Exterior 200. / exterior 200 led

Size: px

Start display at page:

Download "Exterior 200. / exterior 200 led"

Darrell Norton
6 years ago
Views:

1 Exterior 200 LED / exterior 200 led

Exterior 200 LED The Exterior 200 LED is a long-life luminaire offering IP65 full RGB + Amber and White colour mixing, and weatherproofed for the dynamic illumination of

mixing, offering a broader range of colours Choice of narrow, medium or wide diffuser options High optical performance and bright output Consistent colour with

2 Exterior 200 LED The Exterior 200 LED is a long-life luminaire offering IP65 full RGB + Amber and White colour mixing, and weatherproofed for the dynamic illumination of facades, structures, water features and monuments FEATURES Exterior 200 LED / Features 44 high power LEDs in five colours: Red, Green, Blue, Amber and White RGBAW colour mixing, offering a broader range of colours Choice of narrow, medium or wide diffuser options High optical performance and bright output Consistent colour with factory-calibrated pixels 0-0% intensity control Weatherproof rating of IP65 DMX, stand-alone, synchronized (master/slave) control options Choice of DMX control modes: RGB, RGBAW, HSI, HSIC

Consistent and even colours lens medium lens wide lens Martin set out to solve what has been one of the major drawbacks of LED lighting: colour consistency.

Pixel boards for the Exterior 200 LED are individually measured and calibrated, guaranteeing standardized brightness and colour performance.

3 Consistent and even colours lens medium lens wide lens Martin set out to solve what has been one of the major drawbacks of LED lighting: colour consistency. A central feature is the ability to create even and consistent colours. Pixel boards for the Exterior 200 LED are individually measured and calibrated, guaranteeing standardized brightness and colour performance. 2 beam angle 27 beam angle 32 beam angle section: 500 cd True white and better saturated colours With five coloured diodes (Red, Green, Blue, Amber and White) instead of the usual three, Martin is able to offer a broader and finer range of colours. While the amber helps extend the colour range and give effective colour temperature control, the white diode provides a better white light quality and the ability to create softer, subtler pastels. ft. section: 00 cd m Ø50% section: 250 cd E [lux] E [fc] ft. E [lux] E [fc] ft. E [lux] E [fc] m Ø50% 27 m Ø50% % intensity control The ability to dim a luminaire is appreciated by designers who want balance of brightness or the ability to allow structures and landscapes to respond intelligently to the availability of natural light % Half-peak Ø: 0.37 distance (m, ft) Illuminance: 8000 / distance² (lux, fc) Total Output: 400 (lumens) Half-peak Ø: 0.48 distance (m, ft) Illuminance: 4000 / distance² (lux, fc) Total Output: 300 (lumens) 50% Extended lifetime and performance Stand-alone, programmable views The lifetime and brightness of LEDs are dependent on the way the heat is removed from them. In order to ensure the best possible lumen performance, an internal fan monitors and regulates cooling. This heat management system extends the lifespan of diodes. The Exterior 200 LED offers the possibility of programming up to 20 views via the Multi Utility Manager (MUM), stored on the actual fixture. The different views can be triggered by timer or light sensor or synchronized (master/slave) with other fixtures. Half-peak Ø: 0.57 distance (m, ft) Illuminance: 00 / distance² (lux, fc) Total Output: 00 (lumens) 0% Weatherproofed for outdoors Intuitive colour control Hue Choice of beam angles Saturation The Exterior 200 LED is orderable with a choice of narrow, medium or wide beam options for use at distances between approximately two to six metres (6 to 20 ft). The lenses are also available as accessories allowing the luminaire to be reconfigured on site if necessary. With a weatherproof IP65 rating the Exterior 200 LED is perfect for outdoor use, and operates flawlessly from -30 to +45 degrees Celsius. The fixture offers easy installation for applications that require a self-contained luminaire, for example pole mounting, and is also perfect for indoor applications. medium wide The Exterior 200 LED offers greater intuitive control of colour, with four distinct control modes. In addition to RGB (three channel) and RGBAW (five channel) colour fine-tuning, HSI (Hue, Saturation, Intensity) lets you set the effect you want by scrolling through hues, altering their saturation and changing their intensity. HSI-C adds colour temperature control to the intuitive benefits of HSI. Exterior 200 LED / Benefits Intensity

Exterior 200 LED Specification 3 mm (2.2 in.) 6 mm (6.5 in.) 405 mm (5.9 in.) 3 mm (2.2 in.) 6 mm (6.5 in.) Physical Approvals Length: 6 mm (6.5 in.) including cable gland Width: 3 mm (2.2 in.) Height: 405 mm (5.

