Cut-out: 13 15/16 x 7 9/16. Catalog Number ICL-MBSL430-2 A B C D E F G H. Input Voltage 120V 277V

Transcription

1 I-MBS- MBS Retractable Recessed Multiple () Heads JOB NAME ATAOG NUMBER 1 /8 19 /8 1 /8 /8 1 / 8 1/1 /1 Order Matrix Example: I-MBS0----I00 A B E F G H A I-MBS1 I-MBS I-MBS I-MBS B umens / atts (Per Head) 101lm / 1 1 1lm / lm / 1 190lm / 0 1 T / RI 00K / 8 RI 00K / 9 RI 000K / 8 RI 000K / 9 RI 00K / 8 RI 100K / 8 RI Heads - () E Heads blank -10 -E10V1 -E10V01 -EV -UT1 -UT -EAI1 -EAI01 imming Non-imming 0-10V imming 10% eldoe 0-10V 1% eldoe 0-10V 0.1% EV imming 1 utron -ire Hi-ume 1% utron EcoSystem 1% eldoe AI 1% eldoe AI 0.1% E blank -B SF Input Voltage 10V V F Finishes Black Interior / hite Trim hite Interior / hite Trim G Optics H -I100 -I00 -I00 -EM -EM 1 Spot Narrow Flood Flood ide Flood Square Flood Options Accessories uminaire will accommodate a maximum of () filter media and a snoot per head. Accessory holder is required per head. Accessory Holder HRS HRS iffusion Filters PF-1-S8 PF--S8 PF--S8 Accessory Holder, Black Accessory Holder, hite Prismatic Spread ens inear Spread ens Beam Softener ens Snoot SNTRS SNTRS olor Filters P--S8 P--S8 P-9-S8 -hannel Bar (pair) Flat Bar (pair) Architectural Bar (pair) Remote Emergency Unit Emergency Unit with Integral Test Switch, Notes: 1. EV imming available in 10V only. onsult factory for special order finishes.. Multiple optics per fixture available by special order. Access above ceiling required.. EM adds depth. Snoot, Black Snoot, hite Amber ens Red ens Blue ens ouver PFMB-1 Black Hex ouver ut-out: 1 1/1 x 9/1 atalog Number I-MBS10- I-MBS0- I-MBS0- I-MBS0- System attage * 9 1 elivered umens ** 101lm (Per Head) 1lm (Per Head) 188lm (Per Head) 190lm (Per Head) 1 /8 1 1/ FEATURES --Heavy duty die-cast construction --Retractable pull down with vertical locking --1 Horizontal rotation -- Vertical tilt at full pull down position / Vertical tilt at recessed position E IGHT ENGINE (PER HEA) --00K, 000K, 00K and 100K 8 RI --00K and 000K 9 RI (R9 Value = 9) -- Step MacAdam ( SM) --E mounted to die-cast / extruded aluminum heat sink --0,000 hours average rated life at 0% output EETRIA SYSTEM --onstant current E driver --Power factor >.9, 0/0Hzmab --Multiple dimming drivers available --This product complies with IEEE.1 for surge endurance up to.kv. Additional surge protection recommended. amage from power surge is not covered by warranty. HOUSING The inner trim is constructed of 0GA steel painted black, white or silver. Must be kept away from insulation. The internal wire bundles are locked and covered with a glass sleeve. The housing is supplied with a plate to allow the junction box to be accessible from below the ceiling. MOUNTING The luminaire can accommodate a ½ to 1 ¼ ceiling thickness. The fixture is supplied with channel brackets that allow up-to vertical adjustment. Universal mounting brackets included. ompatible with -channel, flat bar, architectural bar and EMT. Bar hangers must be ordered separately. -channel are recommended for T-bar ceilings. Architectural bar hangers are not for use in T-bar ceilings. FANGE TRIM Extruded trim frame includes torsion springs for convenient installation or removal from the housing. EMERGENY Emergency driver operates E load of up to.0 watts at a nominal 0 lumens for a minimum of 90 minutes. See submittal sheet IB-BS1- for specifications. ISTING/ARRANTY --ET listed to US and anadian standards for damp locations Year Intense E imited arranty Total elivered umens ** 000K 000K 000K 000K * System wattage include driver and E module consumption. ** elivered lumen output will vary depending on T, RI and optic selection. umens Per att 80 P 8 P P P MUTIPES /M-0:1 P- Intense ighting 0 E a Palma Ave, Anaheim, A 980 tel fax Intense ighting,. All rights reserved. Subject to change without notice.

