change antenna polarity. Answer: A,B NO.3 Which option will allow the maximum 2.4 GHz channel usage for a survey and voice deployment in the ETSI domain? A. 1, 6, 11 B. 1, 5, 9, 13 C. 1, 6, 9, 14 D. 1, 6, 11, 14 Answer: A NO.4 A wireless engineer is gathering equipment to perform a point-to-point bridge survey. What three pieces of equipment should be used? (Choose three.) A. 3502i with dual band directional antennas B. 3502e with AIR-ANT2460NP-R C with a 10dBi Yagi D. 1552e with three AIR-ANT2547-N= E. 1552e with AIR-ANT2588P3M-N= F with internal antenna G Series with internal antennas Answer: B,E,F NO.5 After installation of a new data-only wireless network, an engineer found that RRM has set all of the APs to a power level of 1. Which option describes the reason for this? A. APs are too far apart for the set data rates. B. EDRRM is enabled. C. APs should be manually set initially. D. TPC needs to be enabled. E. DTPC value is set too high. F. High co-channel interference exists. Answer: A NO.6 You have a customer that is building a new campus of four 3-story buildings that you have just completed the site survey for. The customer is interested in the amount of rack space they will need to allocate in either the building MDF or in the data center for controllers. Each building is going to require 75 APs to support voice and data. How should the controllers be deployed to provide the least number of controllers, the highest redundancy, and the easiest management? A. Use the distributed deployment method in each building MDF with the N + N redundancy method. B. Use the centralized deployment method in the data center with the N + N + 1 redundancy method. C. Use the distributed deployment method in each building MDF with the N + 1 redundancy method. D. Use the centralized deployment method in the data center with the N + 1 redundancy method. Get Latest & Valid Exam's Question and Answers 4 from Pass4test. 4

6 E. Use the distributed deployment method in each building MDF with the N + N +1 redundancy method. F. Use the centralized deployment method in the data center with the N + N redundancy method. Answer: B NO.7 The customer requires connectivity between two buildings that are 100 meters apart. Which type of antenna is suitable for this installation? A. sector antenna B. dipole antenna C. parabolic antenna D. patch antenna Answer: C NO.8 For better compatibility with n clients, which a channels should be utilized? A. UNII-2 Band - extended channels B. UNII-1 Band C. UNII-3 Band D. ISM Band Answer: B NO.9 What is the result of a Cisco 1250 AP deployed for a/b/g/n using optimized power (16.8 W) with software version 7.0? A.One spatial stream per radio B.One spatial stream on 2.4 GHz and two spatial streams on 5 GHz C.One spatial steam on 5 GHz and two spatial streams on 2.4 GHz D.Reduced power on both radios E.Reduced power on 2.4 GHz radio only F.Reduced power on 5 GHz radio only Answer: E NO.10 A site survey proposes placement of new APs to replace older APs. Which three options are three potential placements of the new APs? (Choose three.) A. Use the old placements where they are near the proposed location. B. Add APs from the site survey that have no APs in older installation. C. Mount new APs on the exact location according to site survey report. D. Use network cables and mounting brackets from the older installation. E. Deploy APs every 4000 square feet. F. Deploy APs every 3000 square feet. Answer: A,B,C NO.11 An engineer would like to calibrate the RF environment to improve accuracy. What wireless attribute is added to the floor-level calculation by calibrating the floor? Get Latest & Valid Exam's Question and Answers 5 from Pass4test. 5

7 A. TX power B. multipath C. SNR D. attenuation Answer: D NO.12 Which option lists the non-overlapping channels in the ETSI domain? A. 1, 6, and 11 B. 1, 5, 9, and 13 C. 1, 5, 9, 13, and 14 D. 1, 5, and 9 E. 1, 6, 11, and 14 Answer: A NO.13 What measurement can Iperf be used to verify? A. throughput B. RSSI C. SNR D. interference detection E. utilization Answer: A NO.14 Aside from software applications, which two tools will be important to have when performing a WLAN site survey? (Choose two.) A. Measuring tools B. Temporary attachment devices (tie-wraps, clamps, duct tape) C. Architectural design drawings D. Different sizes and types of wrenches and pliers E. Portable battery packs to power WLAN clients F. Flag tape to outline wireless cell dimensions Answer: A,B NO.15 The customer had a b/g WLAN site survey and installation two years ago with the final service performing as expected. Since that time, the customer has experienced modest customer growth while maintaining employee headcount. New wireless applications are being evaluated along with a possible temporary headcount increase, but the current WLAN performance has noticeable performance degradation. What is the most likely cause of the WLAN performance problems? A. They have added a second microwave to the break room. B. A new coffee shop with a wireless hotspot has opened across the street. C. The customer has expanded their shipping capacity by 50%. D. Employees are now using their smart phones and tablets in the office. Answer: D Get Latest & Valid Exam's Question and Answers 6 from Pass4test. 6

8 NO.16 Which tool can best provide throughput verification? A. WLC > Monitor > Clients > LinkTest B. WaveDeploy C. InSSIDer D. Xirrus Wi-Fi Inspector Answer: B Get Latest & Valid Exam's Question and Answers 7 from Pass4test. 7