4 Exterior 200 LED Specification 3 mm (2.2 in.) 6 mm (6.5 in.) 405 mm (5.9 in.) 3 mm (2.2 in.) 6 mm (6.5 in.) Physical Approvals Length: 6 mm (6.5 in.) including cable gland Width: 3 mm (2.2 in.) Height: 405 mm (5.9 in.) Weight: 7.6 kg (.8 lbs.) including bracket EU safety: EN , EN , IEC/EN EU EMC: EN 553-, EN 553-2, EN , EN US safety: UL 598 Canadian safety: CAN/CSA C.22.2 No. 250 Dynamic Effects Photometric data 405 mm (5.9 in.) Accessories Colour mixing: RGBAW Red: 0-0% Green: 0-0% Blue: 0-0% Amber: 0-0% White: 0-0% Light source: Luxeon K2 high power emitters Total output (balanced white 5600 K): 400 lm Half-peak angle: 2 with narrow diffuser Minimum LED source lifetime (to 50% of initial output level): hours at full intensity 400 beam angle kit (diffuser sheet) 400 Medium beam angle kit (diffuser sheet) 4002 Wide beam angle kit (diffuser sheet) 9239 Safety eyebolt 9305 Floor stand pin male XLR connector, cable-type, IP65 Control and Programming Colour control modes: RGBAW, RGB, HSI, HSIC Control options: DMX, stand-alone, synchronized (master/slave) DMX channels: 3, 4 or 5 DMX address setting: PC with Martin MUM software and DABS hardware interface Stand-alone trigger options: Internal timer and/or ambient light level Stand-alone and master/slave programming: PC with Martin MUM software and DABS hardware interface 26-bit control (internal): RGBAW, RGB, HSI, HSIC Protocol: USITT DMX52-A Receiver: RS-485 Firmware update: Serial upload via DMX link Construction pin female XLR connector, cable-type, IP65 Colour: Clear anodized, white, custom colours to special order Housing: Anodized aluminium Mounting bracket: 8 mm (0.3 in.) anodized aluminium Front glass: 6 mm (0.2 in.) anti-reflection coated Protection rating: IP65 Installation Orientation: Any Vertical aiming: 3 Minimum distance to illuminated surfaces: 0. m (0.3 ft.) AC power: V nominal, 50/60 Hz Typical power consumption (at 0 V, 50/60 Hz): 39 W Power supply unit: Integrated, auto-sensing multi-voltage Main fuse: 2.5 AT (slow blow) Thermal Cooling: Convection Maximum ambient temperature (Ta max.): 45 C (3 F) Minimum ambient temperature (Ta min.): - C (-22 F), power must be maintained below 0 C (32 F) Maximum surface temperature, steady state, Ta=40 C: 90 C (94 F) Total heat dissipation (calculated, +/- %): 860 BTU/hr. Exterior 200 LED / Specification Electrical

LED, White specification CODE specification CODE 90545000 905450 90545002 905452 Medium 905450 90545 Medium 9054502

5 Exterior 200 LED ordering example specification Exterior 200 LED, Surface Mounted, LED, IP65, RGBAW,,, Aluminium = Exterior 200 LED,, = variables Medium Wide No diffuser Aluminium White Exterior 200 LED, Aluminium Exterior 200 LED, White specification CODE specification CODE Medium Medium Wide Wide No diffuser No diffuser Exterior 200 LED / Ordering

Worldwide partners Martin Headquarters Martin Professional A/S Olof Palmes Allé 8 8200 Aarhus N Tel. +45 87 40 00 00 Fax +45 87 40 00 sales@martin.

6 Worldwide partners Martin Headquarters Martin Professional A/S Olof Palmes Allé Aarhus N Tel Fax sales@martin.dk Subsidiaries About Martin Martin is headquartered in Aarhus, and represented in almost 0 countries around the world. On our website, you will find probably the most impressive list of references in the industry. With 250 employees worldwide, solid financials, and a strong environmental and ethical focus at our global manufacturing facilities in, the United Kingdom, and China, Martin is one of the world s leading manufacturers of lighting solutions. Martin Professional, Inc. 700 Sawgrass Corporate Parkway Sunrise, FL USA Tel Fax hr Technical Support: 888 TECH 80 martinus@martinpro.com Martin Professional GmbH Hertzstrasse 4 D Karlsfeld Germany Tel Fax sales@martin-professional.de Martin Scandinavia A/S Olof Palmes Allé Aarhus N Tel Fax sales@martinscan.com Martin Professional PLC Martin House Boxmend Industrial Estate Bircholt Road, Parkwood Maidstone Kent ME5 9YG United Kingdom Tel Fax uksales@martin.dk Martin Professional Italy Spa Via V Alpini Bergamo BG Italy Tel Fax sales@martin.it Martin Professional France S.A. Z.I. Petite Montagne Sud 4/ Allée du Cantal, BP , Lisses France Tel Fax contact@martin.fr Martin Professional Pte. Ltd. 68 Kallang Pudding Road SYH Logistics Building Singapore Tel Fax sales@martin.com.sg Martin partners Martin works closely with local partners in approximately 0 countries. Visit for a complete and up-to-date list of addresses for each of the countries or regions listed below. Algeria Argentina Australia Austria Azerbaijan Bahrain Barbados Belarus Belgium Bolivia Brazil Bulgaria Canada Caribbean Chile China Colombia Costa Rica Croatia Cuba Cyprus Czech Republic Ecuador Egypt Estonia Ethiopia Finland France Georgia Germany Greece Guatemala Honduras Hong Kong Hungary Iceland Indonesia Iran Iraq Ireland Israel Italy Ivory Coast Japan Jordan Kuwait Latvia Lebanon Lithuania Luxembourg Macedonia Malaysia Mexico Middle East Mongolia Morocco Netherlands New Zealand Nicaragua Norway Oman Panama Paraguay Peru Philippines Poland Portugal Qatar Romania Russian Federation Saudi Arabia Serbia Singapore Slovak Republic Slovenia South Africa South Korea Spain Sudan Sweden Switzerland Syria Taiwan Thailand Tunisia Turkey UAE Ukraine United Kingdom Uruguay USA Uzbekistan Venezuela Vietnam Yemen The Happy Factory,

7 2008 Martin Professional A/S Images contained in this brochure have been converted to CMYK and are not necessarily representative of actual colours. Specifications are subject to change without notice Martin Professional Olof Palmes Allé Aarhus N T / F /

Regulatory status for using RFID in the UHF spectrum 3 May 2006

Regulatory status for using RFID in the UHF spectrum 3 May NOTE: The following countries were updated since the last publication of 3 March : Thailand, Romania. The table attached provides an overview