2 ATAOG NUMBER I-MBS10-1 Report #: (-1) (-) (-) (-0) Spot (-1) 9 98 Narrow Flood (-) 1 1 Flood (-) ide Flood (-0) Photometric ata atts: 1.8 umens: 101. P: T: 1 RI: 8 egree andela atts: 1.8 umens: 8.1 P:.0 T: 19 RI: 8 egree andela atts: 1.8 umens: 98. P:.81 T: 1 RI: 8 egree andela atts: 1.8 umens: 9. P:. T: 19 RI: 8 egree andela APPIATION ATA: and are the outer points where the candle power drops to 0% of maximum. are the initial foot Beam width Beam length istance to center of beam istance Foot candles Illuminated width & length are based upon point at which illuminance falls to 0% of center illuminance. Recommended spacing is based 0 o HORIZONTA HORIZONTA VERTIA 0 o I-MBS Spot I-MBS10-1- Narrow Flood I-MBS10-1- Flood I-MBS ide Flood All testing was conducted in accordance with M-9-08, Approved Method: Electrical and Photometric Measurements of Solid-State ighting Products as published by the Illuminating Engineering Society of North America (IESNA) MUTIPES /M-0:1 P- Intense ighting 0 E a Palma Ave, Anaheim, A 980 tel fax Intense ighting,. All rights reserved. Subject to change without notice.

3 ATAOG NUMBER I-MBS0-1 Report #: (-1) (-) (-) (-0) Spot (-1) 8 1 Narrow Flood (-) 0 11 Flood (-) 10 ide Flood (-0) Photometric ata atts: 1. umens: 1. P: 8. T: 18 RI: 8 egree andela atts: 1. umens: P: 0.9 T: 191 RI: 8 egree andela atts: 1. umens: 1.8 P: 9. T: 18 egree andela atts: 1. umens: 1.9 P: T: 18 RI: 8 egree andela APPIATION ATA: and are the outer points where the candle power drops to 0% of maximum. are the initial foot Beam width Beam length istance to center of beam istance Foot candles Illuminated width & length are based upon point at which illuminance falls to 0% of center illuminance. Recommended spacing is based 0 o HORIZONTA HORIZONTA VERTIA 0 o I-MBS Spot I-MBS0-1- Narrow Flood I-MBS0-1- Flood I-MBS0-1-0 ide Flood All testing was conducted in accordance with M-9-08, Approved Method: Electrical and Photometric Measurements of Solid-State ighting Products as published by the Illuminating Engineering Society of North America (IESNA) MUTIPES /M-0:1 P- Intense ighting 0 E a Palma Ave, Anaheim, A 980 tel fax Intense ighting,. All rights reserved. Subject to change without notice.

4 ATAOG NUMBER I-MBS0-1 Report #: (-1) (-) (-) (-0) Spot (-1) Narrow Flood (-) Flood (-) ide Flood (-0) Photometric ata atts:. umens: P: T: 1 egree andela atts:. umens: 10. P:.9 T: 1 egree andela atts:. umens: 11.8 P: 1. T: 1 egree andela atts:. umens: 119. P: 9. T: 18 egree andela APPIATION ATA: and are the outer points where the candle power drops to 0% of maximum. are the initial foot Beam width Beam length istance to center of beam istance Foot candles Illuminated width & length are based upon point at which illuminance falls to 0% of center illuminance. Recommended spacing is based 0 o HORIZONTA HORIZONTA VERTIA 0 o I-MBS Spot I-MBS0-1- Narrow Flood I-MBS0-1- Flood I-MBS0-1-0 ide Flood All testing was conducted in accordance with M-9-08, Approved Method: Electrical and Photometric Measurements of Solid-State ighting Products as published by the Illuminating Engineering Society of North America (IESNA) MUTIPES /M-0:1 P- Intense ighting 0 E a Palma Ave, Anaheim, A 980 tel fax Intense ighting,. All rights reserved. Subject to change without notice.

