A Result Analysis of OFDM-Based Cognitive Radio Networks for Efficient- Energy Resource Allocation

Transcription

1 A Result Analysis of OFDM-Based Cognitive Radio Networks for Efficient- Energy Resource Allocation Santavana Singh 1, Sumit Dubey 2, 1 Mtech Scholar, JNCT Riwa, santavana2416@gmail.com, India; 2, Asst. Professor, JNCT Riwa, sumitdubey02@gmail.com, India; Abstract In this paper, we tend to investigate the energy-efficient resource allocation in orthogonal frequency division multiplexing (OFDM)-based cognitive radio (CR) networks, where we tend to try and maximize the system energy-efficiency under the thought of many practical limitations, such as transmission power budget of the Cr system, interference threshold of most important users and transmit demands of secondary users. Our general objective formulation leads to a challenging mixed integer programming problem that's hard to solve. To form it computationally tractable, we employ a time-sharing methodology to change it as a non-linear partial program problem, which may be further converted into an equivalent convex optimization problem by using its hypogragh kind. Supported these transformations, it is possible to obtain (near) best possible explanation by usual optimization method. However, the complexness of the standard technique is just excessively high for this real-time optimization project. By utilize the structure of the problem extensively; we develop an efficient barrier methodology to work out the (near) best solution with an affordable complexness, significantly higher than the standard technique. Numerical results show that our proposal can maximize the energy efficiency of the Cr system, whilst the proposed algorithmic rule performs quickly and stably. Keywords: orthogonal frequency-division multiplexing (OFDM), inter-carrier interference (ICI) I. Introduction Multiple receive antennas may be used with orthogonal frequency-division multiplexing (OFDM) to boost system performance, where space variety is achieve by means of subcarrier support space combining. However, in subcarrier-based space combining, it's needed that multiple discrete Fourier transform (DFT) process, each per receive antenna, be used. As a result, such systems are quite difficult, because the complexness of DFT could be a major concern for system implementation. Recently, some schemes are proposed to reduce the quantity of DFT blocks required. Within the principle of orthogonal designs, the number of DFT blocks is reduced to a half with three decibel performance degradation. Within the received timedomain OFDM symbols from every antenna are 1st weighted then combined before the DFT processing. By doing thus, the quantity of DFT blocks required is reduced to 1. In OFDM with multiple transmit and multiple receive antennas (MIMO) is investigated, and a reduced- complexity algorithmic rule is proposed to reduce the quantity of DFT blocks needed to 1. In OFDM (orthogonal frequency-division multiplexing), the subcarrier frequencies are preferred so the sub-carriers are Orthogonal to one another that means that cross-talk stuck between the sub-channels is eradicated along with inter-carrier guard bands aren't needed. These significantly simplify the design of both the transmitter and the receiver; dissimilar to standard FDM, a separate filter for each sub-channel isn't needed. The orthogonality have need of that the sub-carrier gap is Hertz, wherever TUseconds is the useful image duration (the receiver side window size), and k may be a positive integer, generally capable one. Therefore, with N sub-carriers, the entire pass band bandwidth are going to be B N Δf (Hz). The orthogonality also allows high spectral efficiency, with a total symbol rate close to the Nyquist rate for the equivalent baseband signal (i.e. close to half the Nyquist rate used for the double-side band substantial pass band sign). Almost the full obtainable waveband may be utilized. OFDM in general have an almost 'white' band, giving it compassionate electromagnetic interference properties with respect to different co-channel users. A simple example: A useful symbol length TU = one ms would need a sub-carrier spacing of (or a number multiple of that) meant for orthogonality. N = 1,000 subcarriers would lead to a complete pass band bandwidth of NΔf = 1 MHz. For this symbol time, the specified [1010]

2 bandwidth in theory in step with Nyquist is N/2TU = 0.5 MHz (i.e., 1/2 the achieved bandwidth required by our scheme). If a guard interval is applied (see below), Nyquist bandwidth demand would be even lower. The FFT would lead to N = 1,000 samples per image. If no guard interval was applied, this is able to result in a base band complicated valued signal with a sample rate of one MHz, which might need a baseband bandwidth of 0.5 MHz in keeping with Nyquist. However, the pass band RF signal is created by multiplying the baseband signal with a carrier wave form (i.e., double -sideband quadrature amplitude-modulation) leading to a pass band bandwidth of one MHz A single-side band (SSB) or vestigial sideband (VSB) modulation scheme would accomplish almost half that bandwidth for a similar symbol rate (i.e., twice as high spectral potency for an equivalent image alphabet length). It s but additional sensitive to multipath interference. OFDM needs very correct frequency synchronization between the receiver and therefore the transmitter; with frequency deviation the sub-carriers can now not be orthogonal, inflicting inter-carrier interference (ICI) (i.e., cross -talk between the sub-carriers). Frequency offsets are usually caused by mismatched transmitter and receiver oscillators, or by propagation as a result of movement. Whereas propagation alone could also be compensated for by the receiver, the case is worsened when combined with multipath, as reflections can appear at various frequency offsets, which is much tougher to correct. This effect usually worsens as speed will increase, and is a very important factor limiting the employment of OFDM in high-speed vehicles. Many techniques for ICI suppression are steered; however they will increase the receiver complexity. II. Method A cognitive radio is an intelligent radio that can be programmed and configured dynamically. Its transceiver is designed to use the best wireless channels in its vicinity. Such a radio automatically detects available channels in wireless spectrum, then accordingly changes its transmission or reception parameters to allow more concurrent wireless communications in a given spectrum band at one location. This process is a form of dynamic spectrum management. The methodology has been implemented in this research work is utilizing the basic concept of the CR using the OFDM. Orthogonal frequency-division multiplexing (OFDM), mostly identical to coded OFDM (COFDM) and discrete multitone modulation (DMT), could be a frequency-division multiplexing (FDM) scheme utilized as a digital multi - carrier modulation method. A huge number of closelyspaced orthogonal sub-carrier is used to carry data. The data is divided into several parallel data streams or else channels, one for every sub-carrier. Each sub-carrier is modulated with a conventional modulation scheme (such as quadrature amplitude modulation or phase-shift keying) at a low symbol rate, maintaining total data rates related to conventional single-carrier modulation schemes in the similar bandwidth. Fig 1 Cognitive Radio Network OFDM has developed into a well-liked scheme for wideband digital, whether or not wireless or over copper wires, used in applications similar to audio broadcasting and digital television, wireless networking and broadband web access. The primary advantage of OFDM over single-carrier schemes is its ability to take care of severe channel conditions (for example, attenuation of high frequencies in an exceedingly long copper wire, narrowband interference and frequency-selective attenuation due to multipath) while not advanced equalisation filters. Channel equalisation is simplified as a result of OFDM could also be viewed as using several slowly-modulated narrowband signals instead of one rapidly-modulated wideband signal. The low symbol rate makes the utilization of a guard interval between symbols affordable, creating it potential to handle time-spreading and eliminate entomb image interference (ISI). This mechanism additionally facilitates the look of single frequency networks (SFNs), wherever many adjacent transmitters send identical signal at the same time at identical frequency, because the signals from several distant transmitters could also be combined constructively, instead of meddlesome as would usually occur in an exceedingly ancient single-carrier system. In this thesis we tend to are method signal for communication and save the energy, 1st take information and convert bit to symbol or serial to parallel and them modulate information with the assistance of QAM modulation. once modulation apply USB rule and calculate the ser and ber and optimize information and take away ber and snr value with the assistance of low pass filter and so plot effect as show on figure. Figure 2: Block Diagram of Proposed Methodology [1011]