5 ATAOG NUMBER I-MBS0-1 Report #: (-1) (-) (-) (-0) Spot (-1) Narrow Flood (-) Flood (-) ide Flood (-0) Photometric ata atts: 0. umens: P:.81 T: 18 egree andela atts: 0. umens: 18.0 P: 0. T: 188 egree andela atts: 0. umens: 19.0 P:.11 T: 1 egree andela atts: 0. umens: 188. P: 1.89 T: 18 egree andela APPIATION ATA: and are the outer points where the candle power drops to 0% of maximum. are the initial foot Beam width Beam length istance to center of beam istance Foot candles Illuminated width & length are based upon point at which illuminance falls to 0% of center illuminance. Recommended spacing is based 0 o HORIZONTA HORIZONTA VERTIA 0 o I-MBS Spot I-MBS0-1- Narrow Flood I-MBS0-1- Flood I-MBS0-1-0 ide Flood All testing was conducted in accordance with M-9-08, Approved Method: Electrical and Photometric Measurements of Solid-State ighting Products as published by the Illuminating Engineering Society of North America (IESNA) MUTIPES /M-0:1 P-8 Intense ighting 0 E a Palma Ave, Anaheim, A 980 tel fax Intense ighting,. All rights reserved. Subject to change without notice.

6 IMMING OMPATIBIITY JOB NAME ATAOG NUMBER 0-10V IMMING (10% imming, eldoe 1%, eldoe 0.1%) --10V/V --ims down to 10% light output --onsult dimming manufacturer for installation instructions and power packs OMPATIBE IMMERS Manufacturer Part Number(s) HUNT PS-010-IV-10V, PS-010-H-10V, PS-010--IV-10, PS-010--H-10V, PS-010-IV-V, PS-010-H-V, PS-010--IV-V, PS-010--H-V, F-010: PS-I-010-IV, PS-I-010-H-10/V, F-010: PS-I-010--IV, PS-I-010--H-10/V, F V, F-010-V eviton eviton entura Fluorescent ontrol System, IllumaTech IP Series, PSPE-1 ightolier ZP00FAM10, MP100FAM10, V000FAMU ithonia EQ B, EQ VB, S VB, SQ1 utron VTV, NTFTV Synergy IS B 10/ INPUT 0-10V IMMER BAK HITE GREEN VIOET (+) GREY (-) RIVER RE - POSITIVE BAK - NEGATIVE E IGHT ENGINE UTRON EOSYSTEM IMMING --10V or V --ims down to less than 1% or % light output --onsult dimming manufacturer for installation instructions OMPATIBE IMMERS Product Part Number(s) EcoSystem S-1-M, S--M, S-1-M, S--M, EcoSystem ESN, Grafik Eye QS with EcoSystem, Quantum EO SYSTEM ONTRO (BY OTHERS) EO SYS BUS BAK HITE GREEN VIOET (E1) VIOET (E) RIVER RE - POSITIVE BAK - NEGATIVE E IGHT ENGINE UTRON HI-UME IMMING --10V or V --ims down to less than 1% light output --onsult dimming manufacturer for installation instructions OMPATIBE IMMERS Product Part Number(s) NovaT NTF-10, NTF-10P, NTF-10P-, NTF-10- Nova NF-10, NF-10P, NF-10P-, NF-10- Vareo VF-10 Skylark SF-10P, SF-1P-, SF-1P--, SF-10P iva VF-10, VF-10P-, VSF-10P, VSF-10P- Ariadni AYF-10P, AYF-10P- Vierti VTF-AM Maestro MAF-AM, MAF-AM-, MSF-AM, MSF-AM- Maestro ireless MRF-FAN-V Spacer System SPSF-A, SPSF-A-, SPSF-AM, SPSF-AM- yneo XF-10P, XF-10P- Radio RA RR-FAN-V Homeorks QS HQR-FAN-V -IRE ONTRO (BY OTHERS) BAK HITE ORANGE GREEN RIVER RE - POSITIVE BAK - NEGATIVE E IGHT ENGINE MUTIPES /M-0:1 P-9 Intense ighting 0 E a Palma Ave, Anaheim, A 980 tel fax Intense ighting,. All rights reserved. Subject to change without notice.