3 III. Result Cognitive radio may be a form of wireless communication during that a transceiver will showing intelligence detect which communication channels are in use and which aren't, and instantly get into vacant channels whereas avoiding occupied ones. CR will sense its surroundings and, while not the intervention of the user, will adapt to the user's communications desires whereas orthodox to Federal Communications Commission rules within the US. A atomic number 24 will showing intelligence detect whether or not any portion of the spectrum is in use, and might temporarily use it while not meddling with the transmissions of different users. In step with Bruce Fette, "Some of the radio's different cognitive abilities embrace determinant its location, sensing spectrum use by neighboring devices, dynamical frequency, adjusting output power or perhaps sterilization transmission parameters and characteristics. Figure 5: EE of CRsystem as a function of mrr Figure 6:Channel Realization Figure 3: EE of CR system as a function of the transmission Figure 7: Optimal RA based on time sharing Figure 4: EE of cr system as a function of interference system [1012]

4 Figure 8: Optimal RA based on time sharing Figure 10: CR Figure 9: Optimal RA based on time sharing IV. Conclusion We studied the energy-efficient resource allocation in an OFDM-based CR network, which is an urgent task for green communication design. Our model is general and covers many practical constraints, leading to an intractable mixed integer programming problem. We perform a series of equivalent transformations by analysing the formulated problem intensively, converting it into a convex optimization problem which can be solved by standard optimization technique. Furthermore, we develop an efficient algorithm to work out the (near) optimal solution by exploiting its special structure to update Newton step in an ingenious way, reducing the computation complexity dramatically and making its applications possible. Numerical results show that our resource allocation proposal can achieve near optimal energy efficiency, while the algorithm developed in this thesis converges quickly and stably. References [1] Shaowei Wang, MengyaoGe, and Wentao Zhao, Energy- Efficient Resource Allocation for OFDM-Based Cognitive Radio Networks IEEE transactions on communications, vol. 61, no. 8, Aug [2] FCC, Facilitating opportunities for flexible, efficient, and reliable spectrum use employing cognitive radio technologies, FCC Report, ET Docket , Dec [3] S. Haykin, Cognitive radio: brain-empowered wireless communications, IEEE J. Sel. Areas Commun., vol. 23, no. 2, pp , Feb [4] FCC, Spectrum policy task force report, FCC Report, ET Docket , Nov [1013]

5 [5] T. A. Weiss and F. K. Jondral, Spectrum pooling: an innovative strategy for the enhancement of spectrum efficiency, IEEE Commun. Mag., vol. 42, no. 3, pp. 8 14, Mar [6] S. Sadr, A. Anpalagan, and K. Raahemifar, Radio resource allocation algorithms for the downlink of multiuser OFDM communication systems, IEEE Commun. Surv. & Tutor., vol. 11, no. 3, pp , Sep [7] R. Zhang, Y.-C. Liang, and S. Cui, Dynamic resource allocation in cognitive radio networks, IEEE Signal Process. Mag., vol. 27, no. 3, pp , May [8] G. Bansal, M. J. Hossain, and V. K. Bhargava, Optimal and suboptimal power allocation schemes for OFDM-based cognitive radio systems, IEEE Trans. Wireless Commun., vol. 7, no. 11, pp , Nov [9] X. Kang, Y.-C. Liang, A. Nallanathan, H. Garg, and R. Zhang, Optimal power allocation for fading channels in cognitive radio networks: ergodic capacity and outage capacity, IEEE Trans. Wireless Commun., vol. 8,no. 2, pp , Feb [10] Y. Zhang and C. Leung, Resource allocation in an OFDM-based cognitive radio system, IEEE Trans. Commun., vol. 57, no. 7, pp , July [11] S. Wang, Efficient resource allocation algorithm for cognitive OFDM systems, IEEE Commun. Lett., vol. 14, no. 8, pp , Aug [12] S. Wang, F. Huang, and Z.-H. Zhou, Fast power allocation algorithm for cognitive radio networks, IEEE Commun. Lett., vol. 15, no. 8, pp , Aug [1014]